cecotec Conga Rockstar 8500 Infinity ErgoWet Upright Vacuum Cleaner Instruction Manual
- June 23, 2024
- cecotec
Table of Contents
- SAFETY INSTRUCTIONS
- PARTS AND COMPONENTS
- BEFORE USE
- ASSEMBLY
- OPERATION
- CLEANING AND MAINTENANCE
- TROUBLESHOOTING
- TECHNICAL SPECIFICATIONS
- DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
- TECHNICAL SUPPORT AND WARRANTY
- COPYRIGHT
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
cecotec Conga Rockstar 8500 Infinity ErgoWet Upright Vacuum Cleaner
SAFETY INSTRUCTIONS
Read these instructions thoroughly before using the device. Keep this instruction manual for future reference or new users.
-
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children must not play with the appliance. Cleaning and user maintenance should not be carried out by unsupervised children.
-
This device is designed for domestic use only and is not intended for bars, restaurants, farmhouses, hotels, motels, and offices.
-
The device must only be supplied at a safety extra-low voltage in accordance with the voltage indicated on the device.
-
Inspect the power cable regularly for visible damage, especially the cable, plug, and charger casing. If the power cable is damaged, it must be replaced with a special cable or set to be supplied by the official Cecotec Technical Support Service.
-
WARNING: to recharge the battery, only use the power supply included with the device, with reference CZH036360100EUWH.
-
Non-rechargeable batteries should not be recharged.
-
The supply terminals must not be short-circuited.
-
Batteries may leak under extreme conditions. Do not touch any liquid that leaks from the battery. If the liquid gets into contact with skin, wash immediately with soap and water.
If the liquid gets into the eyes, wash them immediately with clean water for a minimum of 10 minutes and seek medical attention. Wear gloves to handle the battery and dispose of it immediately in accordance with local regulations. -
The mains plug of the power cord must be removed from the base before cleaning or maintenance operations.
-
ATTENTION: use the appliance and its accessories with caution, as is a risk of entrapment by rotating parts of the appliance.
-
WARNING: this tube contains electrical connections. Do not immerse in water for cleaning. Do not use the appliance to vacuum water. The hose should be checked regularly and must not be used if damaged.
-
The appliance can only be used with the supply unit provided with it.
-
Do not try to repair the appliance by yourself. Contact the official Cecotec Technical Support Service for advice.
-
Make sure that the mains voltage matches the voltage stated on the product marking.
-
Do not use any accessory that has not been recommended by Cecotec, as they might cause injuries or damage.
-
Do not place the appliance close to heat sources, flammable substances, or wet surfaces where it could fall, nor allow it to come into contact with water or other liquids. Do not use outdoors.
-
Do not use the appliance to vacuum liquids, lit matches, cigarette ends, hot ash, or on wet surfaces.
-
Do not use on concrete, tarmac, or other rough surfaces.
-
Stop using the appliance if you notice an abnormal sound or sense a temperature higher than usual.
-
Keep the air outlet unblocked to avoid losing suction power.
-
Do not immerse the cable, plug, or any other part of the appliance in water or any other liquid or expose electrical connections to water. Make sure your hands are dry before handling the plug or switching on the appliance
PARTS AND COMPONENTS
Fig. 1
- Ergonomic handle
- On/off trigger
- Dust-tank release button
- Dust tank
- Tube release button
- Ergoflex tube
- Vacuum-head release button
- Vacuum head
- LED display
- Speed button
- Removable battery
- Battery release button
- Main unit
- Ergoflex button
- Accessory for corners
- 2-in-1 accessory
- Charger
- Flexible hose
- Wall bracket
- Accessory for pets
- Water tank
- Cleaning brush
- Jaliscazo brush
- Long brush
Control panel. Fig. 2
- Operating light ring
- Blocked brush indicator light
- Filter failure indicator light
- Blocked tube indicator light
- Auto Mode indicator light
- Battery percentage indicator light
- Power percentage indicator light
- Filter cleaning indicator light
- Mode indicator light
- Speed button (3 levels + AUTO mode)
BEFORE USE
-
This upright vacuum cleaner includes a package designed to protect it during transport.
Take the upright vacuum cleaner out of the box and remove all packaging materials. Keep the original box and other elements in a safe place, as this will help you prevent damage to the upright vacuum cleaner when transporting it in the future. In case the original packaging is disposed of, make sure all packaging materials are recycled accordingly. -
Make sure all parts and components are included and in good conditions. If there is any piece missing or in bad conditions, contact the official Cecotec Technical Support Service immediately.
