Bissell 1974 Series Smart Clean Robotic Vacuum User Guide

SMARTCLEANTM Robotic Vacuum

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING YOUR ROBOT VACUUM.
Unplug from outlet when not in use and before conducting maintenance. When using an electrical appliance, basic precautions should always be followed, including the following:

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY:

• Do not use outdoors or on wet surfaces.
• Do not allow to be used as a toy. Close attention is necessary when used by or near children.
• Do not use for any purpose other than described in this User’s Guide. Use only manufacturer’s recommended attachments.
• Do not charge with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, have it repaired at a qualified technician.
• Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
• Do not unplug by pulling on cord. To unplug, grasp the charger, not the cord.
• Do not handle charger, docking station or robot vacuum cleaner with wet hands.
• Do not put any object into openings. Do not use with any opening blocked; keep openings free of dust, lint, hair, and anything that may reduce air flow.
• Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
• Do not use to pick up flammable or combustible materials (lighter fluid, gasoline, kerosene, etc.) or use in areas where they may be present.
• Do not use in an enclosed space filled with vapors given off by oil base paint, paint thinner, some moth proofing substances, flammable dust, or other explosive or toxic vapors.
• Do not use to pick up toxic material (chlorine bleach, ammonia, drain cleaner, etc.).
• Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
• Do not use without filter in place.
• Use only on dry, indoor surfaces.
• Keep appliance on a level surface.
• Do not carry the robot vacuum cleaner while it is running.
• Place the cords from other appliance out of the area to be cleaned.
• Do not operate the vacuum in a room where an infant or child is sleeping.
• Do not operate the vacuum in an area where there are lit candles or fragile objects on the floor to be cleaned.
• Do not operate the vacuum in a room that has lit candles on furniture that the vacuum may accidentally hit or bump into.
• Do not allow children to sit on the vacuum.
• Prevent unintentional starting. Ensure the switch is in the off-position before connecting to battery pack, picking up or carrying the appliance. Do not carry the appliance with your finger on the switch.
• Disconnect the battery pack from the appliance before making any adjustments, changing accessories, or storing appliance. Such preventive safety measures reduce the risk of starting the appliance accidentally.
• Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.
• Use appliances only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.
• When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other small metal objects, that can make a connection from one terminal to another. Shorting the battery terminals together may cause burns or a fire.
• Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns.
• Do not use a battery pack or appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
• Do not expose a battery pack or appliance to fire or excessive temperature. Exposure to fire or temperature above 130 degrees C may cause explosion.
• For use only with battery pack.
• For use only with charger.
• Do not modify or attempt to repair the appliance or the battery pack.

SAVE THESE INSTRUCTIONS

This model is for household use only.

WARNING:

• Plastic film can be dangerous. To avoid danger of suffocation, keep away from children.
• Do not plug in your vacuum cleaner UNTIL you are familiar with all instructions and operating procedures.
• To reduce the risk of electrical shock, turn power switch off and disconnect plug from electrical outlet BEFORE performing maintenance or troubleshooting checks.

Package Contents

1. BISSELL SmartCleanTM Robotic Vacuum
2. Rechargeable
Li-Ion Battery
3. Dust Bin
4. Edge Cleaning
Brushes
5. Programmable
Docking Station
6. Power Adapter
7. Invisible Wall (4 AA batteries not included)
8. Filter

NOTE: Standard accessories may vary by model. To identify what should be included with your purchase, please refer to the “Carton Contents” list located on the carton top flap.

Getting to Know Your Vacuum

1 Contact Points for automatic charging
2 Top Cover (Dust Bin inside)
3 DC Jack
4 Power Switch
5 Control Panel and LED Display
6 Bumper
7 IR Receiver (for remote & docking station)
8 Docking Station with
LED Control Panel
9 Cliff Sensors
10 Front Wheel
11 Edge-Cleaning Brushes
12 Brush Roll
13 Rear Wheels
14 Wheel Cover Plates
15 Battery Cover Plate

Assembly

WARNING: Do not plug in your vacuum until you are familiar with all instructions and operating procedures.

