baby trend Adapt 4-in-1 High Chair Instruction Manual

: August 13, 2024
: baby trend

Table of Contents

MODES
PARTS
ASSEMBLY
SAFETY
PRODUCT CARE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Read all instructions BEFORE
assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE.
Adapt 4-in-1 High Chair to Toddler Chair
Instruction Manual
Manual de Instrucciones
HC12XXXA

MODES

MODES OF USE

Traditional High Chair
With tray installed, can be fully reclined| Infant High Chair
Without tray installed, can be fully reclined
---|---
|
Toddler Chair
Only use with most upright position remove restraint system when in use| Dining Chair
Without tray installed, can be fully reclined
|

PARTS

Check that you have all the parts for this model before assembly.

WARNING
WARNING: Failure to follow these warnings and Failure to follow these warnings and the instructions could result in serious injury or death.the instructions could result in serious injury or death.
FALL HAZARD: Children have suffered severe Children have suffered severe head injuries including skull fractures when falling from head injuries including skull fractures when falling from high chairs. Falls can happen suddenly if child is not high chairs. Falls can happen suddenly if child is not restrained properly.restrained properly.
Always use restraints, and adjust to fit snugly.Always use restraints, and adjust to fit snugly.
Tray is not designed to hold child in chair.Tray is not designed to hold child in chair.
Stay near and watch child during use.Stay near and watch child during use.
Never allow child to push away from table.Never allow child to push away from table.
STRANGULATION HAZARD:
Do not place High Chair in any location in where there Do not place High Chair in any location in where there are cords, such as a window blind cords, drapes, phone are cords, such as a window blind cords, drapes, phone cords etc.cords etc.
WARNING: The child should be secured in the The child should be secured in the high chair at all times by the 5-point restraining system, high chair at all times by the 5-point restraining system, either in the reclining, semi- reclining or upright position either in the reclining, semi-reclining or upright position (The requirement does not apply to toddler chair mode).(The requirement does not apply to toddler chair mode).
The tray is not designed to hold the child in the chair. The tray is not designed to hold the child in the chair.
It is recommended that the product be used in the It is recommended that the product be used in the upright position only by children capable of sitting upright upright position only by children capable of sitting upright nassisted.unassisted.
The product should be used only by children at least 6 The product should be used only by children at least 6 months of age. months of age.
See page 13 for instructions on proper use of restraint See page 13 for instructions on proper use of restraint system.system.
Other accessory items may change the balance of the Other accessory items may change the balance of the high chair and cause hazardous unstable conditions.high chair and cause hazardous unstable conditions.
This high chair is designed to be used by a child with a This high chair is designed to be used by a child with a maximum weight of 45 lb, (20.41 kg).maximum weight of 45 lb, (20.41 kg).
The Toddler Chair is designed to be used by a child at The Toddler Chair is designed to be used by a child at least 1 year of age.least 1 year of age.
The Toddler Chair is designed to be used by a child with a The Toddler Chair is designed to be used by a child with a maximum weight of 60 lb, (27.21 kg).maximum weight of 60 lb, (27.21 kg).
NEVER allow your high chair to be used as a toy.NEVER allow your high chair to be used as a toy.
NEVER use this product if there are any loose or NEVER use this product if there are any loose or missing fasteners, loose joints, broken parts, or torn missing fasteners, loose joints, broken parts, or torn mesh/fabric. Check before assembly and periodically mesh/fabric. Check before assembly and periodically during use. Contact Baby Trend Customer Service at during use. Contact Baby Trend Customer Service at 1-800-328-7363 for replacement parts, repair or 1-800-328-7363 for replacement parts, repair or
instructions. instructions.
NEVER substitute parts.NEVER substitute parts.
WARNING: Prevent serious injury or death. Do Prevent serious injury or death. Do not use in motor vehicles.not use in motor vehicles.
WARNING: The tray is not designed to hold the The tray is not designed to hold the child in the chair.child in the chair.
IMPORTANT! To ensure safe operation of your To ensure safe operation of your product, please follow these instructions carefully. Please product, please follow these instructions carefully. Please keep these instructions for future reference.keep these instructions for future reference.
IMPORTANT! Before assembly and each use, Before assembly and each use, inspect this product for damaged hardware, loose joints, inspect this product for damaged hardware, loose joints,missing parts or sharp edges. NEVER use if any parts are missing parts or sharp edges. NEVER use if any parts are missing or broken.missing or broken.
IMPORTANT! Adult assembly is required. Adult assembly is required.

