AGPTEK TT3 IR Infrared Remote Control Repeater Emitter Extender Adapter User Manual
- June 8, 2024
- AGPTEK
Table of Contents
TT3
IR Infrared Remote Control Repeater Emitter Extender Adapter
Does your entertainment system have wooden doors or would you like to mount
your components in a closet? Put all of your AV gear in a closet or in a
chest, or even in another room, totally out of view, and control it with your
IR remote controls.
Feature:
- High sensitivity Remote control signal receiving a real-time response to fast forward without delay
- CFL friendly This unit can be installed in an area with compact fluorescent lighting and will Work in most lighting environments
- IR Status LED Blue IR LED confirms the signal is being transmitted
- Wide Band IR Wide Band IR receives an infrared signal from many types of remotes
- Compact size With the small size of the connecting block, you can mount it near audio equipment with nearly no visibility
- Low power consumption 12VDC, 30mA max
Compatible:
DVD, IPTV, Fans, Air-conditioner, Satellite Receive Equipment, which’s receiving and transmitting frequency range are available.
Specification:
Package Include:
1 x IR Distribution Block
1 x IR Receiver
4 x IR Emitter
1 x DC 12V Adapter
1 x Operation Manual
Note:
Before bid, please make sure receiving and transmitting frequency range are
compatible. The receive range is about 8 meters, please make sure it’s enough
for your house.
How to Use:
Note: Careful consideration must be taken when placing the IR Receiver near a Plasma Display! Plasma Displays emit IR frequencies during use and may cause interference. Put the IR emitter as far as possible from the plasma display screen. The Connected Remote Control Repeater is shown in the picture below:
-
Take the Mini IR Receiver (up to three) and connect it to the IR Receiver input jacks labeled 1-3 on the IR Connecting Block.
-
Connect the emitters (up to six) to the emitter jacks labeled 1-6 on the IR Connecting Block.
-
Place the emitters on the source equipment.
-
Connect the 12VDC/ 5V USB Power Supply to the power jack on the IR Connecting Block and plug the Power Supply in the wall outlet. The LED will illuminate with a red light letting you know power is connected.
-
When the LED is green, it means that the power has been connected successfully. When an IR signal is received, the IR confirmation red LED will flash.
Keyword: IR Remote Control repeater
http://www.ebay.com/itm/IR-Infrared-Remote-Control-Repeater-Emitter-
Extender-/180478446511?clk_rvr_id=263192499448
AGPTEK TT3 IR Infrared Remote Control Repeater Emitter Extender Adapter User
Manual – Download [optimized]
AGPTEK TT3 IR Infrared Remote Control Repeater Emitter Extender Adapter User
Manual – Download
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>