Battery Installation & Removal

** DO NOT REMOVE THE PLASTIC SHRINK SLEEVE FROM THE BATTERY PACK.

To install the battery: First, turn the power switch to the OFF position. Press on the two circles of the battery cover and slide the cover towards you and insert the battery.

Install the battery in the compartment, ensuring the +/- terminals of the battery match the +/- indicators in the battery compartment

Installing & Removing the Side Brush

To install: Push the brush directly onto the holder.
To remove: Hold the brush bristle and pull upward to remove the brush.

Getting Ready to Clean

1. Install the edge cleaning brushes and the battery according to the assembly instructions.
2. Turn the power switch ON and charge the battery directly from power cord for 4-5 hours prior to the first operation.
3. Use the invisible wall to keep the robot from cleaning in areas where obstructions have not been removed.

Note: Initial charge will take 4-5 hours.

Note: The SmartClean robot is shipped with a clear protective film to prevent damage during shipping. To ensure the best user experience, remove clear film before use.

IMPORTANT! Keep SmartClean Away From Hanging Cables and Low To The Ground Tablecloths and Curtains To keep your SmartClean and your home safe, make sure that it cannot get caught on tablecloths, curtains, hanging electric cords, or other cord-like items.
TIP! Tie up wires, curtains and other low-hanging items.

Initial Charging of the Battery: AC/DC Adaptor

Plug the adaptor plug into the port directly next to the power switch first, and then plug the other end in to the wall outlet. Turn the power switch of the robot to the ON position.

For the initial charge, plug the wall adaptor directly into the charging port on the robot vacuum and turn the power ON.

Note: Initial charge will take 4-5 hours.

DISPOSAL OF BATTERY

If your SmartClean robotic vacuum is to be disposed of, the battery should be removed and disposed of properly. For specific disposal instructions of the battery, please contact RBRC (Rechargeable Battery Recycling Corporation) 1-800-822-8837 or visit www.rbrc.com

Recharging the Battery: Docking Station

Make sure the docking station is installed correctly with at least 40 inches to one side, 12 inches to the opposing side and no obstructions in front of the docking station. After the initial charge is complete, plug the wall adaptor directly into the docking station.

To test the auto-charge feature of the dock, turn the switch ON and select “00” with the center button. (See p. 12 for control panel details). The vacuum should back into the dock for recharging if the appropriate spacing was provided for the docking station.

IMPORTANT! To extend SmartClean’s battery life and keep SmartClean cleaning at peak performance:

• Always keep SmartClean charged when not in use.
• For storage off of the Docking Station, remove the battery from SmartClean and store in a cool, dry place.

The Invisible Wall: Assembly & Use

1. To remove the battery cover, hold the invisible wall and press firmly while sliding downward to remove the battery cover.
2. Insert batteries with the +/- terminals facing the directions indicated and replace the battery cover.(AA batteries not included)
3. To turn on the virtual wall slide the switch away from the light towards the (I) symbol. Wait 10 seconds between turning it on or off.
4. Place the invisible wall in the threshold of a room or in front of an area of the room you do not want the robot to clean.

IMPORTANT! Thick carpeting, furniture or other obstructions at the top of stairs may affect the robot’s navigation system. To make sure your robot sees the stairs place an Invisible Wall 6 inches from the edge of the stairs.

SmartClean and Dark or Black Surfaces

NOTE: Be aware that shiny surfaces and dark floors might confuse your robot.

IMPORTANT! SmartClean may not run on certain dark or black colored surfaces. The cliff sensors that recognize an edge or a stair may view this color as an edge and will not clean over it.
TIP! If you encounter this situation, place an Invisible Wall 6 inches from the edge of the stairs to prevent the robot from going over the stairs.

Schedule Cleanings Using Docking Station

Toggle Switch adjusts between 3 settings:

• Set CLOCK
• Set SCHEDULE (auto cleaning)
• Set RUN

• Use the “+” or “-” buttons to set the hour.
  NOTE: The time is set using military time.

• Use the “+” or “-” buttons to set the minute.

• Use the “day” button to set the day.

• Use the “+” or “-” buttons to set the hour.
  NOTE: The schedule is set using military time.

