Maisto TECH 20049RCA RC Rock Hopper Owner’s Manual

June 1, 2024
Maisto TECH

Maisto TECH 20049RCA RC Rock Hopper

Maïsto – Radio Control Vehicles

Warning! Not suitable for children under 36 months.Small parts.Choking hazard.
Please keep this owner’s instruction manual for future reference.
It contains important information.
We reserve the right to improve/revise the product specifications without notice.
This toy is only to be connected to equipment bearing the symbol.
Class 1 LED Product

Contents

  • RC Vehicle With Built-in Rechargeable Battery (non replaceable) × 1
  • Controller x 1
  • 1.5V “AAA” LR03/R03 non-rechargeable Battery (For Controller Use) x 2
  • Owner’s Instruction Manual x 1

INSTRUCTION

Charging the built-in rechargeable battery for the RC vehicle: (Refer to Diagram 1)

  1. Open the compartment cover on the bottom of the vehicle and take out the USB cable.
  2. Make sure the switch is on the OFF/CHARGE position befor charging.
  3. Locate a USB certified port from any of the devices shown here.
  4. Connect the USB charging plug with the USB certified port.
  5. The LED indicator will start lighting in red to show it is charging.
  6. Once the LED indicator turns off, the vehicle is fully charged.
  7. Detach the USB plug from the USB certified port, then put back the USB cable to the compartment and install the cover on the vehicle.

Battery installation for the controller: (Refer to Diagram 2)

  1. Switch the power OFF.
  2. Use screwdriver to loosen the screw on the battery cover and to open the battery cover. (Screwdriver is not included)
  3. Install 2 new 1.5V “AAA” LR03/R03 batteries with correct polarity (+/-) as shown inside the battery compartment.
  4. Install the battery cover and then tighten the screw on the battery cover.

How to play:  (Refer to Diagram 3, 4, 5, 6 & 7)

  1. Set the “Power Switch” on the controller and vehicle to ON position, the “Power LED” on the vehicle will flash less than 3 seconds then stay on, meaning the automatic frequency matching between the controller and the vehicle is completed.
  2. If the “Power LED” of the vehicle flash more than 3 seconds, switch off both the vehicle and controller, then turn them on again.
  3. Push the button on the controller up or down to move the vehicle.
  4. The highly articulated suspension has the ability to crawl and climb over obstacles.
  5. The “Power LED” on the vehicle will not flash nor stay on if the rechargeable battery has run out power.
  6. Turn the switch of the controller and vehicle to OFF position when not in play.

Maisto-TECH-20049RCA-RC-Rock-Hopper-4

Performance Tips:

  1. Do not drive the vehicle on grass, sand or go through water.
  2. Do not drive the vehicle in windy or rainy weather.
  3. Do not drive the vehicle into any hard object.
  4. Keep fingers, hair and loose clothing away from the vehicle.
  5. The operating range can be affected by a variety of factors:
    • Weak controller or vehicle batteries.
    • Interference from other items that emit radio frequency signals such as another R/C item on the same frequency, CB radios, cordless phones, high voltage transmitter, etc.
  6. Outdoor usage is recommended in order to get optimal control range.
  7. Remove the package, take out all accessories and assemble the product before giving it to children to play.

Cautions:

  1. The Built-in rechargeable battery must be charged before use.
  2. Do not overcharge the Battery.
  3. Do not charge the Battery if it shows leakage, corrosion, or has loose or exposed wires or other damage.
  4. Do not cover the vehicle with any sort of material while charging.
  5. Do not touch the vehicle when it is hot. Wait until the vehicle cools before recharging.
  6. Do not dispose of the Battery in fire.
  7. Do not dismantle the Battery or USB, and do not cut the Battery or USB cables.
  8. The USB Cable used with the toy shall be regularly examined for damage to the cord, plug, enclosure and other parts, and in the event of such damage, they must not be used until the damage has been repaired.
  9. Rechargeable batteries are to be removed from the toy before being charged (for transmitter).
  10. The Battery will be warm after charging, and hot after use in a Vehicle.
  11. The supply terminals are not to be short-circuited.
  12. Rechargeable batteries are only to be charged by adults or by children at least 8 years old.
  13. Battery change must only be made by adults!
  14. Note that the 1.5V “AAA” Battery is non-rechargeable and is not to be recharged. Only Batteries of the same or equivalent type as recommended are to be used. It will need replacement when transmission is poor. Alkaline AAA batteries are recommended to be used for the transmitter. Do not mix alkaline,standard or rechargeable batteries. Do not mix old and new batteries or different type of batteries. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions.
  15. Exhausted batteries must be removed from the product.

FCC Label Compliance Statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions :

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Warning : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RSS-210 Compliance Statemetent:
This device contains licence-exempt transmitters)/receivers) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:

  1. This device may not cause interference;
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Environmental notes:

  • The whole product also does not belong to household waste at the end of the product life.
  • You can return it at collection points for the recycling of electronic and electronical instruments
  • The symbol on the item instruction manual, hangtag or packing is showing this clearly.
  • Materials should be recycled according to their respective markings.
  • Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection.
  • Please ask at your local community for the correct collection point.
  • Please retain this sheet and address for future use, as they contain important information.

Disposal of batteries
Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries.
You can hand in your old batteries at public collection points in your area or wherever batteries are sold.
You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:

  • Pb = Battery contains lead
  • Cd = Battery contains cadmium
  • Hg = Battery contains mercury

CE Declaration
Hereby, MAY CHEONG GROUP FRANCE S.A.S., declares that this equipment is in compliance with the essential requirements and other relevant provisions of directive 2014/53/EU.

  • Frequency: 2.4GHz
  • Transmitting frequency band: 2.4-2.4835GHz
  • Max allowed transmitting power: <10mW

The declaration of conformity may be consult at:
MAY CHEONG GROUP FRANCE S.A.S.,

Parc Ariane – Le Vénus, 2 rue Hélène Boucher, 78280 Guyancourt, France.
The full text of the EU declaration of conformity is available at the following internet address: www.maycheonggroup.com.hk/declaration-of- conformity

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals