Bissell 47R5 Series Auto-Mate Corded Hand Vacuum User’s Guide
- June 8, 2024
- Bissell
Table of Contents
Auto-Mate™
Corded Hand Vacuum
USER’S GUID
47 R5 SERIES
2 Thank You
3 Safety Instructions
4 Product View
4-5 Operations
5 Maintenance and Care
6-7 Troubleshooting
7 Consumer Services
7 Replacement Parts
8 Warranty
Thanks for buying a BISSELL Hand Vac
We’re glad you purchased a BISSELL Auto-Mate corded hand vacuum.
Everything we know about floor care went into the design and construction of
this complete, high-tech home cleaning system.
Your BISSELL hand vacuum is well made, and we back it with a limited one year
warranty. We also stand behind it with a knowledgeable, dedicated Consumer
Services department, so, should you ever have a problem, you’ll receive fast,
considerate assistance.
My great-grandfather invented the floor sweeper in 1876. Today, BISSELL is a global leader in the design, manufacture, and service of high quality homecare products like your BISSELL hand vacuum.
Thanks again, from all of us at BISSELL.
Mark J. Bissell Chairman, President & CEO
Mark J. Bissell
Chairman, President & CEO
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should be observed, including the following:
READ ALL INSTRUCTIONS BEFORE USING YOUR HAND VACUUM.
Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and before conducting maintenance.
WARNING: To reduce the risk of fire, electric shock, or injury:
- Do not modify the polarized plug to fit a non-polarized outlet or extension cord.
- Do not leave hand vacuum cleaner unattended when it is plugged in.
- Unplug from outlet when not in use and before servicing.
- Unplug before attaching the nozzles.
- Do not use outdoors or on wet surfaces.
- Do not allow children to operate vacuum clean- er or use as a toy.
- Close attention is necessary when used by or near children.
- Do not use for any purpose other than described in this user’s guide.
- Use only manufacturer’s recommended attachments.
- Do not use with damaged cord or plug.
- If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, have it repaired at an authorized service center.
- Do not pull or carry by cord, use cord as a han- dle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated sur- faces.
- Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
- Do not handle hand vacuum cleaner or plug with wet hands.
- Do not put any object into openings. Do not use with any opening blocked; keep openings free of dust, lint, hair, and anything that may reduce air flow.
- Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
- Turn off all controls before plugging or unplug- ging vacuum cleaner.
- Use extra care when cleaning stairs.
- Do not pick up flammable materials (lighter fluid, gasoline, kerosene, etc.) or use in the presence of explosive liquids or vapors.
- Do not pick up toxic material (chlorine bleach, ammonia, drain cleaner, etc.).
- Do not use hand vacuum cleaner in an enclosed space filled with vapors given off by oil base paint, paint thinner, some moth proofing substances, flammable dust, or other explosive or toxic vapors.
- Do not pick up hard or sharp objects such as glass, nails, screws, coins, etc.
- Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
- Do not use without filters in place.
- Use only on dry, indoor surfaces.
- Keep appliance on a level surface.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
THIS APPLIANCE HAS A POLARIZED PLUG.
To reduce the risk of electric shock, this appliance has a polarized plug (one
blade is wider than the other).
This plug will fit in a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install a proper outlet. Do not change the plugin
anyway.
This model is for household use only
Product view
HEPA Media Filter Assembly, Flex Hose, Crevice Tool, Wide Mouth Tool, and Hose Adapter Nozzle
Operations
Power switch
The power switch is located on the end of the curved handle.
To turn hand vacuum ON ( I ), press up.
To turn hand vacuum OFF ( 0 ), press down.
Cleaning with flexible rubber contour nozzle
The Auto-Mate comes with the rubber contour nozzle already attached. This
attachment is great for vacuuming up pet hair, grabbing debris from sides and
backs of car seats, and many other uses.
Cleaning with hose attachment and tools
- Turn hand vacuum OFF (O).
- Remove flexible rubber nozzle by pressing down on round nozzle release button.
- Replace with hose adapter nozzle by lining up the bottom of nozzle to the bottom of the dirt container. Pivot upwards to snap into place.
- Make sure the nozzle has snapped securely into place before using.
- Attach the flexible hose to the hose adapter nozzle. Choose the tool appropriate for your cleaning job and attach to the end of the hose.
Emptying the dirt container
Empty the dirt container after each use. A full dirt container may reduce suction or performance of vacuum.
-
Turn hand vacuum OFF (O).
-
Unplug hand vacuum from electrical outlet.
-
Press dirt container release latch down to disconnect dirt container and filter assembly from the unit.
-
Remove filter by grasping tabs on both sides of filter frame and pulling away from the dirt container. For best results, periodically tap filter assembly against trash can to remove dirt that has collected on the screen and filter.
-
Empty dirt into trash can.
-
Replace filter assembly by aligning side labeled “TOP” into top of dirt container.
Grasp filter tabs and press firmly to ensure filter assembly is secure in dirt container.
NOTE: Make sure side of filter assembly labeled “TOP” faces outward when inserting filter assembly into dirt container. -
Reattach dirt container to unit by aligning bottom of dirt container to bottom of unit.
Pivot upwards and snap into place. Use one hand to hold the unit and use the other hand to clip the dirt container securely in place.
ATTENTION: ATTENTION: For best performance, dirt container and filter assembly should be cleaned after every use.
