Schlage Control Smart Interconnected Lock FE410F User Manual

June 8, 2024
Schlage

Schlage Control™ Smart Interconnected Lock

with Engage Technology

Model FE410F Installation Instructions

Parts

Warnings and Cautions

Warnings and Cautions

Prepare for Installation

Tools Needed

  • Phillips screwdriver
  • Tape measure

Optional Tools

  • Flathead screwdriver
  • TorxTM driver

Determine the Handing

Determine the handing of your door. Directions for changing lock handing are provided throughout the instructions.

Determine the Handing

Important Notes

Important Notes

Check door dimensions

See consumer.schlage.com/Service-Support for door preparation instructions if dimensions are different.

door dimensions

The firecup cannot be installed on a 1 3/8” (35 mm) thick door, and the lock will not retain the UL rating.

Install the Lock

1. Install the bolt and latch.

Caution: Use provided bolt!

1a Adjust bolt length, if necessary.

Adjust bolt length

1b If desired, change to the square-corner faceplate.

change to the square-corner faceplate

The faceplate for the latch can be changed in the same way.

1c Install the firecup into the lower hole.

DO NOT install the firecup on a 1 3/8” thick door.

1d Install the bolt and the latch into the door.

Install the bolt and the latch

2. Install the top part of the lock.

2a Install the outside deadbolt assembly on the outside of the door.

Install the outside deadbolt

2b Adjust the spindle on the inside assembly, if necessary.

Caution

See Determine the Handing on page 2 to determine the hand of your door.

Adjust the spindle

2c Make sure the cam on the inside assembly is in the correct position.

cam position

2d Install the inside assembly on the inside of the door.

  Bolt must remain retracted!

Install the inside assembly

2e Secure the inside assembly with the two top screws.

  If the screw holes are blocked by the cam, see step 2c.

Secure the inside assembly

3. Install the bottom part of the lock

3a Install the handing plate into the lever assembly.

Caution 1

  See Determine the Handing on page 2 to determine the hand of your door.

Install the handing plate

3b Install the lever assembly on the outside of the door.

Install the lever assembly

  The lever will be installed later.

3c Secure the inside assembly with the two bottom screws.

Secure the inside assembly a

3d Move the handing screw and cam stop to the appropriate position, if necessary.

  See Determine the Handing on page 2 to determine the hand of your door.

Move the handing screw

4. Apply power to the lock

4a Connect the cable to the inside assembly.

Connect the cable to the inside assembly

4b Install the batteries.

Install the batteries

5. Install the inside cover

5a Place the inside cover on the door.

Place the inside cover

5b Secure the inside cover with two screws.

Secure the inside cover with two screws

6. Install the levers

6a Install the lever on the inside of the door.

a Install the lever on the inside

6b Install the lever on the outside of the door.

6b Install the lever on the outside of the door

7. Install the strikes

7a Install the strikes into the frame.

  Install all the parts shown for maximum security.

Install the strikes

8. Test the lock

8a Extend and then retract the bolt using the inside bolt throw.

Extend and then retract the bolt

  Outside bolt throw should spin freely until a valid credential is presented.

8b Extend the bolt using the bolt throw and then rotate the inside lever.

Extend the bolt

8c Rotate the outside lever.

Rotate the outside lever

If the lock did not operate as described, please see Troubleshooting on page 8.

9. Set up the lock

Continue to www.schlage.com to download the Schlage Control Smart Locks User Guide.

Troubleshooting

Most installation problems are related to handing. See Determine the Handing on page 2 to determine the hand of your door.

Troubleshooting

Schlage Control Smart Interconnected Lock FE410F User Manual – Optimized PDF
Schlage Control Smart Interconnected Lock FE410F User Manual – Original PDF

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals