Home Depot Vinyl Fence Infill Panels Instructions
- August 10, 2024
- HOME DEPOT
Table of Contents
Home Depot Vinyl Fence Infill Panels
Installation Instruction
Important: Contact your local authorities prior to digging any post holes to locate and identify possible buried utilities.
Prior to installation, it is the responsibility of the installer to meet all code and safety requirements, and to obtain all required building permits. Contact your local authorities regarding any local zoning laws, neighborhood associations and/or historic districts that may regulate size, type, placement, and ability of fencing. Ensure compliance before starting your fence Installation. J. Sonic Services and its distributors shall not be held liable for improper or unsafe installations.
Tools and Materials (Not Included)
- Screwdriver
- Tape Measure
- PVC Glue
- Power Drill
- 1/8” Drill Bit
- Safety Glasses
Preparation
Determine the full placement of the fencing area. Ensure you have the correct number of panels and components per section. Plan and make any necessary adjustments for odd widths at the back corners or build partial sections equally. Determine the number of posts including the gate post and the gate locations (if applicable)
Sloped Fencing
Note that this style of fencing is designed to be installed on a level surface. It is not designed to be angled to follow slopes.
Installing the Bottom Rail – Aluminum Rail
Slide the 2 long “L” brackets into the post channel down to bottom (short side facing up) and mark for holes placement. Slide out the “L” brackets from the post.
Follow markings and pre-drill holes for screws of “L” brackets in to the post channel with a 1/8” (3.2mm) drill bit.
Position the “L” brackets on top of flat part of bottom rail (Short side facing out) and mark holes placement. Pre-drill holes.
Slide the “L” brackets into slots at the end of the bottom rail and use pre- drilled holes to secure “L” brackets in place.
Slide the bottom rail down through the post channels to the bottom. Ensure the spacing between the posts is correct before securing the bottom rail.
Secure the bottom rail with “L” brackets into the pre-drilled post holes.
Install Fence Boards & Finish Framing
Insert the vinyl panels by sliding them one at a time and fitting them into the post channel with the tongue facing away from the post.
Position the 2 short “L” brackets on top of the flat part of the top rail (short side facing out) and mark the holes placement. Pre-drill the holes. Be aware that the “L” brackets for the bottom rail are different from the top rail.
Slide the “L” brackets into the end of the top rail and use pre-drilled holes to secure the “L” brackets in place with black screws.
Place the top rail on top of the vinyl panels holding them down into place. Secure in place with screws
Repeat the steps above for each fence section until the fence is complete. Keeping in mind the location of the fence gate
Care & Maintenance
Using a non-abrasive sponge, apply soapy water to the fence.
For stubborn dirt and residue, scrub the fence boards using a cleaning brush.
Rinse the fence with water and let dry.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>