cecotec Fast and Furious 9040 Absolute Powerful Steam Station Instruction Manual
- October 27, 2023
- cecotec
Table of Contents
cecotec Fast and Furious 9040 Absolute Powerful Steam Station
SAFETY INSTRUCTIONS
Read these instructions thoroughly before using the appliance Keep this
instruction manual for future reference or new users. Make sure that the mains
voltage matches the voltage stated on the rating label of the appliance and
that the wall outlet is grounded. This appliance is designed for domestic use
only. Do not use it for commercial or industrial purposes. This product is a
high-power home appliance. To reduce the possibility of circuit overload,
please do not use high-power appliances or excessive electrical appliances on
the same AC power outlet. Otherwise, there may be a risk of shock. e or
electric Do not operate the appliance ifit has dropped, ifit shows visible
signs of damage, or if it leaks. Do not immerse the cord, plug. or any non-
removable part of the appliance in water or any other liquid, nor expose the
electricalconnections to water. Make sure your hands are drybefore handling
the plug or switching on the appliance. It is recommended to use pure water
with this product, not distilled water. Before using this product, please
check the water tank carefully for the right amount of water. Check the power
cord regularly for visible damage. Ifthe cord isdamaged, it must be replaced
by the o Service of Cecotec in order to avoid any type of danger. Never leave
the appliance unattended when it is connected to the mains. Do not add hot
water to the water tank, otherwise, the water Technical Support tank will be
deformed. Do not add solutions such as cleaning agents to the water tank, and
do not inject perfume, vinegar, starch, descaling agents, or other chemicals
into the water tank. Do not bend the steam hose or block the steam outlet to
avoid accidents caused by high air pressure. When there is water in the water
tank, please keep the whole machine upright. Do not tip or shake the machine
to prevent water from wing out of the machine. Never let the main cord and
steam tubes come into contact with the hot soleplate of the iron. Do not open
the drain valve before the machine is completely cooled. Never remove the
ironing board cover while ironing or immediately after use. Always let the
appliance cool down y before removing the cover. Do not leave the device in
use on clothes or cloth covers for a long time to avoid damage. Do not pull on
the cord to disconnect or move the device. Instead, pull on the plug. Do not
allow the power cord to come into contact with sharp edges or surfaces to
prevent damage to the power cord. When using the various detachable
accessories of the machine, do it in a non-steam mode to avoid being scalded
by hot steam The appliance will reach very high temperatures during and after
use, especially the soleplate. Do not touch it to avoid burns. Unplug the
device from the power supply as soon as you have used it, before cleaning it,
or before leaving it unattended. Do not move the appliance during use. Do not
use the appliance with wet fabrics. Always place and use the appliance on a Do
not cover the device with any cloth or plastic immediately after use. Always
transport the appliance with its components stored
and with the ironing board folded. Make sure transportation is safe. Do not
pull from the power cord to unplug or move the appliance, use the plug
instead. The appliance is not intended to be used by children under the age of
12. It can be used by children over the age of 12, as long as they are given
continuous supervision. This appliance can be used by children aged 12 and
above, and persons with reduced physical, sensory or mental capabilitiess or
lack of experience and knowledge, as long as they have been given supervision
or instruction concerning the use of the appliance in a safe way and
understand the hazards involved. Supervise young children to make sure that
they do not play with the appliance. Close supervision is necessary when the
appliance is being used by or near children.
ARTS AND COMPONENTS
Img.1.
- Hanger
- Light indicator
- Intermittent steam
- Continuous steam
- Steam adjustment
- Power cord
- Water knob
- Outlet valve
- Lack of water
- Descale
- Operation light indicator
- Switch
- Watertank
- Body
- Base
BEFORE USE
Note: Some parts of the steam iron have been slightly greased and as a result, the iron may slightly smoke when switched on for the time. After a short time, this will cease. Take the product out of the box. Make sure all parts and components are included and in good conditions. Ifany visible signs of damage are observed, contact the Technical Support Service immediately. Remove any packaging materials, stickers or protective foil from the soleplate. Clean the soleplate with a soft cloth.
OPERATION
Product installation Hanger support rod installation Take out the support rod
assembly and insert it into the body vertically through the hole of the
support rod into place. frame following the indications on the e. The support
rod will click
Img. 2. Insert it in the direction shown by the arrow and check if it is
in place by pulling it back after clicking into place. Support rod height
adjustment Release the support rod lock, adjust it to the desired height, and
then fasten the support rod k again.
Img. 3 Once the height is adjusted, you may use a hanger to iron sheets,
dresses, or delicate garments comfortably. (Only included in Fast&Furious 9050
X-Treme)
Note: Before use, check whether there are deposits in the water pump
inlet tank of the machine body. If there is any deposit, please remove it; if
the steam hose outlet is blocked, clear it. Water tank Open the water tank by
pulling upward from the handle and adding water. Then place the water tank in
the main unit and cover the water tank handle.
Img. 4. It is recommended to use tap water at room temperature to use the
device. Do not use hot water, vinegar, starch, detergent, additives or other
chemical products. If the water in your zone contains high amounts of scale,
mix demineralized water or distilled water with tap water.
Warning: Do not use distilled, descaled or perfumed water only. How to
use the steam station
Note: Be careful of hot water from the steam outlet of the iron before
use to prevent burns. When using the appliance, pay attention to prevent the
danger caused by steam spray.
