Maisto 81157 Rock Crawler Xxxl Radio Control Vehicles User Manual

Maisto 81157 Rock Crawler Xxxl Radio Control Vehicles

Maisto – Radio Control Vehicles

Please keep this owner’s instruction manual for future reference

Contents

•  RC Vehicle x 1
•  Controller x 1
•  USB Cable x 1 (Input DC SV 2A Output: DC 6.4V 1A)
•  6.4V Li-ion Rechargeable Battery Pack (For Vehicle Use) x 1
•  1.SV “AA” LR6/R6 non-rechargeable Battery (For Controller Use) x 2
•  Owner’s Instruction Manual x 1\

Charging the rechargeable battery pack fo r the RC vehicle: (Refer to Diagram 1)

1.  Locate a USB certified port from any of the devices shows below. The LED indicator inside the USB Cable will turn green
2.  Connect the 6.4V Li-ion  rechargeable battery pack and the USB Cable connectors, then the LED indicator will tum off to sh ON it is charging
3. Once the LED indicator turns green again, the battery is fully charged. It takes around 1 hour to fully charge the battery. However, even the LED does not turn green, do not charge the battery more than 2 hours.
4.  When charging is completed, detach the connectors from battery pack and USB certified port.

Note: If the LED twinkle slowly, then the USB Cable is not able to work properly. Try to connect the USB Cable to another USB port, if the problem persist, immediately disconnect the battery and the USB Cable
and seek replacement.

Battery installation for the controller: (Refer to Diagram 2)

1.  Use screwdriver to loosen the screw on the battery cover and to open the battery cover. (Screwdriver is not included}.
2.  Open the battery cover.
3.  Install 2 new 1.5V “AA” LR6/R6 battery with correct polarity{+/-) as shown inside the battery compartment.
4. Install the battery cover and then tighten the screw on the battery cover.

Battery installation for the vehicle: (Refer to Diagram 3 & 4) 

1.  Switch the power OFF.
2.  Rotate the battery cover latch aside and open the battery cover.
3.  Install 6.4V Li-ion rechargeable battery into the battery compartment. Connect the rechargeable battery pack to the socket in the battery compartment.
4.  Install the battery cover and turn the latch to lock it in position.
5.  The “Power LED” on the vehicle will not flash nor stay on if the rechargeable battery has run out power.

How to play: (Refer to Diagram 4, 5 & 6) 

1.  Do not drive the vehicle on grass, sand or go through water.
2.  Do not drive the vehicle in windy or rainy weather.
3.  Do not drive the vehicle into any hard object.
4.  Keep fingers, hair and loose clothing away from the vehicle.
5.  Outdoor usage is recommended in order to get optimal control range.
6.  Remove the package, take out all accessories and assemble the product before giving it to children to play.

Cautions

1.  The 6.4V Li-ion battery pack must be charged before use . Use only the battery pack and USB Cable that came with this vehicle.
2.  Do not overcharge the Battery Pack. Do not charge for more than 2 hours except for the initial two charges..
3. Do not charge the Battery Pack if it shows leakage, corrosion, or has loose or exposed wires or other damage.
4.  Do not cover the Battery Pack with any sort of material while charging.
5.  Do not touch the Battery Pack when it is hot. Wait until the Battery Pack cools before installing it in the Vehicle and before recharging.
6.  Do not dispose of the Battery in fire.
7.  Do not dismantle the Battery or USB Cable, and do not cut the Battery or USB Cable.
8.  The Battery Pack will be warm after charging, and hot after use in a Vehicle.
9. The supply terminals are not to be short-circuited.
10. Rechargeable Batteries are to be removed from the toy before being charged.
11.  Rechargeable batteries are only to be charged by adults or by children at least 8 years old.
12.  Battery change must only be made by adults!
13. The USB Cable is not a toy.
14. Use only tM USB Cable to charge the 6.4V Rechargeable Li-Kln battery pack !Mt comes with the product Other types of battery may burst causing injury to persons and damage. Regular1y examine the USB Cabte for any damage to the cord, plug, enclosure and other parts. If any damage is found DO NOT use the USB Cable or Battery Pack until it is replaced. Do not use the USB Cable for any use other than instrL1Cted in this manual.
15. Note that the 1.5\/ ‘AA’ Battery is non-rechargeable arid is not to be recharged. Only Batteries of the same or equivaloot type as recommended are to be used. It will need replacement when the transmission is poor. Alkaline AA batteries are recommended to be used for the transmitter. Im not mix alkaline, standard or rechargeable batteries. Do not mEX okl and oevv batteries or different type of batteries. Be Sllre to insert batteries with correct polarities ar.d always follow the battery manufacturer’s instructions.
16.  Exhausted batteries must be removed from the product.

FCC Label Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions :

1.  This device may not cause harmful interference, and
2.  This device must accept any interference received, including interference that may cause undesired operation. Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause hannful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to l!y to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an ei,.perienced radio/TV technician for help.

Warning : Changes or modifications to this unit not express approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Disposal of batteries
Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries. You can hand in your old batteries at public collection points in your area or wherever batteries are sold.

RSS-210 Compliance Statemetent:

This device contains licence-exempt transmitter(s}/receiver(s} that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1.  This device may not cause interference;
2.  This device must accept any interference, including interference that may cause undesired operation of the device

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>