WYNDHAM COLLECTION WC-7171-60-DBL Main Cabinet Owner’s Manual

WYNDHAM COLLECTION WC-7171-60-DBL Main Cabinet

Product Specifications

• Main Cabinet: 1
• Counter & Sink: 1 (may not be included)
• Backsplash: Comes in two pieces
• Tools Required (not included): Silicone sealant, Spirit Level, Phillips Screwdriver, Tape measure, Pencil, Electric Drill

Product Usage Instructions

Installation Precautions

• Before installation, check all received items against the Packing List. Report any missing items to your retailer immediately.
• Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight, and chemical hazards. Professional installation is recommended.

Cabinet Alignment

• All cabinets are aligned and metal trim is adjusted on a level floor before packaging. After shipping and reaching its destination, the cabinet doors and drawers may require minor alignment.
• Do not move/adjust the door hinges or drawer glides before leveling/adjusting the cabinet on the floor.

Installing Backsplash

• Install the counter and seal around the top of the cabinet with clear silicone sealant. Allow it to dry for 24 hours for proper curing.

Handle Installation

• The handles are safely stored for transport inside the cabinet.
• Unpack the handles and install them on the vanity.
• Use short screws for door handles and long screws for drawer handles.
• Ensure not to over-tighten when attaching.

Adjusting Hinges and Drawer Slides

If required, adjust hinges and drawer slides following the instructions provided in the manual. Use the required tools for adjustments.

Frequently Asked Questions

Q: What should I do if I find missing items upon receipt?

A: Report any missing items to your retailer immediately for resolution.

Q: Can I install the product without professional help?

A: While professional installation is recommended, if you have experience with similar installations and follow the provided instructions carefully, you can install it yourself.

INTRODUCTION

• Prior to installation please check received items against the “Packing List”.
• Please report any missing items to your retailer immediately.
• Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight, and chemical hazards.
• Professional installation is recommended.
• The backsplash comes in two pieces.
• Please install it on a level surface. If minor door and drawer alignment is required, please follow the easy directions on the next page.

PACKING LIST

(Not all components may be included, depending upon your purchase)

HOW TO ADJUST HINGES

HOW TO ADJUST HINGES (if required)

REQUIRED TOOLS NOT IN BOX

INSTALLATION INSTRUCTIONS

Scan the QR code with your phone to watch detailed video instructions or visit www.wyndhamcollection.com/alignment

1. CABINET ALIGNMENT GUIDE
   • ALL cabinets are aligned, and the metal trim is adjusted on a level floor before packaging.
   • After shipping and reaching its destination, the cabinet doors and drawers may require minor alignment, depending on the condition of the floor where they will be installed.
   • DO NOT move/adjust the door hinges or drawer glides before leveling/adjusting the cabinet on the floor.
   • Start by adjusting the back two feet #3 and #4 by bringing the cabinet to a level position. Use a spirit level to ensure accuracy. After adjusting all four feet (front and back) check the metal trim alignment.
   • If the metal trim lines are not aligned, start adjusting the middle two feet #5 and #6 (under the cabinet) by moving the adjustable feet UP or DOWN depending on the condition of your floor.
   • After leveling the metal trim lines using the middle feet (under the cabinet) make sure all 6 vanity feet are firmly resting on the floor and the cabinet is perfectly level.
   • By following the above instructions all the metal trim lines should now be aligned. Minor adjustments may be necessary by adjusting the door hinges and drawer glides, see How To Adjust Hinges on page 1, and How To Adjust Drawer Slides on.
2. The backboard is pre-cut for ease of installation for hot and cold valves and drains.
3. Install the counter. Seal around the top of the cabinet with clear silicone sealant. Do not over-apply. Allow to dry for 24 hours for proper curing.
4. The handles are safely stored for transport in a box inside the cabinet. Look inside the vanity for the box with your handles.
5. Unpack the handles and install them on the vanity.
   • Do not over-tighten when attaching.
6. Short screws are for the door handles and long screws are for the drawer handles.

HOW TO ADJUST DRAWER SLIDES

HOW TO ADJUST DRAWER SLIDES (if required)

• Scan the QR code with your phone to watch detailed video instructions or visit www.wyndhamcollection.com/3dslides

Backboard Cutouts

Note: All measurements are ± 1/4”.

References

• wyndhamcollection.com/3dslides
• wyndhamcollection.com/alignment

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>