SchlageTouch Keyless Touchscreen Lock FE695 User Manual

June 8, 2024
Schlage

SchlageTouch Keyless Touchscreen Lock

Model FE695, Lever

FE695

Prepare for Installation

Tools Needed

  • Phillips screwdriver, #1 and #2 bits
  • Tape Measure
  • Pencil

Optional

  • Flathead Screwdriver
  • Wood Block
  • Hammer

IMPORTANT NOTES

DO NOT use a power drill for installation!

  • Install and test lock with door open to avoid being locked out.

A. Check door dimensions.

See consumer.schlage.com/Service-Support for door preparation instructions if dimensions are different.

dimensions

B. Change faceplate, if necessary.

Choose the drawing that matches your door edge. If the hole has no mortise, change to the circular faceplate.

Change faceplate

Install Lock

1. Install latch.

Make sure latch angle faces door jamb.

Install latch

2. Press levers onto lever posts

Press levers

3. Remove battery cover from the interior thumbturn assembly

Unscrew the cover and lift down and out to remove.

Remove battery

4. Install the touchscreen on the outside of door.

Bar should slide smoothly through hole in latch. If not, check door dimensions.

Install the touchscreen

5. Install the interior lever assembly.

5a Route wire through indicated hole below.

Install the interior

5b Secure interior assembly with screws.

Secure interior

6. Connect wire and battery.

Connect wire and battery

7. Place battery in holder and tuck wires.

Tuck battery and wires behind the tabs.

Place battery

8. Install battery cover.

Angle the cover up to install, then screw the cover in.

Install battery

9. Install strike onto door jamb.

Install strike

10. If needed, switch levers.

switch levers

switch levers b

Test Lock

a. Unlock.

Unlock

Did latch retract and then extend?

Yes. Lock is installed correctly.

No. Latch retracted but did not extend (latch bound). Uninstall the lock, check step 1 , and make sure the latch is facing the right direction.

No. Nothing happened. Make sure the cable is connected in step 6 , then try again.

Basic Programming Functions

Go to schlage.com/faqs-touch for videos, more advanced programming instructions, and more. Register your product at RegisterMySchlage.com.

ADD OR REMOVE USER CODE

ADD OR REMOVE USER CODE

CHANGE THE PROGRAMMING CODE

CHANGE THE PROGRAMMING CODE

Battery Jump

The emergency battery jump start can be used if your battery is dead to unlock your door. Do not remove the battery until you have opened your door.

WARNING: The lock will remain unlocked until you change the battery or manually relock the door from the inside!

Battery Jump

SchlageTouch Keyless Touchscreen Lock FE695 User Manual – Optimized PDF
SchlageTouch Keyless Touchscreen Lock FE695 User Manual – Original PDF

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals