MONSTERTECH VPC Control Panel Mount Instruction Manual
- June 13, 2024
- Monstertech
Table of Contents
MONSTERTECH VPC Control Panel Mount
GENERAL ASSEMBLY INFO AND HOW TO
PROFILE NUT
HEX KEY SET WITH BALL HEAD + EXTENSION OR SIMILAR REQUIRED
UNIVERSAL CONNECTOR
BOLT DIMENSIONS AND HOW TO MEASURE THEM [mm]
PROFILE CAP ASSEMBLY
PARTS FOR CENTER MOUNT
PARTS FOR SIDE MOUNT
CENTER ASSEMBLY
ASSEMBLY FOR SIDE MOUNT
A locknut has to be rough-running on a bolt.
Therefore you need to use a wrench and a hex key to tighten it. Hold up the
M8x18 bolt with the hex key while tighten the locknut with the wrench (or
reverse).
Its perfect tighten if you still can angle your mounted device but it is tight
enough not to move unintentional.
WARNING NOTICES
CAUTION! Do not clamp your fingers while attaching the table mount.
CAUTION! Check before usage if all screws are tightened.
CAUTION! Check before usage that the mounting plate is screwed on tight
after making height adjustments.
DANGER: Contains small parts not suitable for children under 3 years.
Only suitable for children over 12 years and adults.
All MONSTERTECH products are hand assembled and quality checked.
The mount is designed for usage only with a computer controller (f.e. joystick
or throttle).
We exclude liability if the product is used for purposes other than intended.
MONSTERTECH shall be liable for damage arising from causes other than the detriment to life, body and health only to the extent that such damage arises from willful misconduct, gross negligence or the culpable violation of a fundamental contractual obligation on the part of MONSTERTECH or a vicarious agent (e.g. the delivery service) of MONSTERTECH. Any further liability for damages shall be excluded.
If you have safety concerns or questions regarding assembly, contact us under info@mtsim.com or visit www.mtsim.com/en
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>