JC BATTERY JCBATTERY-M Jc Tall Tubular Battery Instructions
- June 6, 2024
- JC BATTERY
Table of Contents
JC BATTERY JCBATTERY-M Jc Tall Tubular Battery
General information
Before using this product, please read the user manual carefully. This particularly applies to the safety instructions. Failure to observe this user manual may result in severe injury or damage to the product. Store the user manual for future use.
-
Check the packed contents
If you are not cautious when opening the packaging with a sharp knife or other pointed objects, you may quickly damage the torch. -
Be very careful when opening.
-
Take the product out of the packaging.
-
Check to make sure that the product is completed.
Technical specifications
- use of temperature: 45℃
- Model: JCBATTERY-M
- Protection class: IP20
- Output (Micro-USB): 5V DC,max.1A
- Battery Type: Li-ion, Rechargeable Integrated
- Voltage: 3.7 V
- Capacity: 4,400 mAh
- Type: rechargeable, integrated lithium-ion battery pack
- Charging time: approx.4–5 h
- Use environment: fixed use
Usage
The maximum usage time of the torch is about 3hours 50% brightness and approx. 1.5hours 100% brightness.
- Push the On/Off switch once for ON, twice for OFF.
- The mobile phone with a wireless charging function can be charged by placing it on the surface of the product with rubber material.
- Attention! In the process of using the mobile phone, there is a matching matter, please try to place the coil of the mobi le phone in the center of the product rubber pad or a relatively matching position, this may need to manually move the mobile phone to match, but please note that you only need to move the mobile phone.
- After the phone is matched with the product, the product can charge the phone
- It also has the power bank function, which is consistent with the normal charging connection of the mobile phone. There may have a little difference on the efficiency of charging but it does not affect the charging function
Cleaning
Risk of damage! Improper handling of the product may damage it.
- Do not use any aggressive cleaners, brushes with metal or nylon bristles or sharp or metallic cleaning utensils such as knives, hard scrapers and the like. They could damage the surfaces.
- Never submerge the product in water or other liquids.
- Make sure that water and other liquids do not end up in the housing.
Storage
Always store the product in a dry area. The battery in this product is not exchangeable, please replace the new device in time after the service life reaches. Keep away from all flame during storage.
FCC ID warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
FCC RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm (7.8 inches) between the antenna and your body when the function for Wireless charging in active. Users must follow the specific operating instructions for satisfying RF exposure compliance Any changes or modifications in the construction of this device that are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different Form that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF warning statement
The device has been evaluated to meet general RF exposure requirements.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>