baby trend TS44XXXC EZ Ride Stroller Travel System Instruction Manual

baby trend TS44XXXC EZ Ride Stroller Travel System

WARRANTY

DO NOT RETURN YOUR PRODUCT TO THE STORE. PLEASE CONTACT BABY TREND® FOR REPLACEMENT PARTS, SERVICE, AND REPAIR. The Baby Trend® warranty covers workmanship defects within 1 year of purchase. Any product that has been subjected to misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental exposure, alteration or accident, or has had its serial number altered or removed invalidates all claims against the manufacturer. Any damage to property during installation is the sole responsibility of the end user. Customer Service Department can be contacted at 1 800-328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required before returning product(s) to Baby Trend®. Please visit http://babytrend.com/pages/limited-warranty for complete warranty details.

• Read all instructions BEFORE assembly and USE of the product. KEEP INSTRUCTIONS FOR FUTURE USE.

Baby Trend, Inc. 13048 Valley Blvd. Fontana CA 92335

• 1-800-328-7363
• (8:00 am ~ 4:30 pm PST)
• www.babytrend.com
• WARNING: Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference.
• WARNING: Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out, always use the safety harness, and insure that the children are properly positioned according to these instructions.
• WARNING: Never leave children unattended.
• WARNING: Care must be taken when folding and unfolding the stroller to prevent finger entrapment.
• CAUTION: This stroller is designed for one child only. Use with more than one child may cause an unbalanced condition which can injure/ harm your child.
• Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause a hazardous, unstable condition.
• The maximum weight that can be carried in the storage basket is 5 lb (2.27 kg). The maximum weight that can be carried in the Parent Tray and Child Tray is 3 lb (1.36 kg) each. Excessive weight may cause a hazardous unstable condition to exist.
• Be certain the stroller is completely opened and locked in place before allowing a child near the stroller.
• The maximum weight capacity of this stroller is up to 50 pounds (22.62 kg) or 40 inches (101.6 cm), additional weight will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition to exist.
• NEVER use the stroller on stairways or escalators.
• NEVER use the stroller with roller skates, in-line skates, skateboards, or bicycles.
• NEVER allow your stroller to be used as a toy.
• To clean use only mild household soap or detergent and warm water on a sponge or clean cloth.
• Check your stroller for loose screws, worn parts, torn material, or stitching regularly. Replace or repair parts as needed.
• Discontinue the use of the stroller should it malfunction or become damaged. Please contact our customer service department to arrange for repair or obtain replacement parts.

PARTS

• Check that you have all the parts for this model before assembling the stroller.

• Please refer to the manual located under the car seat for base type and instructions.

ASSEMBLY MONTAJE ASSEMBLAGE

• IMPORTANT! To ensure safe operation of your stroller, please follow these instructions carefully. Please keep these instructions for future reference.
• IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. NEVER use if any parts are missing or broken.
• IMPORTANT! Adult assembly is required.
  • The front wheels, rear wheels, child tray, and parent tray MUST be installed prior to use.

FRONT WHEELS

1. Release the fold latch by pulling it outward (Fig. 1a).
2. Unfold stroller frame by pulling backward on the stroller handle (Fig. 1b).
3. To attach the front wheels, lean the stroller back so that it rests on the handle with the front and rear legs pointing upward. Position the front wheels over the front leg tubes so that the hole in the housing lines up and will slide onto the legs (Fig. 1c). Firmly push down until the wheels lock securely into place.
   NOTE: Pull on the wheel assembly to ensure that it is securely attached to the stroller.

REAR WHEELS
Attach the rear axle assembly and wheels as follows:

• Position axle assembly over the rear leg tubes, brake pedals facing the back. At the same time, push down applying equal pressure to both sides until they lock into place (Fig. 2).

NOTE: NEVER use stroller if wheels do not lock into place. If you need assistance, please contact our customer service department at 1-800-328- 7363, M-F, between 8 am and 4:30 pm, PST.

To attach the child tray
Push the tray downward into the connectors (Fig. 3a). Check that the tray is securely latched in place.

To access the child seat
Push one release and lift up the tray simultaneously (Fig. 3b). Either side of the child tray will lift and rotate out of the way to allow access to the front seat.

To remove the child tray
Push to release both ends and lift up the tray simultaneously (Fig. 3c).

PARENT TRAY

WARNING: Do not place hot liquids or more than 3 pounds in the parent tray. Serious burns or unstable conditions could result.

• To attach parent tray, line up the parent tray slots with corresponding slots on the stroller frame and slide down until locked into place (Fig. 4).
  NOTE: Check to make sure the parent tray is secure before using.

MULTI-POSITION HANDLE

• To adjust the handle, press the buttons to move the handle up or down to a comfort position for the user (Fig. 5).

CANOPY

• To install the canopy, slide the male ends of the canopy into the female slots on the stroller frame (Fig. 6a).
• To open the canopy: push forward on the front edge of the canopy while holding the rear of the canopy in place (Fig. 6b).
• To fold the canopy: pull backwards on the front edge (Fig. 6b).

BASKET
Rear basket tube needs to be installed prior to use. Insert the female end of the rear basket tube into the male ends located on the basket frame until it locks into place (Fig. 7).

BRAKES

WARNING: Always set brakes when the stroller is not being pushed so that the stroller will not roll away. NEVER leave the stroller unattended on a hill or incline as the stroller may slide down the hill.

• To engage brakes, apply light downward pressure to the brake lever located on each rear wheel. The stroller may require slight forward or rearward movement to line up the teeth on the brake with each wheel brake cluster (Fig. 8).
  NOTE: Check that the stroller will not move and that both brakes are properly applied.

