cecotec Fast&Furious 8040 Absolute Ironing Station Instruction Manual

cecotec Fast&Furious 8040 Absolute Ironing Station

SAFETY INSTRUCTIONS

• Read these instructions thoroughly before using the appliance. Keep this instruction manual for future reference or new users. Make sure that the mains voltage matches the voltage stated on the rating label of the appliance and that the wall outlet is grounded.
• Do not immerse the cord, plug, or any non-removable part of the appliance in water or any other liquid, nor expose the electrical connections to water. Make sure your hands are dry before handling the plug or switching on the appliance. Check the power cord regularly for visible damage. If the cord is damaged, it must be replaced by the official Technical Support Service of Cecotec in order to avoid any type of danger.
• If the appliance falls accidentally in water, unplug it immediately. Do not reach into the water!
• Do not expose the appliance to atmospheric agents.
• Do not use the iron on very wet fabrics.
• Do not twist, bend, strain, or damage the power cord in any way. Protect it from sharp edges and heat sources. Do not let it touch hot surfaces. Do not let the cord hang over the edge of the surface.
• This appliance is not intended to be operated by means of an external timer or separate remote-control system.
• Turn off and unplug the appliance from the mains supply when not in use and before cleaning it. Pull from the plug, not the cord, to disconnect it from the outlet.
• This appliance is designed to iron textiles. It is designed for domestic use only and, therefore, not suitable for commercial use. Do not use outdoors.
• To protect against burns or injuries to persons, do not iron textiles while being worn on the body.
• Do not use any accessory that has not been recommended by Cecotec, as they might cause injuries or damage.
• Place the appliance on a dry, stable, flat, heat-resistant surface. The temperature of accessible surfaces may be high while in use and could cause burns. Do not touch hot surfaces while in use or immediately after.
• Unplug the appliance immediately if fire or smoke is observed. Do not leave the product unsupervised during operation. Unplug the device after use and when you leave the room where it is installed.
• The appliance must not be plugged in when filling or emptying the water tank.
• The tank cap must not be open when the appliance is switched on.
• The use of tap water is recommended. If the lime content of the tap water is too high, use a mix composed of 50 % of tap water and 50 % of water with low mineral content. Do not use only water with low mineral content.
• Burns can occur when touching hot metal parts, hot water, or steam. Hot water may leak from the iron. Be careful when filling or turning the steam iron upside down.
• To protect against burns or injuries, do not direct steam toward persons or animals when ironing.
• The iron must be used and placed on a stable surface. When placing the iron on its stand, make sure that the surface is stable.
• Keeping the iron at maximum temperature for too long may cause discolouration, which will not affect the performance of the appliance.
• Do not try to repair the device by yourself. Contact the official Technical Support Service of Cecotec for advice.
• Cleaning and maintenance must be carried out according to this instruction manual to make sure the appliance functions properly. Turn off and unplug the appliance before moving and cleaning it.
• Make sure the iron has completely cooled down before storing it.
• Do not leave water inside the machine when the room temperature is 0 ºC or below.
• Never unscrew the cleaning valve when the appliance is connected to the power supply.
• Store the appliance and its instruction manual in a safe and dry place when not in use.
• Cecotec takes no responsibility for any damage caused by misuse of the appliance. Any misuse or non compliance with these instructions renders the warranty and Cecotec’s liability null and void.
• If the cord is damaged, it must be replaced by the official Technical Support Service of Cecotec in order to avoid any type of danger.
• Cleaning and maintenance tasks must not be carried out by children.
• The appliance is not intended to be used by children under the age of 8. It can be used by children over the age of 8, as long as they are given continuous supervision.
• This product can be used by children and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, as long as they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance. Close supervision is necessary when the appliance is being used by or near children. Keep this appliance and its power cord out of reach of children under the age of 8.
  Warning: All our ironing range’s products have undergone quality control tests previous to their commercialisation. These tests consist of filling the water tank in order to check tightness and to ensure correct operating of the device. Once the test has been carried out, the tank is emptied and dried, but there is a slight probability that water could remain inside it.

PARTS AND COMPONENTS

1. Soleplate
2. Temperature light indicator
3. Steam button
4.  Temperature control dial
5. Steam/water hose
6. Power light indicator
7. Power button
8. Steam light indicator
9. Power cord and plug
10. Cable storage space
11. Cleaning valve of the boiler
12. Storage space for the hose
13. Reboiler
14. Water tank

BEFORE USE

• Take the product out of the box.
• Remove packaging material, stickers and labels from the soleplate.
• Inspect all parts of the appliance for visual damage. Unwind the power cord completely and inspect it for damage. Do not use the product if it or its cord have been damaged or are not working properly. In case of damage, contact the official Technical Support Service of Cecotec for advice, repairs or returns.
• Clean the iron’s soleplate with a soft cloth.
• Plug the appliance into an appropriate wall outlet. The plug must have easy access, so that in case of an emergency, it can be easily unplugged.
  Note: You may notice a slight burning smell or smoke when using the appliance for the first time, caused by the excess of lubricants from the manufacturing process. Ensure good ventilation and let the appliance work until no odour or smoke can be noticed.

