TRAXON ProPoint Kontour Round Mounting Instructions
- July 15, 2024
- traxon
Table of Contents
TRAXON ProPoint Kontour Round Mounting
Specifications
- Kontour Round Narrow Bracket Dimension: 47.4mm / 1.9
- Kontour Round Wide Bracket Dimension: 75mm / 3
- Mounting Bracket Screw driver type: M3 hex driver
- Minimum Bending Radius: 50.4mm / 1.98
- Minimum spacing for thermal expansion: 4mm/0.16
Product Usage Instructions:
Mounting Instructions
To mount the bracket, follow these steps:
- Attach the mounting bracket to the surface using an M3 screw (included).
- Use an M3 hex driver screwdriver for installation.
- For safety, consider using the optional Safety Cable to fixture and Snap-Clip to fixture.
Power/Data Input and Output
Connect the power/data input side to the appropriate source and the
power/data output side to the device you intend to power or communicate with.
Bending and Spacing
Ensure a minimum bending radius of 50.4mm / 1.98 to prevent damage.
Maintain a minimum spacing of 4mm/0.16 for thermal expansion.
Reference Materials
For detailed installation instructions, refer to section 2.3.1 of the
ProPoint Kontour Installation Guide.
FAQ
-
Q: What is the minimum bending radius for the product?
A: The minimum bending radius is 50.4mm / 1.98. -
Q: What screwdriver type is recommended for installation?
A: An M3 hex driver screwdriver is recommended for installation. -
Q: Is the Safety Cable included with the product?
A: The Safety Cable is an optional accessory and may need to be purchased separately.
ProPoint Kontour Round Mounting Guide
| 300mm / 12”| 600mm / 24”| 1200mm / 48”| 2400mm / 96”
---|---|---|---|---
A| 75mm / 3”| N / A| N / A| N / A
B| 300mm / 11.8”| 600mm / 23.6”| 1200mm / 47.2”| 2400mm / 94.5”
C| 100mm / 3.9”| 15mm / 0.6”| 15mm / 0.6”| 15mm / 0.6”
D| 130mm / 5.1”| 250mm / 9.8”| 540mm / 21.3”| 1500mm / 59”
Dimension
Assembly Instruction
- CONNECT TO THE POWER SUPPLY IN ACCORDANCE WITH NATIONAL REGULATIONS.
- IF THE EXTERNAL FLEXIBLE CABLE OF THIS LUMINAIRE IS DAMAGED,
- IT SHALL BE EXCLUSIVELY REPLACED BY THE MANUFACTURER OR A SIMILAR QUALIFIED PERSON IN ORDER TO AVOID ANY HAZARD.
- INSTALLATION/MAINTENANCE ONLY BY SKILLED PERSONNEL.
- DURING OVERHAUL/MAINTENANCE ONLY USE ORIGINAL PARTS.
- IF ANY LUMINAIRE IS SUBSEQUENTLY MODIFIED, THE PERSON RESPONSIBLE FOR THE MODIFICATION SHALL BE CONSIDERED THE MANUFACTURER.
- THE MANUFACTURER BEARS NO LIABILITY FOR DAMAGE CAUSED BY INAPPROPRIATE USE OR APPLICATION.
- THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE; WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE THE WHOLE LUMINAIRE SHALL BE REPLACED.
- THE LUMINAIRE SHOULD BE POSITIONED SO THAT PROLONGED STARING INTO THE LUMINAIRE AT A DISTANCE CLOSER THAN 4M IS NOT EXPECTED.
02023 TRAXON TECHNOLOGIES. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT ®, ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U. PATENTS, JAPAN PATENTS, OTHER PATENTS PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.