MEYER CROSS Antho 68Inch Nickel Floor Lamp Instruction Manual
- June 3, 2024
- MEYER CROSS
Table of Contents
MEYER CROSS Antho 68Inch Nickel Floor Lamp
IMPORTANT SAFETY INSTRUCTIONS:
- These instructions are provided for your safety.
Please read carefully and completely before beginning
the assembly and installation of this lighting fixture.
- This lighting fixture is intended for indoor use only.
- Always place lighting fixture on a solid, level surface.
- For use with E26 (medium) base light bulbs only.
- To avoid the risk of fire, do not exceed the maximum wattage of 100W incandescent bulb , or 9W LED bulb , or 23W fluorescent (CFL) bulb , or 9W self-ballasted LED bulb .(Bulbs not included)
- This lighting fixture has a polarized plug (one prong is wider than the other) as a safety feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted.
Do not alter the plug. Do not attempt to bypass this safety feature.
WARNINGS:
- To reduce the risk of fire, electrical shock, or personal injury: always turn off and unplug this lighting fixture and allow it to cool before attempting to replace the light bulb.
- Do not touch light bulb while fixture is turned on.
- Keep flammable materials away from this lighting fixture.
- Never look directly at a lit bulb.
CARE INSTRUCTIONS:
- Unplug lamp before cleaning.
- Wipe clean with a soft, dry cloth or static duster.
- Always avoid the use of harsh chemicals or abrasive cleaners as they may cause damage to the fixture’s finish
PRE-ASSEMBLY:
Carefully remove all parts and hardware from carton, along with any protective plastic packaging. Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or hardware.
- Part G (Lampshade Ring) may come pre-installed to Part E (Top Post). Unscrew Part G before installing Part D (Lampshade), then reinstall Part G to secure.
PARTS INCLUDED:
- (A) Base
- (B) Bottom Post
- (C) Middle Post
- (D) Lampshade
- (E) Top Post
- (F) Adjustment Knob
- (G*) Lampshade Ring
- (H) On/Off Control
For use with light bulbs with a E26 (medium) base.
Pictured with:
- ST19 / ST64 LED
E26 (medium) base (Not included)
DO NOT EXCEED THE SPECIFIED WATTAGE.
BEGIN ASSEMBLY AT THE BASE ON A SOLID, FLAT SURFACE. BE CAREFUL NOT TO
STRIP THREADS. INSTALL LAMPSHADE LAST.
Begin with the Base (A) by placing it upright on a flat, even floor
surface. Attach the Bottom Post (B), taking extra care not to strip the
threads. Tighten firmly by hand.
Attach the Middle Post (C), taking extra care not to
strip the threads. Adjust the height of the Top Post (E). Tighten the
Adjustment Knobs (F) to secure the height position of the Top Post (E).
Unscrew and REMOVE the preinstalled Shade Ring (G) from the Top
Post (E). Turn the Shade Ring (G) and tighten fully to lock the Shade (D) in
place. Carefully install the light bulb after all parts are fully
assembled.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>