OPERATION

How to fill the water tank
Make sure the iron is turned off and unplugged from the mains supply before following the below instructions:

• The product may be used with tap water. If the lime content of the tap water is too high, use a mix composed of 50 % of tap water and 50 % of water with low mineral content.
• Remove the water tank from the boiler and fill it with tap water. Do not exceed the MAX mark on its surface.
• Install the water tank back in place. Let the water tank rest on its base and carefully push it until it clicks into place.

Using the iron

• Plug the appliance to the mains supply and press the power button. The power indicator light and the steam indicator light will turn on. That means both the iron and the boiler have started up.
• Select the desired temperature with the temperature control dial according to the international symbols on the label of your clothes.
• Within about 2 minutes, the temperature indicator light will turn off. This means the iron is ready to be used.
• Within about 3 minutes, the steam indicator light will turn off. This means the iron is ready to be operated with steam.

Steam ironing

• When using the iron for the first time, iron a plain cloth first.
• Choose one of the positions of the temperature control dial for steam ironing according to the type of fabric to be ironed. Only positions (··) and (···) can be used when steam ironing.
• Once the steam indicator light and the temperature indicator light turn off, the iron will be ready to be used.
• Press the steam button to release steam whenever necessary. This appliance is also able to generate steam in a vertical position and can therefore be used to iron textiles such as curtains, hanging clothes, etc. If you hear a loud water sound while ironing, there is no water in the water tank. Press the power button to turn the appliance off and fill the water tank. Then, turn the appliance on again and continue ironing normally.
  Warning: Never attempt to open the cleaning valve while the boiler is under pressure.

Dry ironing

• Select the desired temperature with the temperature control dial. Wait until the temperature indicator light turns off before ironing.
• The steam button must not be pressed when dry ironing.

Residual steam release
When you finish ironing, press the power button to turn the appliance off. Then, press the steam button to release the residual steam that remains in the boiler.

Anti-drip function
This system controls the water flow emitted to the soleplate at all times. Below a certain temperature, the anti-drip function cuts off the water flow and prevents the iron from dripping water onto the fabric.
Protection against overheating
The steam station features a safety system that is automatically activated in case of overheating in order to turn the device off. The steam station can take up to 45-60 minutes to completely cool down.

CLEANING AND MAINTENANCE

• Turn off, unplug the appliance from the power supply, empty the water tank (do it after each use) and allow it to cool down completely.
• Use a soft, damp cloth to clean the device’s surface.
• In case fabric is adhered to the soleplate due to heat, use a damp cloth and vinegar to detach it. Do not use abrasive cleaners or scouring pads to clean the product.
• If scale blocks the steam holes, use a toothpick to remove it.
• If the appliance is not going to be used for a long time, pour out the water in the tank and store it.

Soleplate
Starch and other types of residue may be easily removed from the soleplate with a damp cloth. To avoid scratches on its finish, do not use metallic scouring pads to clean the soleplate and never place the iron on a rough surface. If synthetic fabrics are ironed at high temperature, both the fabric and the soleplate of the iron could be damaged. The best way to remove synthetic residue from the soleplate is to heat it up and iron over an old cotton rag.
Warning: Do not use steam iron cleaners in this iron, since they could damage its parts.

Reboiler

• Release the residual steam in the boiler after every use.
• Turn the appliance off, unplug it, and let it cool down.
• Make sure there is no pressure inside the boiler. Then, let the appliance rest on the opposite side to the cleaning valve and open it.
• Fill the boiler with clean water and clean it with a brush. Shake the boiler gently and pour water out. Repeat this process 2-3 times and screw the cleaning valve tightly.
  Warning: Never attempt to open the cleaning valve while the boiler is under pressure.

Storage

• Turn the device off, disconnect it from the power supply and allow it to cool down completely. Place the iron correctly on its stand. Make sure that there are no traces of water under the plate, as these may cause stains.
• There is a special space inside the steam station to store the power cord and the hose. Store the appliance in a dry and cool place.

TECHNICAL SPECIFICATIONS

• Product: Fast&Furious 8040 Absolute
• Product reference: 05535
• 2000-2400 W, 220-240 V~, 50/60 Hz
• Made in China | Designed in Spain

DISPOSAL OF OLD ELECTRICAL APPLIANCES

• The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), specifies that old household electrical appliances must not be disposed of with the normal unsorted municipal waste. Old appliances must be collected separately, in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment.
• The crossed out “wheeled bin” symbol on the product reminds you of your obligation to dispose of the appliance correctly.
• Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries.

TECHNICAL SUPPORT AND WARRANTY

• This product is under warranty for 2 years from the date of purchase, as long as the proof of purchase is submitted, the product is in perfect physical condition, and it has been given proper use, as explained in this instruction manual.
• The warranty will not cover the following situations:
• The product has been used for purposes other than those intended for it, misused, beaten, exposed to moisture, immersed in liquid or corrosive substances, as well as any other fault attributable to the customer.
• The product has been disassembled, modified, or repaired by persons, not authorised by the official Technical Support Service of Cecotec.
• Faults deriving from the normal wear and tear of its parts, due to use.
• The warranty service covers every manufacturing defects of your appliance for 2 years, based on current legislation, except consumable parts. In the event of misuse, the warranty will not apply.
• If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact Cecotec Technical Support Service at +34 963 210 728.

WEB:www.cecotec.es

References

• SmartGroup

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>