Image 5 Steam levels
- Dry clothes
- Fiber
- Silk
- wool
- Cotton
- Linen
Horizontal ironing
Place the clothes horizontally on the ironing board. Connect the device toa
power supply. The device will beep and the lack of water and descalung
indicatorswll ounk dnd turno The operation light indicator will turn on and
then enter standby mode. Press the main switch, the operation light
indicatorwill blink. The device will start preheating. this process will take
2 minutes 30 seconds approximately. During this process, n steam willbe
emitted. Once the device is preheated, the operation light indicatorwill
remain steady. Press the manual steam switch to release steam or press the
automatic steam switch automaticaly releases steam during1 second and then
stops tor 1 second). At this time, the iron knob can be adjusted. There are 6
modes: Dry clothes, chemical e, silk, wool, cotton and linen. Select the
desired one according to the type ot garment to be ironed. Vertical steam
ironing Hang the clothes or garment from the device. Connect the device toa
power supply. The device will beep and the lack of water and descaling
indicators will blink and turn o. The operation light indicatorwill turn on
and then enter standby mode. Press the main switch, the operation light
indicatorvwill blink. The device will start preheating. this process will take
2 minutes 30 seconds approximately. During this process, no steam will be
emitted. Once the device is preheated, the operation light indicator will
remain steady on. For hanging curtains and clothes (coats, suits. jackets,
etc.), use the vertical ironing function. At this time, the iron is lifted and
the steam is sprayed on the clothes Spray back and forth several times to
remove creases.
Warning: The iron will spray hot steam. Never try to use it on clothing
that someone is
wearing. Never use steam on yourself or others. After use After using the
device, turn it o from the main switch and unplug itfrom the power supply. Let
the iron rest on its heel. Wind the power cord around the base and with the
clamp. Allow the machine to cool naturally before storin8
CLEANING AND MAINTENANCE
After using the product for a period of time (the cumulative working time
reaches 10 hours or the continuous use of 10 boxes of water), it must be
cleaned and maintained. To avoid the risk of burns, remove the power plug and
allow the machine to cool down for at least two hours before descaling. Unplug
the power plug when servicing, cleaning, or repairing the product. If there is
any fabric adhered to the soleplate, use a damp cloth with vinegar to wipe off
the soleplate. Do not use abrasive scouring pads, powders or cleaners to clean
the product. Stam generator descaling Residual water in the part where the
water tank is connected to the body must be cleaned up to prevent scale from
building up. During use, after the machine has accumulated 10 hours of working
time or ten times of use, the descaling indicator light will turn on,
reminding the user that descaling is required. Follow the below steps: Turn
the device off and unplug it from the power supply. When the device has cooled
down to room temperature, remove the water tank from the main body and turn
the water valve by hand to drain the remaining water in the machine.
Fig. 6. Mix 15 g of the descaling product (if there is more scale, please
increase the descaling product quantity as appropriate) and 1L of water, pour
it into the machine through the drain valve port, tighten the drain valve and
shake it for 3-5 times. You may also use white vinegar with water in a 1:1
solution. If there is more scale, please increase the amount of vinegar as
appropriate. Pour the mixed liquid into the drain valve hole and tighten the
drain valve so that the amount of mixed liquid does not overflow the machine.
Let the mixture stand at room temperature for 1-2 hours (if there is more
scale, let it sit for longer, but do not exceed 8 hours). Pour the mixed
liquid out of the drain valve. Fill the drain valve port with clear water, and
then pour the water from the drain valve port. Repeatedly inject clean water
until the residual scale and organic acid smell disappear. Rinse well. After
the descaling process is completed, the descaling indicator will blink. Press
and hold the main switch for five seconds to turn off the indicator.
Descaling
Pour the mixed liquid into the water tank to the maximum scale line, turn the
steam adjustment knob to the maximum position, and press the auto steam button
until all the water in the water tank is sprayed out. Then clean the water
tank, fill it with an appropriate amount of clean water, and run it for a
period of time until the sprayed steam has no vinegar smell.
TECHNICAL SPECIFICATIONS
- 05595 Fast&Furious 9040 Absolute
- 05596 Fast&Furious 9050 X-Treme
- 2600 W, 220-240 V~, 50 Hz
- Made in China | Designed in Spain
DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE)that old household electrical appliances must not be disposed of with the normal unsorted municipal waste. Old appliances must be collected separately, in order to optimize the recovery and recycling of the materials they contain and reducing the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation to dispose of the appliance correctly. Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries.
TECHNICAL SUPPORT AND WARRANTY
This product is under warranty for 2 years from the date of purchase, as long as the proof of purchase is submitted, the product is in perfect physical condition, and it has been given proper use, as explained in this instruction manual. th The warranty will not cover the following situations: The product has been used for purposes other than those intended for it, misused, beaten, exposed to moisture, immersed in liquid or corrosive substances, as well as any other fault attributable to the customer. The prepared by persons, not authorized by the o Technical Support Service of Cecotec. Faults deriving from the normal wear and tear of its parts, due to use. The warranty service covers every manufacturing defects of your appliance for 2 years, based on current legislation, except consumable parts. In the event of misuse, the warranty will not apply. If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact Cecotec Technical Support Service at +34 963 210 728
-
Grupo Cecotec Innovaciones S.L.
-
C/ de la Pinadeta s/n, 46930
-
Quart de Poblet, Valencia (Spain)
-
ICO1201021
Documents / Resources
|
cecotec Fast and Furious 9040 Absolute Powerful Steam
Station
[pdf] Instruction Manual
Fast and Furious 9040, Absolute Powerful Steam Station, Fast and Furious 9040
Absolute, Powerful Steam Station, Fast and Furious 9040 Absolute Powerful
Steam Station, Steam Station
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>