MONSTERTECH 00670001 VPC Control Panel Mount Instruction Manual
- June 4, 2024
- Monstertech
Table of Contents
VPC CONTROL PANEL MOUNT
Instruction Manual
GENERAL ASSEMBLY INFO AND HOW TO
PROFILE NUT
HEX KEY SET WITH BALL HEAD + EXTENSION OR SIMILAR REQUIRED
UNIVERSAL CONNECTOR
BOLT DIMENSIONS AND HOW TO MEASURE THEM [mm]
PROFILE CAP ASSEMBLY
PARTS FOR TOP / FRONT MOUNT
[dimensions in mm /different scales]
PARTS FOR SIDE MOUNT
CENTER ASSEMBLY
| 
---|---
| 
| 
ALTERNATIVE ASSEMBLY ON FRONT
| 
---|---
ASSEMBLY FOR SIDE MOUNT
A locknut has to be rough-running on a bolt.
Therefore you need to use a wrench and a hex key to tighten it. Hold up the
M8x18 bolt with the hex key while tightening the locknut with the wrench (or
reverse).
It’s perfect to tighten if you still can angle your mounted device but it is
tight enough not to move unintentionally.
| 
---|---
WARNING NOTICES
CAUTION! Do not clamp your fingers while attaching the table mount.
CAUTION! Check before usage if all screws are tightened.
CAUTION! Check before usage that the mounting plate is screwed on tight after
making height adjustments.
DANGER: Contains small parts not suitable for children under 3 years.
Only suitable for children over 12 years and adults.
All MONSTERTECH products are hand assembled and quality checked.
The mount is designed for usage only with a computer controller (f.e. joystick
or throttle).
We exclude liability if the product is used for purposes other than intended.
MONSTERTECH shall be liable for damage arising from causes other than the
detriment to life, body and health only to the extent that such damage arises
from wilful misconduct, gross negligence, or the culpable violation of a
fundamental contractual obligation on the part of MONSTERTECH or a vicarious
agent (e.g. the delivery service) of MONSTERTECH. Any further liability for
damages shall be excluded.
If you have safety concerns or questions regarding assembly, contact us at
i[email protected] or visit
www.mtsim.com/en