• Use the “+” or “-” buttons to set the minute.

• Use the “day” button to set the correct day. There are five format schedules available for the day setting (see below).

• Slide the switch to the RUN setting.

• If the clock and schedule have been programmed, the CLOCK and SCHEDULE icon will both display lit when the switch is on RUN mode.

Cleaning the Dust Bin

Warning: To reduce the risk of electric shock, turn power switch o and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.

1. Push the top cover to open.
2. Pull up the dust bin handle and take out the dust bin from the cleaner.
3. Open the top cover of dust bin. Unsnap dust bin filter.
4. Empty the dust and dirt from the dust bin.
5. Rinse the dust bin with tap water. It is not necessary to wash every time. Do not machine wash the dust bin.
6. Periodically clean the filter with a soft bristle brush. Do not wash the filter.
7. Once clean, reinstall the filter and close the dust bin lid.
8. Place dust bin back in cleaner and close top cover.

Cleaning the Brush Roll

Note: Clean the brush roll frequently. Most hair and other debris are captured in the dirt bin, but some may get tangled on the brush and may affect cleaning performance.

To clean the brush, follow these steps:

1. Turn off the power.
2. Flip the robot so the bottom is facing up with the battery compartment away from you and set on a flat surface.
3. Grasp the brush roll cover and gently pull upward toward you to remove.
4. Gently take out the brush by placing your fingers on the brush roll and press in and away from the white clip and pull upward to remove.
5. Remove any debris from the brush roll.
6. Re-install the brush roll by inserting the metal tip into the brass cap and gently pressing to retract the spring mechanism
7. To re-install the brush roll cover insert and press gently to click into place.

Cleaning the Intake

After repeated use, dirt and dust can accumulate around the intake of the vacuum and the working efficiency can be reduced.
To ensure the best efficiency and constant airflow, the intake should be cleaned periodically by removing any debris from the intake or brushroll. Before cleaning the intake ensure the robot is not attached to the charging cable or dock, and the power switch is in the OFF position.

Cleaning the Sensors

After repeated use, dirt and dust can accumulate on the sensors of the vacuum and the working efficiency can be reduced.
To ensure the best efficiency, the sensors should be cleaned off periodically by brushing any dirt or debris from them. Before cleaning the sensors, ensure the robot is not attached to the charging cable or dock and the power switch is in the OFF position.

Cleaning the Side Brushes

• After being used for a period of time, the brushes need to be cleaned to work more effectively.
• Turn OFF the power. Place bottom of the cleaner upward on a flat surface. Hold the brush bristle and pull upward to remove the brush.
• The side brushes can be rinsed and if they become crooked, you can soak them in hot water to make them return to the original shape. Place the brushed back in after they have completely dried.

Warranty

If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Care by E-mail or telephone as described below.

Limited One-Year Warranty

Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, upon receipt of the product BISSELL will repair or replace (with new or remanufactured components or products), at BISSELL’s option, free of charge from the date of purchase by the original purchaser, for one year any defective or malfunctioning part.
See information below on “If your BISSELL product should require service”.
This warranty applies to product used for personal, and not commercial or rental service. This warranty does not apply to fans or routine maintenance components such as filters, belts, or brushes. Damage or malfunction caused by negligence, abuse, neglect, unauthorized repair, or any other use not in accordance with the User’s Guide is not covered.

BISSELL IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE ASSOCIATED WITH THE USE OF THIS PRODUCT. BISSELL’S LIABILITY WILL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT.

*EXCEPTIONS AND EXCLUSIONS FROM THE TERMS OF THE LIMITED WARRANTY

THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES EITHER ORAL OR WRITTEN. ANY IMPLIED WARRANTIES WHICH MAY ARISE BY OPERATION OF LAW, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE ONE YEAR DURATION FROM THE DATE OF PURCHASE AS DESCRIBED ABOVE.

NOTE: Please keep your original sales receipt. It provides proof of date of purchase in the event of a warranty claim.

Bissell 1974 Series Smart Clean Robotic Vacuum User Guide – Download [optimized]
Bissell 1974 Series Smart Clean Robotic Vacuum User Guide – Download

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>