• To release, gently lift up on the brake lever (Fig. 8).

SAFETY SEGURIDAD

TO SECURE THE CHILD
WARNING: Avoid serious injury from falling or sliding out. Always use the safety harness.

• Snap the side of seat pad onto the inner sides of the frame (Fig. 9a). Repeat for the other side.
• The shoulder straps of the 5-point harness have 3 attachment positions. Select the position that places the shoulder strap level with, or below the top of the child’s shoulder. To adjust harness height unhook the shoulder strap from the crotch buckle (Fig. 9b).
• Feed the shoulder strap through the harness spread slots. You can access these slots from the rear of the seat underneath the fabric. Feed the shoulder strap through the appropriate slot and reattach the shoulder strap to the crotch buckle (Fig. 9c).
• Carefully place the child in the stroller seat and bring the safety harness around the child’s waist and over the shoulders. Place the crotch strap between the child’s legs. Insert the male end of each shoulder/waist belt into the buckle on the crotch strap. Tighten the harness to be snug around the child’s waist and over the child’s shoulders (Fig. 9d).
• Push the Button on the Center Clasp, and the two Harness Buckles will pop free (Fig. 10).

SEAT BACK POSITION

WARNING: The upright position should be used only for a child that is at least 6 months old.

• To recline the seat, press the side tabs on the adjuster and pull downward. To place the seat into the upright position, hold the strap hoop and push the adjuster upward (Fig. 11). The upright position should be used only for a child that is at least 6 months old. Always readjust the safety harness, including the shoulder belts, when repositioning the seatback.

INFANT CAR SEAT

THE INFANT CAR SEAT
WARNING: Avoid serious injury from falling or sliding out, always use the Infant Car Seat harness.

• ATTENTION: CS01 EZ-Lift, CS02 EZ-Lift PLUS and CS03 EZ-Lift PRO Infant Car Seats must attach to the module of the stroller front seat. These models require child tray and seat back adjustment to the most reclined position.
• NOTE: To make seat position adjustments refer to step 11.

CAR SEATS MODULE CONNECTION

• From the rear side of the stroller engage both car seat support tabs (Fig. 12a).
• Align the car seat module to the inner frame connectors. Carefully rest the car seats’ lower rear against the angle point of the tray. Latch the module into the stroller frame. Press down firmly for the click. ALWAYS ensure that the car seat is properly connected and locked onto the stroller before each use by lifting up on the car seat handle (Fig. 12b).
• NOTE: To make seat position adjustments refer to step 11.

REMOVING THE CAR SEAT

NOTE: Set handle to the carry position (Fig. 13a). Squeeze the release handle located at the Top-rear of the car seat and lift away from the stroller (Fig. 13b).

NOTE: To attach the head pillow and bottom inserts, refer to the CS01 instruction manual.

OTHER COMPATIBLE CAR SEATS OTROS

• Put the stroller seat in the full recline position, See (Fig. 11). Turn car seat support tabs on the stroller frame (Fig. 14a).Car Seat Support Tabs are Only used for the infant car seat. Check that the front child tray is firmly attached to the stroller armrests.
• Position the infant car seat so that it faces toward the rear of the stroller. Push the car seat into the front tray until it latches into place (Fig. 14b). The rear of the car seat rests on the support tabs. Put the stroller seat inthe most upright position for additional support (Fig. 11).
• When the infant car seat is locked firmly into place, secure the single short clip over the infant car seat through the belt path on the infant car seat (Fig. 14c). the short clip must be always tightly fastened around the infant car seat. Always secure your child with the car seat harness when using the car seat in the stroller. If your child is already in the car seat, check that the child is secured with the harness. Improper use of the stroller with the car seat may result in serious injury or death.

Removing the car seat from the child tray

• First use the carry handle buttons to rotate it to the carry position (Fig. 14d). Remove the short clip from the infant car seat (Fig. 14e).
• To remove the Infant Car Seat, squeeze the release handle located at the Top-rear of the seat and carefully lift upward on the seat (Fig. 14f). From the rear side of the stroller disengage both car seat support tabs (Fig. 14g).

FOLD / UNFOLD

TO FOLD STROLLER

WARNING: Care must be taken when folding and unfolding the stroller to prevent finger entrapment.

• To fold the stroller slide the thumb trigger to the left and squeeze the pull trigger while pushing forward on the handle (Fig. 15a).
• Once the stroller begins to fold, release the handle and push forward on the handle until the stroller is folded (Fig. 15b). Use the fold latch to secure the stroller (Fig. 15c).

TO UNFOLD STROLLER

CAUTION: Do not allow children near the stroller while unfolding.

• Release the fold latch (Fig. 16a) and unfold the stroller frame by pulling upward on the stroller handle until the frame locks (Fig. 16b).

MAINTENANCE

SEAT PAD

• To clean the seat pad, use only mild household soap or detergent and warm water on a sponge or clean cloth.

OTHER

• Check your stroller for loose screws, worn parts, torn material or stitching regularly. Replace or repair parts as needed.

FRONT-WHEEL – MAINTENANCE

• If replacing the front wheel, press the pin located behind the wheel hub. Pull the wheel out from the hub (Fig. 17).

REAR WHEEL – MAINTENANCE

• If replacing the rear axle, press the pin on each side behind the wheel hub. Pull the rear axle out from the hub.

BABY TREND® CUSTOMER SERVICE
The Customer Service Department can be contacted at 1 800-328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®.

• Copyright © 2024, Baby Trend Inc., All Rights Reserved.

References

• Limited Warranty Coverage – Baby Trend
• Baby Trend® | Car Seats, Strollers, High Chairs, Nursery and More!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>