TRAXON Allegro Washer AC Installation Guide
- June 1, 2024
- traxon
Table of Contents
- TRAXON Allegro Washer AC Installation Guide
- Accessories Structure
- Spread Lens
- Full Glare Shield Dimension
- Angled Glare Shield Dimension
- Open Glare Shield Dimension
- Allegro Washer AC
- Full Glare Shield Mounting
- Angled Glare Shield Mounting
- Open Glare Shield Mounting
- Read More About This Manual & Download PDF:
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
TRAXON Allegro Washer AC Installation Guide
Accessories Structure
Spread Lens
One side of the spread lens has a smooth surface, the other side has a rough
surface. The smooth side must face the outside.
On the smooth side, it is also printed the angle of the spread lens.
The spread lens has a notch for rotational orientation. The notch is at 0o
(top center). There are two types of notch on the spread lens.
Full Glare Shield Dimension
Angled Glare Shield Dimension
Open Glare Shield Dimension
©2023 TRAXON TECHNOLOGIES . ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE
TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U. PATENTS, JAPAN PATENTS,
OTHER PATENTS PENDING. SPECIFICATIONS ARE
SUBJECT TO CHANGE WITHOUT NOTICE.
Allegro Washer AC
Accessories Mounting Guide
Full Glare Shield Mounting
Angled Glare Shield Mounting
Open Glare Shield Mounting
©2023 TRAXON TECHNOLOGIES . ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE
TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U. PATENTS, JAPAN PATENTS,
OTHER PATENTS PENDING. SPECIFICATIONS ARE
SUBJECT TO CHANGE WITHOUT NOTICE.
CONNECT TO THE POWER SUPPLY IN ACCORDANCE WITH NATIONAL REGULATIONS.
- IF THE EXTERNAL FLEXIBLE CABLE OF THIS LUMINAIRE IS DAMAGED, IT SHALL BE EXCLUSIVELY REPLACED BY THE MANUFACTURER OR A SIMILAR QUALIFIED PERSON IN ORDER TO AVOID ANY HAZARD.
- INSTALLATION/MAINTENANCE ONLY BY SKILLED PERSONNEL.
- DURING OVERHAUL/MAINTENANCE ONLY USE ORIGINAL PARTS.
- IF ANY LUMINAIRE IS SUBSEQUENTLY MODIFIED, THE PERSON RESPONSIBLE FOR THE MODIFICATION SHALL BE CONSIDERED THE MANUFACTURER.
- THE MANUFACTURER BEARS NO LIABILITY FOR DAMAGE CAUSED BY INAPPROPRIATE USE OR APPLICATION.
- THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE; WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE THE WHOLE LUMINAIRE SHALL BE REPLACED.
- THE LUMINAIRE SHOULD BE POSITIONED SO THAT PROLONGED STARING INTO THE LUMINAIRE AT A DISTANCE CLOSER THAN 7M IS NOT EXPECTED.