TEAM ASSOCIATED RC10B74.2D B74.2D CE Supplement Pg. 1 Instruction Manual
- August 6, 2024
- TEAM ASSOCIATED
Table of Contents
TEAM ASSOCIATED RC10B74.2D B74.2D CE Supplement Pg. 1
Specifications
- Model: B74.2D CE Supplement
- Material: Plastic
- Includes: Diff sun gear, pinion gear, planet gear, strengthening ring, molded ring gear, wheel hex, shock pistons, shock fluid, steering block arm
FAQs
- Q: What type of surfaces are these gears suitable for?
- A: The gears are intended for use on carpet or astro turf surfaces with center differentials in stock class racing. Avoid modified power and use slipper clutches to prevent early gear failure.
INSTALLATION STEPS
B74.2D CE Supplement Pg. 1
- Bag 3 – Step 1
- Bag 3 – Step 2
- Bag 3 – Step 2
- Remove the machined pinion gear and replace it with the molded pinion gear included in this set.
- Note that #92319 Pinion Gear Shim (5×6.5x1mm) will not be used with the molded pinion gear.
- Assemble molded ring gear and strengthening ring to diff case as shown below.
- Be sure not to over-tighten the ring gear screws. This will lead to the gear warping.
- Bag 4 – Steps 1, 3, and 4
- Both front and rear differentials should be shimmed tight from the start so that you can feel the teeth when you spin the pinion gear (one shim on both sides of the diff case side should be the default starting position).
- The gear mesh should be checked after the fi rst couple of runs to tighten it back up if it has loosened. #92139 RC10B74 Differential Outdrive Shims can be used to finely adjust the mesh.
- Running the gear mesh loose can result in premature failure.
- FT recommends the use of #6636 Silicone Grease to prevent gear skipping and prolong the life of the gears.
- Please note that these gears are intended for use with a center differential and stock class racing.
- Modifi ed power, the use of a slipper clutch, and running on carpet or astro turf can lead to early failure of these gears.
B74.2D CE Supplement Pg.2
- Bag 7 – Step 1
- Bag 7 – Step 2
- Bag 10 – Step 1
- Bag 11 – Step 1
- Bag 11 – Step 4
Front Suspension
Rear Suspension
Electronics
Differential
Shocks
Track Info
Tires
Body, Wing, Weight
For more setups, visit RC10.com and click on “Setup Sheets”
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>