Phoenix RX4CX 4 Inch 80 Watt Coaxial Speaker User Manual
- June 3, 2024
- Phoenix
Table of Contents
Coaxial loud Speaker Manual
Models: RX4CX, RX46CX, RX5CX RX57CX, RX65CX, RX69CX
Features:
- LAMINATE-TREATED PAPER CONE – Advanced laminating process produces excellent stiffness to weight ratio, superior damping qualities
- 19mm BALANCED DRIVE MYLAR TWEETER – Excellent reproduction of high frequencies
- POLYMIDE VOICE COIL FORMER – High temperature light-weight voice coil structure for increased sensitivity
- TRIPLE-LAYER UV TREATED FOAM SURROUND – Premium design for excellent sensitivity and long term reliability
- RIGID POWDER COATED STEEL FRAME – Designed for precise motor alignment
BASIC INSTALLATION
Selecting the placement of your new RX Coaxial speakers could be as easy as using the existing factory locations or may require you to create a new location. Speaker placement in the door, dash, or rear deck is the most common. See your local Phoenix Gold Dealer for additional location and mounting assistance.
DOORS /REAR DECK
- Many vehicles already have factory locations (Figure 1) to house the “DROP IN” feature of the RX Coaxial speakers. If no existing locations are available or are not used, check the desired location for adequate cutout area and any depth obstructions. Make sure to allow sufficient clearance for window tracks, structural braces, trunk lid springs, etc.
- Assuming enough area and depth is available, use the provided template and trace the speaker cutout and mounting holes onto the surface of the mounting location.
- If the mounting surface is not structurally strong enough to accommodate screws, (i.e. plastic, cardboard) use the pro vided speed clips which will act as a nut for the supplied screws.
- Always provide water protection, if not supplied in the vehicle. We suggest using a rain shield or equivalent. If in doubt, please contact your Phoenix Gold Dealer.
SPEAKER INSTALLATION WITHOUT GRILL
Phoenix Gold has provided a foam mounting gasket. When installing your new
component speakers in a factory location make sure to use the foam mounting
gasket as shown in figure 1. For reverse mounted speakers place the foam
gasket in front of the speaker. This will ensure an air tight seal for your R
speakers.
For more custom applications, or cases where the factory grill will not be
used, a high excursion protective grill has been provided. When installing
your new component speakers with the provided RX grill use figure 2.
SPECIFICATIONS:
Due to continual product improvement, all specifications subject to change without notice.
| RX4CX| RX46CX| RX5CX| RX57CX| RX65CX| RX69CX
---|---|---|---|---|---|---
RMS Power Handling (watts)| 40W| 40W| 40W| 50W| 50W| 60W
Peak Power Handling (watts)| 80W| BOW| 80W| 100W| 100W| 120W
Impedance (ohms)| 4| 4| 4| 4| 4| 4
Cut Out Dimension (mm) / in.| (93) 3.7| (143 X 88) 5.6 X 3.5| (120) 4.75| (188
X 131) 7.4 X 5.2| (144) 5.7| (221 X 154) 8.7 X 6.1
Mounting Depth (mm) / in.| (50) 2.0| (51.5) 2.1| (55) 2.2| (71) 2.8| (64) 2.5|
(76) 3.0
Coaxial Speaker Owner’s Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>