ZhangWei HJ168A Smart Music Star Projection Lamp User Manual
- June 6, 2024
- ZhangWei
Table of Contents
ZhangWei HJ168A Smart Music Star Projection Lamp User Manual
BOX CONTENTS
- Projecting Light x1
- Fixed seat x1
- User Manual x1
- Type-C USB cable x1
- Power button
- Laser speed control button
- Cloud Projecting speed adjustment button
- Music control button
- Wireless connections button
- Remote control receiver
- Fixed seat
- LED Cloud Projecting
- Laser Beam Pointing
- Type-C USB Jack
SPECIFICATIONS
Power Input: DC 5V
Light Source: green laser light
Light power: laser light≤5mW(for US)
laser light≤1mW(for UK)
LED RGB light= 4W
Dimension: 18016585mm
Materials: ABS
Working temperature: -20℃ to 40 ℃
Light coverage area: UP to 64 sq.m form 3.0m distance UP to 81 sq.m form
4.0m distance
Battery: 18650 lithium battery 2400 mAh
Working time: Laser +Cloud +Music: 4-5hrs
Laser +Cloud: 6-7hrs
Music :7-8hrs
Remote control distance 5 meters
- Place the fixed base on a flat table or the ground, and then place the starlight on the fixed base.
- Irradiation angle can be adjusted arbitrarily.
For optimal coverage, carefully put this product onto a clean, flat and solid surface – such as a table-top, or cabinet top, close to any power socket. Make sure the light at least 6 feet to the ceiling or top surfaces you are trying to illuminate. This will provide for an area about 60 sq. ft.
Power button: Long press the button for 2 seconds to start the product, Press once to turn off Cloud Projecting, Press twice to turn off the laser light, Press the third time to turn off the laser light and Cloud Projecting
Laser speed control: the default is medium speed when starting, press the first time to switch to high speed, press the second time to switch to low speed, press the third time to pause
Cloud Projecting speed adjustment: the default is medium speed when starting up, press the first time to switch to high speed, press the second time to switch to low speed, press the third time to pause
Music control mode: Press once to turn on the sound control mode, the light will flash in accordance with the music rhythm. Press again to OFF.
Wireless connections: Press once to turn on the Wireless connections, after connecting with the mobile phone, you can play music or make a phone call.
Multiple Charging Methods
4-5Hrs charged time with Type-C USB cable.
-
Adapter
-
computer
-
car charger
-
power bank
-
USB charging
IMPORTANT SAFETY INSTRUCTIONS
-
No recommended for set-up or installation by children. As with all electrical products, exercise caution during handling and use to reduce the risk of electric shock if the power cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid а hazard.
-
To reduce the risk of burns, fire, electric shock, or injury to persons, unplug from outlet before putting on or taking off parts.
-
Close supervision is necessary when this finishing is used by, or near children, invalids, or disabled persons.
-
Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer.
-
keep the cord away from heaters or other heated surfaces
-
Do not operate where aerosol (spray) products are being used or where oxygen is being administered
-
To disconnect, turn all controls to the off position, then remove plug from power socket.
-
That furnishing has not been evaluated for flammability or cigarette ignition resistance
-
Route the power supply cord away from walkways, driveways and traffic areas to prevent trip hazards. and damage to the power supply cord.
-
Do not shake.
-
ONLY ALLOW USE BY RESPONSIBLE PERSONS.
This is not a toy. Children can safely use Class I lasers only with continuous adult supervision. -
The product is not waterproof, only allowed to use for indoor or dry places.
IMPORTANT:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not accept liability for any resulting defects or problems. Keep away from heaters and other heating sources! if the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. Leave the device switched off until it has reached room temperature. Please note that damage caused by manual modification on the device or unauthorized operations by unqualified personnel is not warranted. Keep young children and amateurs away from the device!.
WARNING:
Within 10 nautical miles of an airport, never project the laser beams into sky. if you are located in the area within 10 nautical miles of an airport we recommend the laser be pointed at the wall or the ground so that no lasers point into the air!.
SAFE USE GUIDANCE -GENARAL
A Class 2 a laser is low powered it normally would not ham eyes during a momentary exposure of less than 1/4 second, this is within the aversion response, where a person turns away and/or blinks to avoid bright light.
Do not deliberately look or stare into the laser beam. Laser protective eyewear is normally not necessary. A Class 2 a laser is not a skin or materials burn hazard.
However, a Class 2 a laser can be a distraction, glare or flash blindness hazard for pilots and drivers.
NEVER: aim any laser towards an aircraft or vehicle that is in motion. This is unsafe and illegal you could be arrested and jailed.
CAUTIONEYE INJURY HAZARD- DIRECT AND REFLECTED ВЕАМ
Class 2 a visible-light lasers are considered safe for unintentional eye exposure, because a person will normally turn away or blink to avoid the bright light. Do NOT deliberately look into or stare into the beam– this can cause injury to the retina in the back of the eye. Be aware of beam reflections off glass and shiny surfaces. Depending on the surface, the reflected beam could be about as strong and as focused as a direct beam.
Maintenance and Cleaning
- Maintenance and cleaning shall only be done to the product surface. Unplug this product from the power socket before cleaning.
- Do not wet any electric parts of this product. Please use a dry, soft cloth instead of sharp tools for cleaning.
- When not in use, store neatly in a cool, dry location protected from sunlight.
WEEE Directive & Product Disposal
At the end of its serviceable life, this product should not be treated as household or general waste. It should be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Statement
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance of 20cm the radiator your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.