COMMSCOPE G22RHDX Monopole Sector Frame Instructions
- July 31, 2024
- CommScope
Table of Contents
COMMSCOPE G22RHDX Monopole Sector Frame
Specifications
- Manufacturer: CommScope, Inc.
- Model: MCG22RHDX-15MB
- Material: Steel
- Dimensions: Height 120”, Length 180”, Width 84”
- Weight: 1942.17 lbs
- Surface Area: 63756.52 sq in
Product Usage Instructions
Installation
- Identify any hazards or obstructions before installing the product.
- Ensure the product fits monopoles with outer diameters (OD) ranging from 30 to 50 inches.
- Tighten all bolts securing flat plates using the turn-of-nut method.
- Tighten all U-bolts using the turn-of-nut method, maintaining equal distance and force on each leg of the U-bolt.
Packaging
- Packaging must meet CommScope requirements as per document IS-PL-3005.
- Place printed documents inside a polybag before placing them in the shipping container.
- Extra hardware may be supplied, bagged, and shipped along with the product.
FAQ
Q: What are the allowable tieback angles for the product?
A: The product allows for a tieback angle of 15 degrees vertical and 25
degrees horizontal.
Q: What are the individual component part numbers provided for assembly?
A: The component part numbers provided for assembly purposes are:
- 1. MC-RM1550-3 – 15-50 OD Ringmount Weldment
- 2. SFG2204 – Back Vertical Arm Mount Arm
- 3. SFG2278 – Standoff SFG22
- 4. XP-R – Crossover Plate, Round, up to 3.5 OD
- 5. XAU01 – Angle, Crossover, 1.9-3.5 x 1.9-3.5 OD
- 6. GB-05225 – 5/8 x 2-1/4 Galv Bolt Kit
GENERAL NOTES
- ALL METRIC DIMENSIONS ARE IN BRACKETS [X. X]
- FOR PATENT INFO: https://www.cs-pat.com
DESIGN NOTES
- ANY HAZARDS OR OBSTRUCTIONS TO THE CLIMBING FACILITY AND SAFETY CLIMB MUST BE IDENTIFIED PRIOR TO INSTALLING THE APPURTENANCE. ADDITIONAL PRODUCTS MAY BE REQUIRED TO MAINTAIN THE INTEGRITY OF THE SAFETY CLIMB. DURING INSTALLATION, TEMPORARY AND/OR PERMANENT PRECAUTIONARY MEASURES SHOULD BE TAKEN TO PRESERVE THE CLIMBING FACILITY AND/OR SAFETY CLIMB.
- FITS MONOPOLES 30″ TO 50″ OD.
MANUFACTURING/SPECIAL REQUIREMENTS
TIGHTEN ALL BOLTS SECURING FLAT PLATES BY THE TURN-OF-NUT METHOD. TIGHTEN ALL U-BOLTS USING TURN-OF-NUT METHOD WITH ATTENTION TO LEAVE EQUAL DISTANCE AND EQUAL FORCE ON EACH LEG OF THE U-BOLT.
TEST
COMPONENT PART NUMBERS PROVIDED FOR ASSEMBLY PURPOSES;
INDIVIDUAL COMPONENTS MAY BE SHIPPED AS PARTS WITHIN AN INCLUDED KIT.
PACKAGING
- PACKAGING SHALL MEET COMMSCOPE REQUIREMENTS PER DOCUMENT IS-PL-3005.
- PRINTED DOCUMENT TO BE PLACED INSIDE POLYBAG AND THEN IN SHIPPING CONTAINER.
- EXTRA HARDWARE MAY BE SUPPLIED, BAGGED AND SHIPPED.
References
Read User Manual Online (PDF format)
Loading......