ASSEMBLY

TO ASSEMBLE SEAT

• Insert metal tabs (1) and (2) directly into the seat base slot until it secures into place. Ensure the backrest sits in the base correctly (Fig. 1a). • Important Pin Set Up: The backrest must be in the most upright position before inserting the pins (Fig. 1b). • Press Pins In: Ensure the seat parts latched together in the upright position. Insert the pin all the way into each side of the seat base and test the recline feature (Fig. 1c).
CAUTION: DO NOT push pin into the base only. Must catch base and backrest (Fig. 1d).
• Loop the flap on the back of the pad over the top of the Seat Back.
Connect the Seat Pad to the Seat Back with the two Elastic Loops. These fit over the Attachment Tabs located near the top harness slots (Fig. 2a).
• Attach the bottom of Seat Pad to the Seat Base with the two Elastic loops located at the rear of the bottom of the Seat Pad. These fit over the Attachment Tabs located on the underside of the Seat Base (Fig. 2b).
• Attach each anchor hook of the Seat Pad to the side of the seat armrest. Ensure that the slot of the anchor hook slides through the under side division (Fig. 2c). TO ASSEMBLE HIGH CHAIR LEGS
• Press down on metal pin on the upper leg and insert it into the underside of the seat base until the pin clicks in place (Fig. 3a).
NOTE: The 2 legs with warning labels should be assemble to the front side of the highchair.
• With foot rest facing out, press down on metal pin on upper legs and slide the foot rest on until it clicks in place (Fig. 3b). Repeat these step above for the back leg brace (Fig. 3b).
• Press down on metal pin on the lower leg and insert it into the upper leg until the pin clicks in place (Fig. 3c).
• Press down on metal pin on the foot and insert it into the lower leg until the pin clicks in place (Fig. 3d).
• Repeat these steps for the remaining feet and legs to assemble the traditional high chair. TO CONVERT HIGH CHAIR TO TODDLER CHAIR
WARNING: For toddler chair mode, the For toddler chair mode, the reclined backrest may cause a hazardous unstable reclined backrest may cause a hazardous unstable condition to exist, this mode can ONLY be used with condition to exist, this mode can ONLY be used with most upright position.most upright position. Please ALWAYS remove 5-point restraining system before use this product as toddler chair mode.
• Remove the foot from the lower leg by pressing on the metal pin, twist the foot and pull the foot away from the lower leg (Fig. 4a). **• Repeat the step above to remove the lower leg from the upper leg.
• Press down on metal pin on the foot and insert it into the upper leg until the pin clicks in place (Refer to Fig. 3a).
• Repeat the steps above for the remaining feet.
• Refer to page 14 to detach 5-point harness to convert the high chair to the toddler chair (Fig. 4b).
Note: Please keep the 5-point harness safely for future use for other modes of this product. TO ATTACH TRAY
WARNING:** The tray is not designed to hold The tray is not designed to hold the child in the chair. The child should be secured in the child in the chair. The child should be secured in the high chair at all times by the 5-point restraining the high chair at all times by the 5-point restraining system, either in the reclining, semi-reclining or upright system, either in the reclining, semi-reclining or upright position (The requirement does not apply to toddler position (The requirement does not apply to toddler
chair mode). Stay near and watch child during use. chair mode). Stay near and watch child during use. Never leave child unattended.Never leave child unattended.
• To attach the Tray, squeeze the release handle located underneath the tray, line up the grooves on the bottom of the tray parallel with the armrests of the high chair, slide the tray onto the armrests and release the release handle. Check that the Tray is securely locked on the armrest (Fig. 5a).
• The Tray has a 4-position adjustment. To adjust the position, squeeze the Tray’s release handle and reposition the tray to the desired position (Fig. 5b). Release the Tray’s handle. Check that the Tray is securely locked in its new position. • The Tray may be stored on the back legs of the High Chair. Align the holes in the rear of the tray with the small pegs on the back legs (Fig. 5c). NOTE: To remove, lift the tray.

