dji MT4MFVD Aircraft Drone Camera User Guide

: May 15, 2024
: DJi

Table of Contents

Download the DJI Fly App and Watch the Video Tutorials
Preparing the Aircraft
Preparing the Remote Controller
Ready to Fly
Specifications
Compliance Info
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Aircraft

Horizontal Omnidirectional Vision System
Gimbal and Camera
Downward Vision System
Infrared Sensing System
Auxiliary Bottom Light
Battery Buckles
Frame Arms
Aircraft Status Indicator
Motors
Landing Gear (Built-in antennas)
Propellers
Battery Level LEDs
Power Button
USB-C Port
microSD Card Slot
Intelligent Flight Battery

Remote Controller RC151

Power Button
Flight Mode Switch
Flight Pause/RTH Button
Control Sticks
Customizable Button
Mobile Device Holder
Antennas
Remote Controller Cable
Photo/Video Toggle
Control Sticks Storage Slot
USB-C Port
Battery Level LEDs
Gimbal Dial
Shutter/Record Button
Mobile Device Slot

Download the DJI Fly App and Watch the Video Tutorials

DJI Fly App

Charging to Activate

Checking the Battery Level and Powering On/Off

Press once to check the battery level.
Press, then press and hold to turn on/off.

Preparing the Aircraft

Preparing the Remote Controller

Ready to Fly

Power on the remote controller and the aircraft, and run the DJI Fly app.
Ready to Fly

Specifications

Aircraft (Model: MT4MFVD, MT4MFVDB)

Operating Temperature| -10° to 40° C (14° to 104° F)
Operating Frequency| 2.400-2.4835 GHz, 5.150-5.250 GHz, 5.725-5.850 GHz
Remote Controller (Model: RC151)
Operating Temperature| -10° to 40° C (14° to 104° F)
Operating Frequency| 2.4000-2.4835 GHz, 5.150-5.250 GHz, 5.725-5.850 GHz
Intelligent Flight Battery (Model: BWX140-2590-7.32)
Charging Temperature| 5° to 40° C (41° to 104° F)
Capacity| 2590 mash
Max Charging Power| 37 W
Standard Voltage| 7.32 V
Intelligent Flight Battery Plus (Model: BWX162-3850-7.38)
Charging Temperature| 5° to 40° C (41° to 104° F)
Capacity| 3850 mAh
Max Charging Power| 58 W
Standard Voltage| 7.38 V

Compliance Info

CC Compliance Notice

Supplier’s Declaration of Conformity
Product name : DJI MINI 4 PRO
Model Number : MT4MFVD
Responsible Party : DJI Technology, Inc.
Responsible Party Address : 201 S. Victory Blvd., Burbank, CA 91502
Website : www.dji.com

We, DJI Technology, Inc., being the responsible party, declares that the above mentioned model was tested to demonstrate complying with all applicable FCC rules and regulations.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information

The aircraft complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm during normal operation. This transmitter must not be co- located or operating in conjunction with any other antenna or transmitter.

This remote controller complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves

established by the Federal Communications Commission (USA). These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body.

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled
environment. End user must follow the specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the ISED.

These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body.

EU Compliance Statement: SZ DJI TECHNOLOGY CO., LTD. hereby declares that this device (DJI MINI 4 PRO) is in compliance with the essential requirements and other relevant provisions of the Directive 2014/53/EU.
A copy of the EU Declaration of Conformity is available online at www.dji.com /euro-compliance
EU contact address: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany

GB Compliance Statement : SZ DJI TECHNOLOGY CO., LTD. hereby declares that this device (DJI MINI 4 PRO) is in compliance with the essential requirements and other relevant provisions of Radio Equipment Regulations 2017.

A copy of the GB Declaration of Conformity is available online at www.dji.com /euro-compliance

Environmentally friendly disposal
Old electrical appliances must not be disposed of together with the residual waste, but have to
be disposed of separately. The disposal at the communal collecting point via private persons is for
free. The owner of old appliances is responsible to bring the appliances to these collecting points
or to similar collection points. With this little personal effort, you contribute to recycle valuable
raw materials and the treatment of toxic substances

зхвърляне с оглед опазване на околната среда
Старите електрически уреди не трябва да се изхвърлят заедно с битовите отпадъци, а отделно. Изхвърлянето в общинския пункт за събиране на отпадъци от частни лица е безплатно. Собственикът на старите уреди е отговорен за пренасянето на уредите до тези или до подобни събирателни пунктове. С това малко собствено усилие допринасяте за рециклирането на ценни суровини и за обработката на токсични вещества.

Απόρριψη φιλική προς το περιβάλλον
Οι παλιές ηλεκτρικές συσκευές δεν πρέπει να απορρίπτονται μαζί με τα υπολειμματικά απόβλητα, αλλά ξεχωριστά. Η απόρριψη στο δημοτικό σημείο συλλογής μέσω ιδιωτών γίνεται χωρίς χρέωση. Ο κάτοχος παλιών συσκευών είναι υπεύθυνος για τη μεταφορά των συσκευών σε αυτά ή παρόμοια σημεία συλλογής. Μέσω της ατομικής σας προσπάθειας, συμβάλλετε στην ανακύκλωση πολύτιμων πρώτων υλών και την επεξεργασία των τοξικών ουσιών.