BLU PRODUCTS BLUG52L Smartphone User Guide
- June 8, 2024
- Blu Products
Table of Contents
BLU PRODUCTS BLUG52L Smartphone
Federal Communication Commission Interference Statement
FCC ID: YHLBLUG52L
This device complies with Part 15 of the FCC Rules Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation. This equipment has been
tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference radio communications. However, there is no
guarantee that interference will not occur in a particular installation. t
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit ditferent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution : Any changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate this equipment.
Radiation Exposure Statement:
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. The exposure standard for wireless device
employs a unit of measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6W/kg. Tests for SAR are conducted using
standard operating positions (1Omm) accepted by the FCC with the device
transmitting at its highest certified power level in all tested frequency
bands.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>