Box content
- Upright vacuum cleaner
- 2 in 1
- Accessory for corners
- Jaliscazo brush
- Wall bracket
- Accessory for pets
- Extensible tube
- Long brush
- Water tank
ASSEMBLY
Tube installation Fig. 3
- Insert the tube into the main unit until you hear a click.
- To remove the vacuuming tube, press the tube release button
Vacuum head installation Fig. 4
- Insert the vacuum head into the end of the tube until it clicks
- To remove the vacuum head, press the vacuum-head release button.
Installing the battery Fig. 5
- Install the battery into the bottom of the main unit until it clicks into place.
- To remove the battery, press the battery release button.
Charging Fig. 6
Plug the charger into the charging port and then plug the other side of the adapter into the power socket.
Note:
- Charge the battery before using the device for the first time.
- It is recommended to charge the battery fully within the first 3 uses.
- Do not charge the battery for long periods of time, as this may damage it.
During charging
The battery indicator light will flash, and the battery percentage will
increase. Once charging is complete, the indicator light will turn off after 5
seconds.
During use
When the battery charge is less than 10 %, the indicator will flash. Recharge
battery when the appliance is off.
Wall bracket Fig. 7
- Place the wall bracket against the wall and mark the drilling points for later fixing of the bracket. It is recommended that the vacuum head rests on the floor so that the wall bracket does not support the full weight of the vacuum cleaner.
- Drill the holes and fix the wall bracket with the expansion screws, then place the vacuum cleaner.
OPERATION
- You can use this vacuum cleaner in two different manners:
- Handheld vacuum cleaner, attaching the accessories directly to the main body.
- Upright vacuum cleaner, using the suction tube with the accessories assembled.
Using the vacuum cleaner
- Select the accessory according to the cleaning task you want to perform.
- Press the on/off trigger to switch on the appliance. Press it again to stop operation.
- Press the speed button to set the 3 speed levels and the Auto mode. Bear in mind that if the battery percentage is below 20% you will not be able to set speed. This vacuum cleaner features the following modes:
- Low: low speed.
- Medium: medium speed.
- High: high speed.
- Automatic: this mode allows you to adapt the speed automatically depending on the soiling. When activated, the auto mode indicator light lights up.
Accessories
Vacuum head
The vacuum head is suitable for both carpets and hard floors.
Accessory for corners
Use this accessory to clean corners, recesses, edges, and other hard-to-reach
places.
2-in-1 accessory
Use this accessory to clean upholstered surfaces, keyboards, lamps, curtains,
blinds, vents, etc. To switch between the wide side and narrow side, press the
button on the accessory and slide the brush up or down. Fig. 8
Long brush
Use this accessory to reach the most inaccessible places.
Accessory for pets Fig. 9
This accessory allows you to effortlessly brush and cut tangles (depending on the head you use) from your pet’s coat.
- To attach the accessory for pets to the main body, align and fit both until the accessory clicks into place.
- To remove the accessory, press the accessory for pets release button with one hand while holding the main body firmly with the other.
- Press the head release button to remove the head so that the desired head can be fitted. To attach the head, insert the lower tabs and then press the upper part until it clicks into place.
- Press the trigger to release the hair and instantly vacuum it.
Fig. 9 key:
- Head release button
- Trigger
- Accessory for pets release button
Watertank accessory
- With this accessory you will mop and scrub your floor just by attaching it to the vacuum cleaner.
- Do not use cleaning agents. Use clean and room temperature water only. Do not use the vacuum cleaner to vacuum water.
- When the vacuum clener is not going to be used for a long period of time, remove the water tank and empty the remaining water. Do not expose it to direct sunlight or to damp environments.
- When using this product for the first time, make sure the water tank plug is not open.
Mop installation
- Place the mop cloth on the ground with the Velcro facing upwards.
- Align the mop cloth with the Velcro strips on the water tank and attach it without covering the wheels.
Replacing the mop
- Remove the water tank from the vacuum cleaner.
- Use your foot to hold the accessory against the ground and pull the vacuum cleaner upwards until both parts are separated.
- Replace the mop and refill the water tank.
- Install the water tank again, insert the tank in the lower part of the vacuuming brush head, and press until it is fixed.
