TRAXON AM321410055 50W AC Allegro Washer Installation Guide
- June 1, 2024
- traxon
Table of Contents
TRAXON AM321410055 50W AC Allegro Washer
Product Information
Specifications
- Power: 50W
- Dimensions: 170mm x 270mm x 203mm
- Weight: Not specified
- Material: Not specified
- Color: Not specified
Product Usage Instructions
Mounting Guide
- Tilt the head slightly to mount the bracket. Only turn enough to unlock.
- Do not unscrew the hex screw from the fixture.
Adjust Position
- Lock/Unlock instructions are visually represented on the product.
Additional Notes
- Use a 6mm Hex Key for tightening torque of 3.5Nm.
- Optional stainless steel safety cable can be used.
- Avoid obstructing vent holes.
FAQ
- Q: Can I install the product vertically?
- A: Avoid vertical placement of connectors, but if unavoidable, follow specific guidelines provided in the manual regarding wire bending radius and silicone glue application.
- Q: What type of connectors are compatible with this product?
- A: Field installable connectors such as XB.AC.3106000 and XB.AC.4006000 for cable OD 6-14mm are recommended. Ensure proper tightening of cable gland after installation.
- Q: What is the recommended torque for tightening screws?
- A: The recommended torque is between 0.8 – 1.0 Nm or 0.6 – 0.7 lb ft.
Dimension
Installation Instructions
Allegro Washer AC 50W Mounting Guide
Applicable to Field Installable Connectors
To properly bend the cable
- Cable must NOT bent below the Minimum Bending Radius (4 x Cable Diameter) as specified by cable manufacturer and the Non-Bendable Length of 5cm near the connector end MUST be adhered to.
- Note the minimum bending radius for conductors > 1.5mm?.
- Pull forces on the contact points can be avoided by bending the wire as required.
Avoid vertical placement of the connectors
If vertical installation is unavoidable:
- Add silicone glue on the surface of the cable gland.
- Layout the cable to have a drip loop to allow water run off the wire.
- XB.AC.3106000 (for cable OD 6-10mm)
- XB.AC.4006000 (for cable OD 10-14mm)
- 3-pin Field Installable AC Female Connector IP66
- XB.AC.2302000
- 5-pin Field Installable AC Male Connector IP66 (for cable OD 10-14mm)
- XB.AC.2303000
- 5-pin Field Installable AC Female Connector IP66 (for cable OD 10-14mm)
- Remember to tighten the cable gland after installation.
- Make sure the cable gland also tightens the cable sheath.
CONNECT TO THE POWER SUPPLY UNDER NATIONAL REGULATIONS
- IF THE EXTERNAL FLEXIBLE CABLE OF THIS LUMINAIRE IS DAMAGED, IT SHALL BE EXCLUSIVELY REPLACED BY THE MANUFACTURER OR A SIMILAR QUALIFIED PERSON IN ORDER TO AVOID ANY HAZARD.
- INSTALLATION/MAINTENANCE ONLY BY SKILLED PERSONNEL.
- DURING OVERHAUL/MAINTENANCE ONLY USE ORIGINAL PARTS.
- IF ANY LUMINAIRE IS SUBSEQUENTLY MODIFIED, THE PERSON RESPONSIBLE FOR THE MODIFICATION SHALL BE CONSIDERED THE MANUFACTURER.
- THE MANUFACTURER BEARS NO LIABILITY FOR DAMAGE CAUSED BY INAPPROPRIATE USE OR APPLICATION.
- THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE; WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE THE WHOLE LUMINAIRE SHALL BE REPLACED.
- THE LUMINAIRE SHOULD BE POSITIONED SO THAT PROLONGED STARING INTO THE LUMINAIRE AT A DISTANCE CLOSER THAN 7M IS NOT EXPECTED.
CONTACT
©2023 TRAXON TECHNOLOGIES. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT ® , ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U. PATENTS, JAPAN PATENTS, OTHER PATENTS PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE. www.traxon-ecue.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>