RevZilla PB-FILL-23-RB ProBEAM LED Fillerz For Harley Touring Instruction Manual

RevZilla PB-FILL-23-RB ProBEAM LED Fillerz For Harley Touring Instruction Manual

Fitment: 2023-2024 Harley Davidson® CVO Street Glide (FLHXSE), CVO Road Glide (FLTRXSE), 2024 Street Glide (FLHX), Road Glide (FLTRX), and CVO Road Glide ST (FLTRXSTSE)

ATTENTION

Please read all Information below before Installation

Warning: Remove seat and disconnect the negative battery cable from battery; Failure to do so may result in electrical shock, injury or fire. Secure negative battery cable away from positive side of battery and all other positive voltage sources on vehicle.
Safety First: Make sure the bike is parked on a level surface and bike‘s mechanical components are cool to the touch.
Notice: Always wear appropriate safety gear including safety glasses when soldering or performing any electrical work. It is highly recommended that safety glasses be worn throughout this installation process. Read all directions before starting project.

IMPORTANT

CAN Bus Models: This LED product is BCM compliant. However, you must perform a BCM sync.

1. Turn Ignition on, but do not start the bike
2. Turn on 4 way hazards by pressing the hazard button on the controls. Count 10 flashes and deactivate.
3. Turn on 4 way hazards for another 10 flashes and deactivate.
4. Turn Ignition OFF then back ON. Turn on 4 way hazards.
   

Installation

1. Remove the saddle bags to allow access to the fender strut support brackets on the fender.
2. Remove the left and right OEM rear taillights by removing the three flange nuts from the studs on each side of the fender. See Figure 1.
3. 
4. Remove the stud plate from the fender that is held on by 3M tape.
5. Disconnect the OEM JAE connector from the backside of each OEM rear Taillight.

Installation Instructions

6. Clean the surface area of the fender strut support bracket areas with the denatured alcohol and allow to dry.
7. Verify Left and Right Probe AM® Fillers® panels before installing. See Figure 2
8. Remove the red protective film of the 3M tape from the back of Probe AM® Fillers® Line up the bottom edge of Probe AM® Fillers® with bottom edge of bag support bracket. Push ProBEAM® Fillerz® into place until the alignment tabs click. Apply pressure evenly over the Probe AM® Fillers® to ensure the tape is applied evenly. See Figure 2.

Note: The Probe AM® Fillers® are designed to be secured in place by the 3M backing tape on the Fillers® Inserts, not by the alignment tabs (See Figure 2).

9. Connect the male connector on the Probe AM® Eclipse® Module to the female connector on the Probe AM® Fillers®.
   See Figure 3.

10. Connect the 4-position female JAE connector on the Probe AM® Eclipse® Module to the corresponding 4-position JAE on the bike. For the Right side use the connector with the Brown wire. For the Left side use the connector with the Violet wire. See Figure 3.

11. 12. Use the Provided 4” Cable Ties to secure the Probe AM® Eclipse® Module and Probe AM® Fillers® behind each saddlebag.

12. Reinstall negative battery terminal and test running, brake and turn signal functions.

13. Reinstall saddlebags and seat.

Part Number: PB-FILL-23-RB, PB-FILL-23-SB PB-FILL-23-RC, PB-FILL-23-SC US Patent D814673, D824553 & D846,166 China Patent ZL201730501975.7

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>