dormakaba IP-516418-15 Saffire LX-P Smart Locks Instruction Manual
- July 29, 2024
- dormakaba
Table of Contents
dormakaba IP-516418-15 Saffire LX-P Smart Locks
Product Specifications
- Product Models: Saffire LX-P & Saffire EVO LZ-P
- Manufacturer : SARGENT
- Model : 8710F
- Door Thickness : 2.750” [70mm]
- Backset Adjustment Dimension Y: .032” [0.81mm] – .072” [1.83mm]
- Thread Class / Filet Finish: SAE: 2A-2B, ISO: 6g / 6H
Product Usage Instructions
Preparation
Before installation, refer to the exit device manufacturer’s instructions
for cut-out details and specifications.
Installation Process
- Ensure the backset is adjusted according to the exit device manufacturer’s requirements.
- Use the correct template for the specific lock model being installed.
- Verify the door thickness and backset adjustment dimensions before proceeding.
Important Notes
- It is strongly recommended to complete a full-door mockup to ensure all necessary parts are included for a successful installation.
- Different locking device options may be available for the same lock model.
- Consult your local sales representative or authorized reseller for further assistance.
SARGENT 8710F exit door preparation
- FOR EXIT DEVICE AND MORTISE LOCK CUT-OUT REFER TO EXIT DEVICE MANUFACTURER INSTALLATION INSTRUCTIONS.
- BACKSET SHOWN FOR REFERENCE ONLY, ADJUST BACKSET TO EXIT DEVICE MANUFACTURER INSTALLATION INSTRUCTIONS. BACKSET TO BE ADJUSTED TO LOW AND HIGH BEVEL DOOR EDGE AS PER BACKSET ADJUSTMENT TABLE.
- DIMENSIONS ARE SYMETRICAL ABOUT UNLESS OTHERWISE NOTED.
- FOR SURFACE MOUNT VARIANTS PLEASE REFER TO IP-516418-15 FOR THE PLACEMENT OF HOLE 0.750″ & CABLE GROOVE 0.250″. HOLES 2×0.250″ NOT REQUIRED.
- GROOVE TO BE DONE ONLY IN SOLID DOORS. TO PASS WIRES INSIDE THE DOOR FOR HOLLOW DOORS.
- REFER TO SPECIFIC TOLERANCES TABLE FOR DIMENSIONS MARKED WITH #.
- DRAWING IS NOT TO SCALE.
- DIMENSIONS ARE IN INCHES [mm].
DIMENSIONS = IMPERIAL [MILLIMETER]
SPECIFIC TOLERANCES
BACKSET ADJUSTMENT FOR 3° BEVEL DOOR
WARNING
- To verify lock coverage and door operation meet expectations, dormakaba strongly recommends completing a full door mockup. This will ensure that all necessary products and parts for a successful installation are included.
- Always validate that you have selected the correct template for the specific lock model being installed. The same lock model can be offered with different locking device options.
- The drawing is not to scale. Measurements are for reference only. Not a drilling template.
- If you have any questions, please contact your local sales representative or authorized reseller.
FAQ
Q: Do I need to adjust the backset for installation?
A: Yes, adjust the backset according to the exit device manufacturer’s
specifications for proper installation.
Q: What should I do if I encounter difficulties during installation?
A: If you face any challenges during installation, please contact our customer
support team or consult with your local sales representative for assistance.
Read User Manual Online (PDF format)
Loading......