Schlage Control Smart Deadbolt BE467F Installation Manual
- June 8, 2024
- Schlage
Table of Contents
Schlage Control™ Smart Deadbolt
with Engage Technology
Installation Instructions
Model BE467F
Warnings and Cautions
WARNING
Warnings indicate potentially hazardous conditions, which if not avoided or corrected, may cause death or serious injury.
CAUTION
Cautions indicate potentially hazardous conditions, which if not avoided or corrected, may cause minor or moderate injury. Cautions may also warn against unsafe practices.
Caution: Cautions indicate a condition that may cause equipment or property damage only.
Prepare for Installation
Tools Needed
-
* Phillips screwdriver- Tape measure
Optional Tools
-
* Flathead screwdriver- TorxTM driver
Important Notes
WARNING
Install and test lock with door open to avoid being locked in or out!
Caution: Use provided bolt!
DO NOT use a power drill for installation!
Check door dimensions.
See consumer.schlage.com/Service-Support for door preparation instructions if dimensions are different.
Install the Lock
1 Install bolt and strike.
Caution: Use provided bolt!
1a Adjust bolt length, if necessary.
Measure the backset.
If the measurement is 2C\v” (70 mm), extend the bolt.
1b If desired, change to the square-corner faceplate.
1c Install the bolt into the door.
CAUTION
If the bolt does not remain retracted throughout installation, locking and unlocking could be reversed, resulting in an unsecured residence.
1d Install the strike into the frame.
**i** Install all the parts shown for maximum security.
2 Install the outside assembly
CAUTION
If the bolt does not remain retracted throughout installation, locking and unlocking could be reversed, resulting in an unsecured residence.
2a Install the outside assembly on the outside of the door.
3 Install the inside assembly.
CAUTION
If the cam is not in the correct position during installation, locking and unlocking could be reversed, resulting in an unsecured residence.
3a Make sure the cam on the inside assembly is in the correct position.
3b Install the inside assembly on the inside of the door.
**i** Bolt must remain retracted!
3c Secure the inside assembly with two screws.
**i** If the screw holes are blocked by the cam, see step 3a.
3d Connect the cable to the inside assembly.
3e Install the batteries.
3f Install the inside cover.
3g Secure the inside cover with two screws.
4 Test the Lock
4a Extend and then retract the bolt using the inside bolt throw.
**i** Outside bolt throw should spin freely until a valid credential is
presented.
5 Set up the lock.
Continue to www.schlage.com to download the Schlage Control Smart Locks User Guide.
Schlage Control Smart Deadbolt BE467F Installation Manual – Optimized
PDF
Schlage Control Smart Deadbolt BE467F Installation Manual – Original
PDF
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>