dormakaba Saffire EVO LZ-P Wi-Fi Lock Security Instruction Manual

dormakaba Saffire EVO LZ-P Wi-Fi Lock Security

Specifications

• Product Name: Saffire LX-P & Saffire EVO LZ-P
• Series: Saffire LX & Saffire EVO LZ
• Model Number: IP-516418-7A – Rev 2
• Backset Adjustment Dimension Y: .032” [0.81mm] – .072” [1.83mm]
• Door Thickness Dimension X: 2.750” [70mm] – 2.75” [69.9mm]
• Thread Class / Filet Finish / Finish: SAE: 2A-2B ISO: 6g / 6H
• Door Handing: Right Hand, Left Hand, Reverse

Product Usage Instructions

Installation:

1. Refer to the exit device manufacturer installation instructions for cut-out dimensions.
2. Adjust the backset according to the exit device manufacturer’s specifications.
3. Ensure the door thickness falls within the specified range for proper installation.
4. Check and adjust the door handing as needed for the specific model.
5. Follow the threading class and finish guidelines for installation.

Door Preparation:

1. Measure and mark the cut-out dimensions as per the provided specifications.
2. Ensure precise hole drilling within specified tolerances for proper fit.
3. Adjust backset and bevel edges as required for the specific door thickness.
4. Verify all distances and dimensions marked on the door for accuracy before installation.

Maintenance:
Regularly inspect the product for any signs of wear or damage. Clean and lubricate moving parts as necessary to ensure smooth operation.

FAQ

• What should I do if the door thickness does not fall within the specified range?
  If the door thickness is not within the specified range, consult with a professional installer or contact customer support for guidance on possible solutions.

• How can I determine the correct door handing for my model?
  Refer to the product manual or markings on the product itself to identify the correct door handing (Right Hand, Left Hand, or Reverse) based on your specific requirements.

NOTES:

1. FOR EXIT DEVICE AND MORTISE LOCK CUT-OUT REFER TO EXIT DEVICE MANUFACTURER INSTALLATION INSTRUCTIONS.
2. BACKSET SHOWN FOR REFERENCE ONLY, ADJUST BACKSET TO EXIT DEVICE MANUFACTURER INSTALLATION INSTRUCTIONS. BACKSET TO BE ADJUSTED TO LOW AND HIGH BEVEL DOOR EDGE AS PER BACKSET ADJUSTMENT TABLE.
3. DIMENSIONS ARE SYMETRICAL ABOUT UNLESS OTHERWISE NOTED.
4. FOR SURFACE MOUNT VARIANTS PLEASE REFER TO IP-516418-15 FOR THE PLACEMENT OF HOLE 0.750″ & CABLE GROOVE 0.250″. HOLES 2×0.250″ NOT REQUIRED.
5. GROOVE TO BE DONE ONLY IN SOLID DOORS. TO PASS WIRES INSIDE THE DOOR FOR HOLLOW DOORS.
6. REFER TO SPECIFIC TOLERANCES TABLE FOR DIMENSIONS MARKED WITH #.
7. DRAWING IS NOT TO SCALE.
8. DIMENSIONS ARE IN INCHES [mm].

DIMENSION

DIMENSIONS = IMPERIAL (MILLIMETER)
3D FILE GOVERNS ALL UNSPECIFIED DIMENSIONS & GENERAL TOLERANCES APPLY

SPECIFIC TOLERANCES

-.000 [0.00]

WARNING

• To verify lock coverage and door operation meets expectations, dormakaba strongly recommends completing a full door mockup. This will ensure that all necessary products and parts for a successful installation are included.
• Always validate that you have selected the correct template for specific lock model being installed. The same lock model can be offered with different locking device options.
• Drawing is not to scale. Measurements are for reference only. Not a drilling template.
• If you have any questions, please contact your local sales representative or authorized reseller

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>