DJI Phantom 4 PRo User Guide
- June 7, 2024
- DJi
Table of Contents
DJI PHANTOM™ 4 Pro V2.0 Quick Start Guide
v1.2
Phantom 4 Pro V2.0
The DJI PHANTOM™ 4 Pro V2.0 is a smart prosumer flying camera capable of shooting 4K video at 60 fps and at up to 100 Mbps, and capturing 20 megapixel stills. 4 directions of obstacle avoidance allow it to intelligently avoid obstacles during flight. Using TapFly™ and ActiveTrack™ through the DJI GO™ 4 app, you can fly anywhere visible on your screen or track a moving subject smoothly and easily with a simple tap. The camera uses a 1-inch CMOS sensor offering unprecedented clarity, lower noise, and better quality images.
In addition to the above features, improved propulsion system efficiency means aircraft noise is 4dB (60%) lower than on the Phantom 4 Pro V2.0.
- Gimbal and Camera
- Downward Vision System*
- Micro USB Port
- Camera/Linking Status Indicator and Link Button
- Camera Micro SD Card Slot
- Forward Vision System
- Infrared Sensing System*
- Front LEDs
- Motors
- Propellers
- Aircraft Status Indicators
- Antennas
- Rear Vision System
- Intelligent Flight Battery
- Power Button
- Battery Level Indicators
- The Vision and Infrared Sensing Systems are affected by surrounding conditions. Read the Disclaimer and Safety Guidelines and watch the tutorials in the DJI GO 4 app or on the official DJI website to learn more.
http://www.dji.com/phantom-4-pro-v2
Remote Controller
The powerful remote controller of the Phantom 4 Pro V2.0 has a transmission range extending up to 5 mi (8 km)*. It features physical buttons and dials to control exposure, camera tilt, photo capture, and video recording.
Built into the remote controller is DJI’s latest long-range transmission technology OCUSYNC™, which when paired with a compatible mobile device gives you a live HD view from the Phantom’s camera. Dual frequency support makes the HD video downlink more stable.
- Power Button
- Return-to-Home (RTH) Button
- Control Sticks
- Status LED
- Battery Level LEDs
- Power Port
- Mobile Device Holder
- Small Device Positioning Tabs (for mobile phones)
- Antennas
- Handle Bar
- Gimbal Dial
- Camera Settings Dial
- Record Button
- Flight Mode Switch
- Shutter Button
- Intelligent Flight Pause Button
- C1 and C2 Buttons (customizable)
- USB Port
- Micro USB Port
The default flight control is known as Mode 2. The left stick controls the aircraft’s altitude and heading, while the right stick controls its forward, backward, left and right movements. The gimbal dial controls the camera’s tilt.
- The remote controller is able to reach its maximum transmission distance (FCC) in a wide open area with no Electro-Magnetic Interference, and at an altitude of about 400 feet (120 meters).
Using Phantom 4 Pro V2.0
1. Download the DJI GO 4 App
Search for `DJI GO 4′ on the App Store or Google Play, and install the app on your mobile device.
2. Watch the Tutorial Videos
Watch the tutorial videos at www.dji.com or in the DJI GO 4 app.
- DJI GO 4 App DJI GO 4 supports iOS 9.0 (or later) or Android 4.4 (or later).
3. Check the Battery Levels
Press once to check the battery level. Press once, then again and hold to turn on/off.
4. Charge the Batteries
- When charging is complete, the battery level indicators will automatically turn off.
5. Prepare the Remote Controller
6. Prepare for Takeoff
7. Flight
Ready to Go (GPS)
Before taking off, make sure the Aircraft Status Bar in the DJI GO 4 app
indicates Ready to Go (GPS)’ orReady to Go (Vision)’ if flying indoors.
In the DJI GO 4 App:
Auto Takeoff
The aircraft will take off and hover at an altitude of 4 feet (1.2 meters).
Auto Landing
The aircraft will land vertically and stop its motors.
Return-to-Home (RTH)
Bring the aircraft back to the Home Point. Tap again to stop the procedure.
Normal
You are in control of the Phantom, with satellite and Return-to-Home support.
TapFly
Tap on your screen to fly your Phantom in that direction, avoiding obstacles
as it flies.
ActiveTrack
Mark an object on your screen to track it as it moves.
- Watch the tutorial in the DJI GO 4 app or on the official DJI website to learn more.
- Always set an appropriate RTH altitude before takeoff. When the aircraft is returning to the Home Point, you should guide it with the control sticks. Refer to the Disclaimer and Safety Guidelines for more details.
Manual Takeoff
Manual Landing
Left stick down (slowly) until you touch the ground
Hold a few seconds to stop the motors
- Rotating propellers can be dangerous. Do not start the motors when there are people nearby.
- Always keep your hands on the remote controller so long as the motor is still spinning.
- Stop motor mid-flight: Pull the left stick to the bottom inside corner while simultaneously pressing the RTH button. Only stop motors mid-flight in emergency situations when doing so can reduce the risk of damage or injury. Refer to the user manual for details.
It’s important to understand basic flight guidelines, for the safety of both you and those around you. Don’t forget to read the Disclaimer and Safety Guidelines.
