YOSE POWER Electric Bike Kits User Manual
- June 6, 2024
- YOSE POWER
Table of Contents
- YOSE POWER Electric Bike Kits
- Safety Regulation
- E-Bike assembling & repair guide
- Tools and Packing Components
- Kits connection diagram
- Remove original front wheel
- Brake disk/Tire installation
- Front wheel installation
- Brake Lever and Throttle installation
- Display installation
- Install the PAS in the left pedal side
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
YOSE POWER Electric Bike Kits
Safety Regulation
Notice of user manual
Important information
E-Bike assembling & repair guide
Tools and Packing Components
| Installation tool | Material |
|---|---|
| Adiustable wrench | Hub motor with wheel |
| Cross screwdriver | Waterproof connection cable (5 in 1) |
| Hex wrench | Controller |
| Puller | PAS Sensor |
| Thumb throttle | Brake lever |
| Front Led Light |
Kits connection diagram
Remove original front wheel
Photo1、2: Take out the original front wheel.
Brake disk/Tire installation
- Photo1: Unscrew the original brake disc and then install it on the motor with the hex wrench (Attention:Please use the screws from the motor to fasten the disc).
- Photo2、3: Remove the original tire and guard ring, install them on the motor wheel(The guard ring can protect the tire).
- Photo4: Install the original tire to the motor hub.
Front wheel installation
Motor screws install and fasten method
- Photo1: Place the washer (with part bulge), shim,and nut in sequence into both sides of the motor axle.
- Photo2-3: Put the front wheel into the front fork, place the washer between the motor and fork,then use the adjustable wrench to fasten the nut.Please note: the motor cable should face down,cover the waterproof plug, waterproof and dustproof.
Brake Lever and Throttle installation
- Put the brake lever to the handle bar and adjust it to a comfortable position,then use the hex wrench to fix it.
- Photo1、2: Pull out the original brake line of bike, then connect the line to the new brake lever.
- Photo3、4: Place throttle on the right side of the bar,find a comfortable position and fasten it with hex wrench.
Display installation
- Put the display on the left handle bar and fix it in a comfortable position.
Please re-set the data of wheel diameter otherwise it will affect the speed showing (default value: 26 inch)
Install the PAS in the left pedal side
Use puller and hex wrench to take off the left crank, then install the pass
sensor(Attention:the pass sensor spline must be matched well with crank spline
), finally install and fasten the left crank.
At last, install the battery and controller in the right position, and connect all connectors, then your e-bike has been done.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>