HOCHIKI DCP-AMS Series Addressable Manual Pull Stations User Manual
- June 4, 2024
- HOCHIKI
Table of Contents
HOCHIKI DCP-AMS Series Addressable Manual Pull Stations
STANDARD FEATURES
- Addressable integrated design
- All metal construction
- Single and dual action models available
- Extremely easy to operate
- Bi-colored status LED indicates Standby and Alarm conditions
- Address is programmable in EEPROM
- Address can be programmed when installed
- Key lock or hex key lock models available
- Enclosed switch with glass rod (included)
- Terminals accept up to 14AWG wire
- Surface mount back box available
- ADA compliant (except LP models) Specifications subject to change without notice.
SPECIFICATIONS
Operating Voltage (SLC)| 17~41 VDC
Average Current Consumption 550uA (Typical) 660uA (Alarm)
Ambient Temperature| 32°F (0 °C) ~ 120°F (49°C)
Maximum Humidity| 90% RH, non-condensing
Dimensions| 3.4″W x 4.8″H x 2.0″D
Mounting| Single gang or 4″ square electrical box
MODEL DESCRIPTION
DCP-AMS| Single Action Hex Key Lock
DCP-AMS-LP| Dual Action Hex Key Lock
DCP-AMS-KL| Single Action Key Lock
DCP-AMS-KL-LP| Dual Action Key Lock
DESCRIPTION
The DCP-AMS are the Hochiki America series of addressable manual pull stations
that provide a fast and practical means of manually initiating a fire alarm
signal. Both single action and dual action manual pull stations are available.
Resetting of the pull station requires either a Cat 30 key or a 1/8″ hex key
(depending upon the model used).
An alarm condition is actuated by pulling down on the handle of the DCP-AMS
and DCP-AMS-KL single action models. On the dual action models DCP-AMS-LP and
DCP-AMS-KL-LP the Lift and Pull cover must be lifted before pulling down on
the pull station handle. Once the pull station is activated, the handle cannot
be put back into a normal standby condition without using the key operated
reset feature.
The DCP-AMS series is electronically addressable and includes a bi-colored
status LED. The LED blinks green indicating normal communication with the DCP
compatible SLC loop. When an alarm condition is actuated by pulling the
handle, the LED will latch Red to indicate the alarm condition.
ENGINEERING SPECIFICATIONS
Manual pull stations shall be Hochiki addressable AMS-series single or dual
action models, DCP-AMS, DCP-AMS-KL, DCP-AMS-LP, or DCP-AMS-KL-LP. Models shall
be made of 14 AWG CRS and painted with Red enamel. The words Fire Alarm shall
be in a contrasting color and be embossed text 1/2″ tall. The electronics
shall be fully integrated into the manual pull station requiring only
connection to the SLC loop of the control panel. Programming of the manual
pull station address must be possible with the manual pull station fully
installed.
Manual pull stations shall be Underwriters Laboratories Inc. Listed, CSFM
Approved, and be installed within the limits defined in the Americans With
Disabilities Act.
WIRING DIAGRAMS
Hochiki America Corporation DCP-AMS, DCP-AMS-LP, DCP-AMS-KL AND DCP-AMS-KL-LP
Specifications subject to change without notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>