Specifications
- Aircraft
Weight (Battery & Propellers Included): 1375 g
Max Ascent Speed: S-mode: 6 m/s; P-mode: 5 m/s
Max Descent Speed: S-mode: 4 m/s; P-mode: 3 m/s
Max Speed: 45 mph (72 kph) (S-mode); 36mph (58 kph) (A-mode); 31 mph (50 kph) (P-mode)
Max Service Ceiling Above Sea Level: 19685 ft (6000 m)
Max Flight Time: Approx. 30 minutes
Operating Temperature: 32° to 104° F ( 0° to 40° C)
GNSS: GPS+GLONASS
Operating Frequency: 2.400 – 2.483 GHz and 5.725 – 5.850 GHz
Transmitter Power (EIRP):
2.4 GHz: ≤26 dBm (FCC); ≤20 dBm (CE); ≤20 dBm (SRRC)
5.8 GHz: ≤26 dBm (FCC); ≤14 dBm (CE); ≤26 dBm (SRRC)
Hover Accuracy Range:
Vertical: ±0.1 m (With Vision Positioning); ±0.5 m (With GPS Positioning)
Horizontal: ±0.3 m (With Vision Positioning); ±1.5 m (With GPS Positioning)
- Gimbal
Controllable Range: Pitch: -90° to +30°
- Vision System
Velocity Range: ≤31 mph (50 kph) at 6.6 ft (2 m) above ground
Altitude Range: 0 – 33 ft (0 – 10 m)
Operating Range: 0 – 33 ft (0 – 10 m)
Obstacle Sensory Range: 2 – 98 ft (0.7 – 30 m)
Operating Environment: Surfaces with clear patterns and adequate lighting (> 15 lux)
- Infrared Sensing System
Obstacle Sensory Range: 0.6 – 23 ft (0.2 – 7 m)
Operating Environment: Surface with diffuse reflection material, and reflectivity > 8% (such as wall, trees, humans, etc.)
- Camera
Sensor: 1’’ CMOS; Effective pixels: 20M
Lens: FOV (Field of View) 84°, 8.8 mm (35 mm format equivalent: 24 mm), f/2.8 – f/11, auto focus at 1 m – ∞
ISO Range: Video: 100 – 3200 (Auto); 100 – 6400 (Manual); Photo: 100 – 3200 (Auto); 100 – 12800 (Manual)
Mechanical Shutter: 8 – 1/2000 s
Electronic Shutter: 8 – 1/8000 s
Max Image Size: 3:2 Aspect Ratio: 5472×3648; 4:3 Aspect Ratio: 4864×3648; 16:9 Aspect Ratio: 5472×3078
Still Photography Modes:
Single Shot
Burst Shooting: 3/5/7/10/14 frames
Auto Exposure Bracketing (AEB): 3/5 bracketed frames at 0.7EV Bias
Interval: 2/3/5/7/10/15/30/60 s
Video Recording Modes:
H.265
- C4K: 4096×2160 24/25/30p
- 4K: 3840×2160 24/25/30p
- 2.7K: 2720×1530 24/25/3 0/48/50/60p
- FHD: 1920×1080 24/25/30/48/50/60/120p
- HD: 1280×720 24/25/30/48/50/60/120p
H.264
- C4K: 4096×2160 24/25/30/48/50/60p
- 4K: 3840×2160 24/25/30/48/50/60p
- 2.7K: 2720×1530 24/25/30/48/50/60p
- FHD: 1920×1080 24/25/30/48/50/60/120p
- HD: 1280×720 24/25/30/48/50/60/120p
Video Storage Bitrate: 100 Mbps
Supported File Systems: FAT32 (≤ 32 GB); exFAT (> 32 GB)
Photo: JPEG, RAW (DNG), JPEG + RAW
Video: MP4/MOV (AVC/H.264; HEVC/H.265)
Supported SD Cards: Micro SD, Max Capacity: 128 GB. Class 10 or UHS-1 rating required
Operating Temperature: 32° to 104° F (0° to 40° C)
- Remote Controller
Operating Frequency: 2.400 – 2.483 GHz and 5.725 – 5.850GHz
Max Transmission Distance (Unobstructed, free of interference):
2.4 GHz: 5 mi (8 km, FCC); 3.1 mi (5 km, CE); 3.1 mi (5 km, SRRC)
5.8 GHz: 5 mi (8 km, FCC); 3.1 mi (5 km, CE); 3.1 mi (5 km, SRRC)
Operating Temperature: 32° – 104° F (0° – 40° C)
Battery: 6000 mAh LiPo 2S
Transmitter Power (EIRP):
2.4 GHz: ≤26 dBm (FCC); ≤20 dBm (CE); ≤20 dBm (SRRC)
5.8 GHz: ≤26 dBm (FCC); ≤14 dBm (CE); ≤20 dBm (SRRC)
Operating Voltage: 1.2 A @ 7.4 V
- Charger
Voltage: 17.4 V
Rated Power: 100 W
- Intelligent Flight Battery (PH4-5870mAh-15.2V)
Capacity: 5870 mAh
Voltage: 15.2 V
Battery Type: LiPo 4S
Energy: 89.2 Wh
Net Weight: 468 g
Charging Temperature Range: 41° to 104° F (5° to 40° C)
Max Charging Power: 100 W
For more information, read the User Manual:
http://www.dji.com/phantom-4-pro-v2
This content is subject to change without prior notice.
PHANTOM is a trademark of DJI.
Copyright © 2019 DJI All Rights Reserved.
Printed in China.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>