Maintenance and care
Cleaning the filter and screen
1. Turn hand vacuum OFF (O).
2. Unplug hand vacuum from electrical outlet.
3. Press dirt container release latch down to disconnect dirt container and
filter assembly from the unit.
4. Remove filter by grasping tabs on both sides of filter frame and pulling
away from the dirt container.
5a. Separate filter assembly by grasping tabs on both sides of assembly and
pull.
5b. For best results, periodically tap filter and screen against trash can to
remove dirt that has collected on the screen and filter.
6. Reconnect filter and screen by aligning rectangular tab on filter with
insert on screen.
Press together to ensure assembly is secure.
7. See page 5 to reattach dirt container.
NOTE: Dirt container and screen may be rinsed with cold water. Ensure
both are dry before reinserting.
Do not wash or rinse pleated filter.
Storage/Cord wrap system
A wrap is always attached to the cord for quick and easy storage.
- To store the unit, turn hand vacuum OFF (O).
- Unplug hand vacuum from electrical outlet.
- Bundle cord, using wrap that is located on cord, to store.
Nozzle and tools Maintenance
Keep nozzle and tools clean and free of debris by wiping nozzle and tools
clean with damp cloth.
Troubleshooting
Hand vacuum won’t turn on
- Power cord not plugged in
- Blown fuse/tripped breaker in home
Hand Vacuum won’t pick up or low suction Possible causes
- Dirt container not installed properly
- Dirt container is full
- Filter or screen is dirty
- Nozzle or hose is clogged with debris
Remedies
- Check electrical plug
- Check/replace fuse or reset breaker
Remedies
-
Check assembly of dirt container making
sure it is securely in place -
Empty dirt container and reattach
-
See instructions above. Replace filter if needed
-
Remove hose and tool; remove debris
Troubleshooting
Other maintenance or service not included in the manual should be performed by
an authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
For any questions or concerns, please contact BISSELL Consumer Services at
1-800-263-2535.
BISSELL Consumer Services
For information about repairs or replacement parts, or questions about your
warranty,
call:
BISSELL Consumer Services
1-800-263-2535
Monday – Friday 8 a.m. — 10 p.m. ET
Saturday 9 a.m. — 8 p.m. ET
Or write:
BISSELL Homecare, Inc.
PO Box 3606 Grand Rapids MI 49501
ATTN: Consumer Services
Or visit the BISSELL website – www.bissell.ca
When contacting BISSELL, have model number of cleaner available.
Please record your Model Number:
Please record your Purchase Date:
NOTE: Please keep your original sales receipt. It provides proof of purchase date in the event of a warranty claim. See Warranty on page 8 for details.
Replacement parts – BISSELL vacuum
Item | Part No. | Part Name |
---|---|---|
1 | 97D5 | HEPA Media Fiter Assembly |
2 | 203-1454 | Flexible Rubber Contour Nazzle |
3 | 203-1458 | Flex Hose |
4 | 203-1456 | Crevice Tool |
5 | 203-1455 | Wide Mouth Tool |
6 | 200-1457 | Hose Adapter Nozzle |
Warranty – BISSELL Auto-Mate™ Corded Hand Vacuum
If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Services by E-mail, telephone, or regular mail as described below.
Limited One Year Warranty
Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, BISSELL Canada
Corporation will repair or replace (with new or remanufactured components or
products), at BISSELL’s option, free of charge from the date of purchase by
the original purchaser, for one year any defective or malfunctioning part.
See information below on “If your BISSELL product should require service”.
This warranty applies to product used for personal, and not commercial or
rental service. This warranty does not apply to routine maintenance components
such as belts or brushes. Damage or malfunction caused by negligence, abuse,
or use not in accordance with the User’s Guide is not covered.
If your BISSELL product should require service:
Contact BISSELL Consumer Services to locate a BISSELL Authorized Service
Center in your area or visit our website –
www.bissell.ca
NOTE: Please keep your original sales receipt. It provides proof of date
of pur- chase in the event of a warranty claim.
If you need information about repairs or replacement parts, or if you have
questions about your warranty, contact BISSELL Consumer Services.
Website: www.bissell.ca
E-mail: canada.custhelp@bissell.ca
Or Call:
BISSELL Consumer Services
1-800-263-2535
Monday – Friday 8 a.m. – 10 p.m. ET
Saturday 9 a.m. – 8 p.m. ET
Or write:
BISSELL Homecare, Inc.
PO Box 3606 Grand Rapids MI 49501
ATTN: Consumer Services
BISSELL CANADA CORPORATION IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE ASSOCIATED WITH THE USE OF THIS PRODUCT. BISSELL’S LIABILITY WILL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT.
*EXCEPTIONS AND EXCLUSIONS FROM THE TERMS OF THE LIMITED WARRANTY
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES EITHER ORAL OR
WRITTEN. ANY IMPLIED WARRANTIES WHICH MAY ARISE BY OPERATION OF LAW,
INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, ARE LIMITED TO THE ONE YEAR DURATION FROM THE DATE OF
PURCHASE AS DESCRIBED ABOVE.
©2010 BISSELL Homecare, Inc
BISSELL Canada Corporation Mississauga,
Ontario L5N 0B3 All rights reserved.
Printed in China Part
Number 110-4304 Rev 10/10 Visit our website at:
www.bissell.ca
Bissell 47R5 Series Auto-Mate Corded Hand Vacuum User’s Guide – Download
[optimized]
Bissell 47R5 Series Auto-Mate Corded Hand Vacuum User’s Guide –
Download
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>