Teclast 2BGRT-NEOTAB Tablet PC Instruction Manual

Teclast 2BGRT-NEOTAB Tablet PC

Cautions

This user manual has been specially designed to guide you through the functions and features of your device.

1. Please read this manual carefully before using your device to ensure safe and correct use.
2. The descriptions in this manual are based on the default settings of your device.
3. Do not use this unit near water. Do not place over the unit any container with liquid inside.
4. Please do not put your device in high temperature, moisture or dust places. The tablet is not waterproof.
5. Avoid falling or violent collisions. Do not violently shake the touch screen, otherwise, it could lead to damage or display abnormality.
6. lf the system shuts down automatically, it means the battery may used up, and battery charging is required.
7. Please charge the tablet regularly if not in use for a long time to avoid the damage caused by the excessive consumption of the battery.
8. Do not disassemble or use alcohol, thinner or benzene class to swab the product surface.
9. Please do not use the tablet when driving or walking in the street, otherwise, it may lead to an accident.
10. Please choose the appropriate volume, if had tinnitus， please lower the volume or stop using it.
11. Memory space available is nominal, as the android system itself takes up part of the memory space and the operation of the program will also take up space.
12. The storage capacity available is nominal, as the Android system occupies about hundreds of MB of storage capacity. And in order to install the software needs, the system must reserve a certain storage capacity, so the actual usable space is less than nominal space.
13. When the CPU operates in high speed, especially when playing 3D games or High-definition video for a long time, the fuselage will have a fever.
14. Please keep this manual for future reference.
15. The battery is contained with the device, please do not take out the battery.

One Over view

Appearance

1. front camera
2. Volume +/-
3. Power button
4. SD Card Slot
5. Earphone jack
6. Type C Port
7. Speaker
8. MIC
9. Rear Camera

Buttons
Power button
Long press the power button for 2-3 seconds to turn the unit on. When the tablet is in operation, short-press press power button to enter the off-screen state and short-press it again to light up the screen.

Volume
Press Volume+/- to adjust the volume

Power on and off
Power on
Long press the power button for 2-3 seconds, and pictures will show up until the interface.
Power off
Long press the power button, and choose Power Off to shut down.

Open and close standby mode

• Open the standby mode
  When the tablet is in operation, you can press the power button to go to the standby mode which can save power.

• Close the standby mode
  When the tablet is in standby mode, you can press the power button to light up the screen and the unit will back to its normal state.

Lock and unlock the screen
Lock
You can set the sleep time in the system of display.
The system will sleep automatically and lock the screen to standby mode if without any activity when reaches the preset standby time.
Unlock

• Drag to unlock the screen and enter the application interface

Homepage Information Bar

Text Input
When using the tablet, you can use the virtual keyboard to input text, numbers, and symbols directly by touching screen. After selecting the Android input method, the default keyboard shows as below

• To switch the numbers and letters, press
• To switch the capital and lowercase letters, press

Reset
Use a thin object (like the end of a paper clip) to press the reset button in the hole, and then your device will shut down, you need to press the power button to turn on the unit

USB connection

Use the USB cable to connect the tablet to the PC, Click the drop-down bar and you will see, click this sign to connect your device. Turn off USB storage to disconnect your device from the PC

Accessories

Internet

Browser
Require network support before using a web browser, if there are network- supporting problems, please contact your network operator or the service provider. The tablet’s web browser can connect to the Internet via WiFi to satisfy your business and individual
network needs. Please touch (Settings) to set up the WiFi so that you can use the browser normally. Touch (Chrome) in the application list to enter the browser pages.

Input URL : Touch the input area to get the soft keyboard, then input the URL. Touch to show the submenu of the browser, and choose the corresponding one accordingly

Application

File Manager
Touch ( File manager), you can copy files among SD cards, USB and internal memory

System setting

Click (Settings) to enter the system setting interface

Wireless networks setting
Set WiFi ON, the system will scan the available wireless network automatically and display the wireless local area network in the list. If the local area network has the sig,it represents the network has been encrypted, it needs password for connection. While the sign represents the network is unlocked and can be connected directly

Sound setting

• Set the system volume, and the default notification sound, and enable or disable the touch sound and screen lock sound.

• Display setting

• Set the brightness, wallpaper, sleep time, and font size.

• Apps setting

• Display the applications. Choose one application, the relevant information will show up, then you can choose force stop or uninstall. You can also choose to clear the cache, unload program and default value.

• Security setting
  Set the system securities.

• Language & input setting
  Set the default language and input method Set the system securities.

• Language & input setting
  Set the default language and input method

• Date & time setting
  Set date and time manually or set automatic date and time by using network- provided time.

Specification

If at any time in the future you should need to dispose of this product please note that waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive

• Owing to continuous improvement, no prior notice will be given regarding changes to the above feature and spec.
• Google, Android, Google Play, YouTube, and other marks are trademarks of Google LLC

FAQ

• Q : Can I remove the battery from the device?
• A : No, the battery is contained within the device, so please do not attempt to take it out.
• Q: How do I adjust the volume on the tablet?
• A : You can adjust the volume by pressing the Volume +/- buttons located on the device.

FCC Statement

This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Specific Absorption Rate (SAR) information:
This device meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure Information and Statement the SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: This device has also been tested against this SAR limit. This device was tested for typical body-worn operations with the back of the This device kept 0mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 0mm separation distance between the user’s body and the back of the device. The use of belt clips, holsters, and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided.

ISED Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).

This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure and compliance. This equipment complies with Canada’s radiation exposure limits set forth for an uncontrolled environment. The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systemsThis radio transmitter has been approved by Industry Canada to operate with the antenna types listed with the maximum permissible gain indicated. Antenna types not included in this list, having again greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.

Specific Absorption Rate (SAR) information
This device meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. ISED RF Exposure Information and Statementthe The SAR limit of Canada(ISED) is 1.6 W/kg averaging over one gram of tissue. Device types: The device has also been tested against this SAR limit. This device was tested for typical body-worn operations with the back of the phone kept 0mm from the body. To maintain compliance with ISED RF exposure requirements, use accessories that maintain a 0mm separation distance between the user’s body andthe back of the phone. The use of belt clips, holsters, and similar accessories should not contain metallic components in its assembly. The use of accessories that do notsatisfy these requirements may not comply with ISED RF exposure requirements, and should be avoided.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>