MaiSto 82860 Series 2.4GHz RC Vehicles User Manual

: July 9, 2024
: Maisto

Table of Contents

Documents / Resources
- References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MaiSto 82860 Series 2.4GHz RC Vehicles User Manual

Please keep this owner’s instruction manual for future reference.
It contains important information.
We reserve the right to improve/revise the product specifications without notice.
Class 1 LED Product

RC Vehicle With Built-in Rechargeable Battery (non replaceable) x 1
Controller x 1
1.5V “AAA” LR03/R03 non-rechargeable Battery (For Controller Use) x 2
USB Cable x 1
Owner’s Instruction Manual x 1

Charging the built-in rechargeable battery for the RC vehicle: (Refer to Diagram 1)

Open the charging port cover on the vehicle.
Make sure the switch is on the OFF/CHARGE position befor charging.
Locate a USB certified port from any of the devices shown below.
Connect the USB charging plug with the USB certified port.
The LED indicator will start lighting in red to show it is charging.
Once the LED indicator turns off, the vehicle is fully charged.
Detach the USB plug from the USB certified port, then install the charging port cover on the vehicle.

Battery installation for the controller: (Refer to Diagram 2)

NOT INCLUDED

Computer

Smartphone Adapter

Switch the power OFF.
Use screwdriver to loosen the screw on the battery cover and to open the battery cover. (Screwdriver is not included)
Install 2 new 1.5V “AAA” LR03/R03 batteries with correct polarity (+/-) as shown inside the battery compartment.
Install the battery cover and then tighten the screw on the battery cover.

How to play: (Refer to Diagram 3, 4 & 5)

Set the “Power Switch” on the controller and vehicle to ON position, the “Power LED” on the vehicle will flash less than 3 seconds then stay on, meaning the automatic frequency matching between the controller and the vehicle is completed.
If the “Power LED” of the vehicle flash more than 3 seconds, switch off both the vehicle and controller, then turn them on again.
Pull the trigger on the transmitter to drive the vehicle forward. Push the trigger on the transmitter to drive the vehicle backward.
The headlights will light up when the vehicle is moving forward.
Turn the transmitter steering wheel to move the vehicle left or right.
If the vehicle does not run in a straight line, adjust the wheel alignment under the chassis.
The “Power LED” on the vehicle will not flash nor stay on if the rechargeable battery has run out power.
Turn the switch of the controller and vehicle to OFF position when not in play.

Performance Tips:

Do not drive the vehicle on grass, sand or go through water.
Do not drive the vehicle in windy or rainy weather.
Do not drive the vehicle into any hard object.
Keep fingers, hair and loose clothing away from the vehicle.
The operating range can be affected by a variety of factors:
a) Weak controller or vehicle batteries.
b) Interference from other items that emit radio frequency signals such as another R/C item on the same frequency, CB radios, cordless phones, high voltage transmitter, etc.
Outdoor usage is recommended in order to get optimal control range.
Remove the package, take out all accessories and assemble the product before giving it to children to play.

Cautions:

The Built-in rechargeable battery must be charged before use.
Do not overcharge the Battery.
Do not charge the Battery if it shows leakage, corrosion, or has loose or exposed wires or other damage.
Do not cover the vehicle with any sort of material while charging.
Do not touch the vehicle when it is hot. Wait until the vehicle cools before recharging.
Do not dispose of the Battery in fire.
Do not dismantle the Battery or USB, and do not cut the Battery or USB cables.
The USB Cable used with the toy shall be regularly examined for damage to the cord, plug, enclosure and other parts, and in the event of such damage, they must not be used until the damage has been repaired.
Rechargeable batteries are to be removed from the toy before being charged (for transmitter).
The Battery will be warm after charging, and hot after use in a Vehicle.
The supply terminals are not to be short-circuited.
Rechargeable batteries are only to be charged by adults or by children at least 8 years old.
Battery change must only be made by adults!
Note that the 1.5V “AAA” Battery is non-rechargeable and is not to be recharged. Only Batteries of the same or equivalent type as recommended are to be used. It will need replacement when transmission is poor. Alkaline AAA batteries are
recommended to be used for the transmitter. Do not mix alkaline,standard or rechargeable batteries. Do not mix old and new batteries or different type of batteries. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions.
Exhausted batteries must be removed from the product.

FCC Label Compliance Statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions :

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Warning : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Disposal of batteries

Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries.
You can hand in your old batteries at public collection points in your area or wherever batteries are sold.

You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:

Pb = Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury

RSS-210 Compliance Statemetent:

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:

This device may not cause interference；
This device must accept any interference, including interference that may cause undesired operation of the device.

Maisto International, Inc.
Fontana, CA 92336, U.S.A.

www.maisto.com
MADE IN CHINA

Documents / Resources

| MaiSto 82860 Series 2.4GHz RC Vehicles [pdf] User Manual
82861RC, PKG82861RC, 82863, 2.4GHz RC Vehicles, 2.4GHz Vehicles, RC Vehicles, Vehicle, 82860 Series 2.4GHz RC Vehicles, 82860 Series RC Vehicles, 2.4GHz RC Vehicles, 82861, 82862, 82863
---|---