kanto PDX650 Full Motion TV Wall Mount User Manual
- June 4, 2024
- Kanto
Table of Contents
- Supplied Parts and Hardware
- Project Overview
- Select TV Screws and Spacers
- Select Spacers for Irregular TVs
- Attach TV Brackets
- Hang and Secure TV
- Level TV
- Finalize Adjustments
- Manage Cables
- Limited Warranty to Original Purchaser
- FULL MOTION DUAL STUD MOUNT
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
PDX650 Full Motion TV Wall Mount
User Manual FULL
MOTION TV MOUNT
Supporting your digital lifestyle™
Thank you for choosing Kanto
Read these instructions fully before assembly and installation. If you do not
understand these directions or have any doubts about the safety of the
building, please consult a qualified installation contractor. Make sure there
are no defective or missing parts.
Do not use defective parts. Kanto cannot be liable for property damage or
injury caused by incorrect mounting, incorrect assembly, lifting, or incorrect
use of this product. If there is hardware missing, or if you are uncertain
whether a part is defective, please get in touch with Kanto directly using one
of the methods below.
CAUTION
The maximum loading weight is 125 lb (57 kg). This mount is intended for use
only with the maximum weights indicated.
Use of products heavier than the maximum weights indicated may result in
instability causing possible injury. The wall you plan to affix the Kanto
mount to must be able to support more than 5 times the weight of the
television and the mount combined. Do not use this product for any purpose
other than to mount a VESA-compliant TV on a vertical surface as outlined in
this manual. Improper installation may cause damage to your TV or serious
injury. This product should not be mounted on steel stud walls or cinder block
walls. Do not install this product if you are unsure what kind of wall you may
have or the load it can support. You are advised to consult a qualified
installation contractor before installing this product.
| US & Canada: 1-888-848-2643
UK: +44 800086999
---|---
| support@kantoliving.com
| See the installation video online at:
www.kantomounts.com/resources
Supplied Parts and Hardware
Required Tools
Wood stud wall
Concrete wall
Project Overview
- Select TV Screws and Spacers
- Select Spacers for Irregular TVs
- Attach TV Brackets
- Mount Wall Plate Assembly
- Hang and Secure TV
- Level TV
- Finalize Adjustments
- Manage Cables
IMPORTANT!: Please read this entire document before attempting assembly.
If you have any problems or difficulties while following these instructions,
please contact Kanto directly:
Email: support@kantoliving.com
Toll Free: US & Canada: 1-888-848-2643
| UK: +44 800086999
Select TV Screws and Spacers
|
---|---
1.1 A–G Select Screws
The back of your TV has 4 screw holes in a square or rectangular pattern. This
is where the mount will attach to your TV.
Kanto provides several sizes and lengths of screws. This guide will help you
select the right screws for your TV. You will only use 4 of the provided
screws to attach your TV – the rest are not needed.
1.2 H–J Select Spacers
Plastic spacers are also provided in 3 thicknesses to allow the mount to
work with curved TVs and TVs that have recessed mount holes, protrusions, or
inputs in the way. They can also be used to prevent the TV screws from going
too deep and damaging your TV. You may not need spacers for your TV.
Select Spacers for Irregular TVs
Spacers can be used to provide clearance around protrusions on the back of your TV, or to accommodate a curved TV. You may need to use longer screws.
Attach TV Brackets
WARNING
Do not lay the TV face down on its front. Use a wall or TV stand.
VESA
100 x 100 – 100 x 200
3a.| VESA
200 x 200 – 600 x 400
3b. Pg.8
---|---
3b.
WARNING
Do not lay the TV face down on its front. Use a wall or TV stand.
† Only applicable if using M5 / M6 screw
4a. Mount Wall Plate Assembly (Wood Stud Wall)
Mount height depends on TV size, viewing position, and personal preference.
WARNING
Do not use concrete anchors in drywall or wood stud walls.
CAUTION
Make sure the supporting surface will support the load limits outlined in the
caution on page two. Tighten lag bolts (N) until the wall plate is snug
against the wall.
Do not over-tighten the lag bolts (N). Each lag bolt must be located in the
middle of a wood stud.
4b. Mount Wall Plate Assembly (Concrete Wall)
Mount height depends on TV size, viewing position, and personal preference.
WARNING
Do not use concrete anchors in drywall or wood stud walls.
CAUTION
Make sure the concrete or brick wall is at least 4” thick. Make sure the
anchor is seated completely flush with the concrete surface even if there is
another layer of material, such as drywall. If drywall is over 5/8” thick,
custom lag bolts must be used. Concrete must be a minimum of 2000 psi in
density.
Hang and Secure TV
Level TV
Finalize Adjustments
Manage Cables
Limited Warranty to Original Purchaser
Kanto Living Inc. (Kanto) warrants the equipment it manufactures to be free
from defects in material for the limited warranty period of 5 years.
If equipment fails because of such defects and Kanto is notified within 5
years from the date of shipment with proof of original invoice from an
authorized reseller, Kanto will, at its option, provide replacement parts or
replace the equipment, provided that the equipment has not been subjected to
mechanical, electrical, or other abuse or modifications. Any replacement
parts or replacement units are warranted for 90 days from the day of
reshipment to the original purchaser.
Customers will be responsible for obtaining a Return Authorization Number and
paying shipping costs to return the product to a Kanto location or authorized
depot. If the equipment is covered under the warranty provisions above, Kanto
will replace parts or provide a replacement unit, and be responsible for
shipping costs to the customer. Please keep the original packaging to prevent
damage to the product during shipping. Insuring your shipment is also
recommended.
The information in the manual has been carefully checked and is believed to be
accurate. However, Kanto assumes no responsibility for any inaccuracies that
may be contained in the manual. In no event will Kanto be liable for direct,
indirect, special, incidental, or consequential damages resulting from any
defect in the equipment, even if advised of the possibility of such damages.
This warranty is in lieu of all other warranties expressed or implied,
including without limitation, any implied warranty, including any warranty of
merchantability and fitness for any particular purpose, all of which are
expressly disclaimed.
FULL MOTION DUAL STUD MOUNT
PDX650
References
- Kanto Mounts | Commercial TV Stands & Home TV Mounts
- TV Wall Mount Instructions and Resources | Kanto Mounts
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>