CLEANING AND MAINTENANCE
- Always turn off and unplug the vacuum cleaner before cleaning or maintenance.
- Use a soft, slightly dampened cloth to clean the surface of the appliance.
- Never immerse the appliance in water or other liquids. Do not allow liquids to enter the appliance.
- Do not use abrasive cleaners or scouring pads to clean the device.
- Do not leave the vacuum cleaner in a place with direct sunlight.
- Do not leave the vacuum cleaner in a wet place after cleaning it.
- After the brush has been used for a long time, bristles might start to tangle with hair and other dirt. Clean the brush to ensure cleaning efficiency.
Cleaning the water tank and the filters
-
Press the dust-tank release button and remove it. Fig. 10
-
Press the dust-tank release button to open the tank cover and empty it. Fig. 11
-
Use the cleaning brush to clean the filter. Fig. 12
-
Hold the dust tank, remove the filter and lift the filter cover to remove the parts inside. Fig. 13
-
Wipe all parts with a slightly damp cloth.
-
After cleaning the filter, press the button on the display for 3 seconds to restart
Motor filter cleaning Fig. 14
- Turn the filter cover counterclockwise to remove it.
- Remove the filter and clean it.
- It is recommended to clean the filter at least every six months.
Cleaning the brush and the vacuum head
-
Press the release tab on the hard floor brush and remove the brush as shown in figure 15.
-
Remove hair and debris around the brush with your fingers or the cleaning brush blade.
-
Wash the brush under running water.
-
Allow the brush to dry completely before reassembly.
-
Replace the brush.
WARNING:
The motorised brush includes electrical connections, do not immerse in water
for cleaning.
Make sure the brush is completely dry before replacing it.
Water tank cleaning
- To clean the water tank, fill it with clean water, shake it, and empty it.
- The mop is washable; therefore, it is suggested to wash it after every use.
- Replace the cloth after 20-30 uses, depending on the use.
TROUBLESHOOTING
Error codes
Error code | Error description |
---|---|
E1 | Battery overvoltage |
E2 | Undervoltage or significant battery voltage difference. |
E3 | Undervoltage, overvoltage or overcurrent of the charger |
E4 | Switch failure, cannot switch on |
E5 | Thermistor failure |
E6 | Main motor disconnected or engine failure |
E8 | Main motor overload |
E9 | Main motor short circuit |
If you notice a problem with the appliance or if it is not working properly, you can carry out a few simple checks before calling the official Cecotec Technical Support Service.
Problem | Solution |
---|---|
The upright vacuum cleaner does not turn on | Before using the appliance, check |
that it is fully charged. Check if the appliance is off.
Check whether the filter is correctly positioned or installed.
Not suctioning/not sufficiently suctioning| Check the inlets for clogging,
unplug them and clean them if necessary.
Make sure that the filter is installed correctly. Empty the dust tank and
clean the filter.
The device does not charge| To charge the battery, use only the supplied
charger. The battery has overheated, recharge the device when it has cooled
down completely.
For any further doubt or question, contact the official Cecotec Technical Support Service.
TECHNICAL SPECIFICATIONS
Product reference: 08444
Product: Conga Rockstar 8500 Infinity ErgoWet Animal
Voltage and frequency: 100-240 V ~, 50-60 Hz
Motor rated power: 650 W
Brush rated power: 30 W
Li-Ion battery 29.6 V 4000 mAh 118.40 Wh
Rated power of charger: 36 V, 1A, 36.0 W
Technical specifications may change without prior notification to improve
product quality.
Made in China | Designed in Spain
DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
This symbol indicates that, according to the applicable regulations, the
appliance and/or batteries must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should dispose
of the batteries/accumulators and take them to a collection point designated
by the local authorities.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help protecting the environment.
TECHNICAL SUPPORT AND WARRANTY
Cecotec shall be liable to the end user or consumer for any lack of conformity
that exists at the time of delivery of the product under the terms,
conditions, and deadlines established by the applicable regulations.
It is recommended that repairs be carried out by qualified personnel.
If at any moment you detect any problem with your product or have any doubt,
do not hesitate to contact the official Cecotec Technical Support Service at
+34 963 210 728.
COPYRIGHT
The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES, S.L. All rights reserved. The contents of this publication may not, in whole or in part, be reproduced, stored in a retrieval system, transmitted, or distributed by any means (electronic, mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC INNOVACIONES, S.L.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>