MONSTERTECH USA MPS Pilot Seat Belt Harness Holder Instruction Manual
- June 13, 2024
- MONSTERTECH USA
Table of Contents
MONSTERTECH USA MPS Pilot Seat Belt Harness Holder Instruction Manual
PARTS
ASSEMBLY
It is not recommended to use power tools. Please make sure the screws are
running smoothly in the threads. If the screw cannot be screwed in easily,
unscrew it and start again. Do not apply too much pressure when screwing.
If no threaded holes are visible at the top of the backrest, they are under the fabric or leather. In this case you have to make a cut in the fabric or leather. The threaded holes are 120mm from the top edge and are 120mm apart.
Feel the positions with your finger or a pointed object. Make 2 small cross cuts with a sharp knife.
Carefully cut away excess material.
For information:
This is how the threads look in the backrest panel.
Rear side (where you assemble the belt holder)
Front side (where you put your head)
ASSEMBLY OF THE EYE BOLTS FOR YOUR BELT HOOKS
The alignment of the ring bolts after tightening is random (thread length given by engineer standard). To adjust the alignment extra washers can be used. If the ring screw is not tightened, this is not a problem as it cannot turn and loosen further when the belt is hooked.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>