SLC SHIFT 200-210 3K-4K Ceiling Down Light Installation Guide
- July 27, 2024
- SLC
Table of Contents
SLC SHIFT 200-210 3K-4K Ceiling Down Light
PRODUCT OVERVIEW
CONNECTION
DIMENSION
Installation Spacing
- Only to be installed by an authorized electrician
- Power off before installing
INSTALLATION INSTRUCTION
Sensor datasheet
Wiering diagram
Detection range diagram
Settings
Detection area
The detection area can be adjusted by the knob, clockwise adjustment increases
the sensitivity, counterclockwise adjustment reduces the sensitivity, the
maximum detection distance is 6 meters, and the minimum detection distance is
2 meters.
- Notice 1 : The distance test is carried out under Ta25°C, 1.8 meters wall mounting installation height. The test result is based on the movement along the tangential direction of the sensor, and the detection distance can be adjusted by the dial switch.
- Notice 2 : The infrared sensor will be affected by temperature. Too high or too low temperature may affect the detect distance or even cause failure to the sensor.
Hold time
The hold time can be adjusted by the knob. Clockwise adjustment increases the
hold time, counterclockwise adjustment reduces the hold time, the maximum hold
time is 7min, and the minimum hold time is 10S.
Notice 1 :The hold time counting should be started after the sensor is powered on and initialized.
Daylight sensor
The light threshold can be selected through the Knob. The clockwise adjustment
increases the light threshold, counterclockwise the adjustment reduces the
light threshold, the maximum light threshold is 2000lux, and the minimum light
threshold is 10lux.
Notice 1: The light threshold may cause a large deviation in different lamps.
THE LIGHT GROUP AS | TIf.: +47 38 00 21 01 | E-Mail: post@tlg.no Miavannsvegen 175 | 4628 | Kristiansand S | Norway