FORUM LIGHTING GU10 Leto Twin Spotlight Instructions
- July 29, 2024
- Forum Lighting
Table of Contents
FORUM LIGHTING GU10 Leto Twin Spotlight
TOOLS REQUIRED
- REQUIRES 2 X 7W MAX. GU10 LED REFLECTOR BULBS
- BULBS NOT INCLUDED
Installation Instructions
-
Step A
Turn off the power at the circuit breaker.
Illustration: A hand turning off a circuit breaker switch labeled “OFF”. -
Step B
Prepare the light fixture for installation.
Illustration: The light fixture with two bulb sockets. -
Step C
Mount the fixture base to the wall.
Illustration: The fixture base being attached to the wall with screws and anchors. The letter “C” indicates the screws and anchors. -
Step D
Connect the electrical wires from the wall to the fixture.
Illustration: The wires being connected to the fixture. A close-up of the wiring diagram shows the connections for “N” (neutral) and “L” (live). -
Step E
Secure the fixture to the wall.
Illustration: The fixture being secured to the wall with screws labeled “C”. -
Step F
Install the GU10 LED reflector bulbs into the sockets.
Illustration: The bulbs being inserted into the sockets. The letter “C” indicates the bulbs. -
Step G
Ensure the bulbs are properly installed and secured.
Illustration: The bulbs securely in place. The text “No incl” indicates that bulbs are not included. -
Step H
Turn on the power at the circuit breaker.
Illustration: A hand turning on a circuit breaker switch labeled “ON”.
Note: Please take time to read this leaflet carefully and retain it for future reference.
Specifications
| Model | INS 34018 |
|---|---|
| IP Rating | IP65 |
| Bulb Type | GU10 LED Reflector Bulbs |
| Max Wattage | 2 x 7W |
FAQ
-
Q: What type of bulbs are required for this fixture?
A: This fixture requires 2 x 7W Max. GU10 LED Reflector Bulbs. -
Q: Are the bulbs included with the fixture?
A: No, the bulbs are not included. -
Q: How do I turn off the power before installation?
A: Turn off the power at the circuit breaker by switching the breaker to the “OFF” position. -
Q: How do I connect the wires?
A: Connect the electrical wires from the wall to the fixture according to the wiring diagram, ensuring the neutral (N) and live (L) wires are correctly connected. -
Q: What should I do if the fixture does not work after installation?
A: Ensure the power is turned on at the circuit breaker and check that the bulbs are properly installed and secured. If the problem persists, consult a qualified electrician.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>