SEAJIC 2ABY9SELFIE-SHOT SELFIE-SHOT Magnetic Hand Grip with Power Bank-5000mAh User Manual
- June 1, 2024
- SEAJIC
Table of Contents
SEAJIC 2ABY9SELFIE-SHOT SELFIE-SHOT Magnetic Hand Grip with Power Bank-
5000mAh
Product Introduction
- Power button: press once to power on and press twice to power off.
Bluetooth pairing:
- Press and hold it for 2 seconds to power on When the green indicator flickers, enable Bluetooth on your mobile phone to search for “SEAJIC”, then click on it to connect; the green indicator will be always on after a successful connection。
- To take photos/videos, just short press “Bluetooth/Camera” (some phones may not support taking videos)
- It will enter sleep mode in case of no connection or no key operation in 10 minutes after connection and will be shut down automatically in 30 minutes in sleep mode.
Note: when the Bluetooth doesn’t work, please enable it again by poking with your SIM card pin or another hard object Static storage duration in shutdown mode: charging it every 6 months is recommended.
Specifications
Parameters of the Magnetic Wireless Charger:
- Boundary dimensions : 120x87x50mm
- Weight : 216g
- Bluetooth transmission distance : 10m
- Input/output voltage : 5V/2A
- Input/output interface : Type-C
- Wireless charging efficiency : 75% (max)
- Wireless charging power : 5W
- Battery capacity/voltage : 5,000mAh/3.7V (18,650/2,500 mAh*2)
- Material : ABS (fireproofing) PC (fireproofing) Aluminum alloy
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2)this device must accept any interference received,
including interference that may cause undesired operation. Any Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, under part 15 of the FCC Rules. These limits are
designed toprovide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used by the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
FAQ
Q: What should I do if the Bluetooth function is not working?
A: You can reset the Bluetooth function by poking the reset hole with a SIM
card pin or another hard object.
Q: How often should I charge the device in shutdown mode?
A: It is recommended to charge the device every 6 months in shutdown mode
to maintain static storage duration.
References
- Reinvent the Creative Process | KraftGeek | Premium Tripods & Add-ons
- China Satatic Live Streaming Kit, Beauty Live Stream, Camera Photography Tripod Suppliers,Tripod bracket stand Manufacturers, Factory - OSM GROUP