SAFETY

TO USE SAFETY BELT
WARNING: The highchair should be used only by The highchair should be used only by children capable of sitting upright unassisted and at children capable of sitting upright unassisted and at least 6 months of age.least 6 months of age.
WARNING: Prevent serious injury or death from Prevent serious injury or death from falls or sliding out. Always use the restraint system. The falls or sliding out. Always use the restraint system. The child should be secured in the high chair at all times child should be secured in the high chair at all times by the 5-point restraining system, either in the reclining, by the 5-point restraining system, either in the reclining, semi-reclining or upright position (The requirement semi-reclining or upright position (The requirement does not apply to toddler chair mode).does not apply to toddler chair mode).

• 5-point harness: The shoulder straps of the 5-point harness have 2 attachment positions. Select the position that places the shoulder strap level with, or below, the top of the child’s shoulders (Fig. 6a). • Carefully place the child in the seat and position the safety harness around the child’s waist and over the shoulders. Place the crotch strap between the child’s legs. Insert the male end of each shoulder / waist belt into the buckle on the crotch strap. Tighten the harness to be snug around the child’s waist and over the child’s shoulders (Fig. 6b). TO RELEASE SAFETY BELT
• Push Button on Center Clasp, the two. Harness Buckles will pop fr(Fig. 7). TO DETACH/RE-ATTACH 5-POINT HARNESS
• To detach 5-point harness, fold the anchor flaps and pull out each of the five straps out of their corresponding hole (8a). • To re-attach 5-point harness, fold the anchor flaps and insert each of the 5 anchor flaps into their corresponding holes through the seat pad and seat back (8b).
RECLINE SEAT
• Squeeze recline lever on back of the seat and adjust to the preferred recline or upright position (Fig. 9). Use caution not to trap arms, hands and fingers when adjusting recline positions. TO REATTACH SEAT PAD
NOTE: Certain High Chair models are packaged with the High Chair Seat Pad and Seat Insert already attached to the Seat Back.

PRODUCT CARE

• Thread non-buckle end of Harness Straps called Harness Attachment Tabs through the provided slots in the Seat Fabric, Seat Insert, Seat Back, and Seat Base (Fig. 10). When Harness Attachment Tabs are through the provided slots, rotate the Harness Attachment Tabs 90 degrees. Make sure that the straps are firmly in place.
• Revert to step 2 and follow steps (Fig. 2a to Fig. 2b).

CARE AND MAINTENANCE
WARNING: Harness Straps are NOT washable. Harness Straps are NOT washable.
High Chair/Tray:
Use mild soap and wash with damp cloth. Please use only a soft bristle brush, sponge or cloth to clean the surface or remove particles of food.
DO NOT submerge High Chair and Tray in water. Surface clean only.
Seat Pad:
Please refer to the care label on individual soft good pieces for cleaning instructions.
To remove the seat pad:
Remove Harness Straps by pushing Harness Attachment Tabs through the Harness slots on the Seat Back, Seat Base and Seat Pad. Remove Elastic Loops from Attachment Tabs on Seat Base and Seat Back.
To attach the seat pad:
Carefully follow the instructions outlined in Step 6 on how to correctly re- thread the safety harness.

WARRANTY
DO NOT RETURN YOUR PRODUCT TO THE STORE. PLEASE CONTACT BABY TREND® FOR REPLACEMENT PARTS, SERVICE AND REPAIR.
The Baby Trend® warranty covers workmanship defects within 1 year of purchase.
Any product which has been subjected to misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental exposure, alteration or accident, or has had its serial number altered or removed invalidates all claims against the manufacturer. Any damage to property during installation is the sole responsibility of the end user.
Customer Service Department can be contacted at 1 800-328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®. Please visit http://babytrend.com/pages/ limited-warranty for complete warranty details.

Baby Trend, Inc. 13048 Valley Blvd. Fontana CA 92335
1-800-328-7363 • (8:00am ~ 4:30pm PST)
www.babytrend.com
Copyright © 2024, Baby Trend Inc.,
All Rights Reserved. Todos los derechos reservados.