AGPTEK Foaming Soap Dispenser User Manual

AGPTEK Foaming Soap Dispenser User Manual

Attention

1. Please place the unit on a flat level surface without water covering.
2. Please use the liquid soap which contains low concentration of alcohol.
3. Please turn off the unit first when you need to move it to prevent dispensing accidently.
4. Do Not flush the unit with the strong running water nor immerse the bottom of unit in the water, which may damage battery compartment.
5. Do Not expose the unit directly to the sun or strong light, which may interfere IR sensor system.
6. When the unit is not used for a long time, please empty the container, clean it with dry soft towel and remove the batteries, store it in a dry place.
7. Keep this manual in a safe place for future reference.

Features

1. Power Button/Indicator LIght
2. Spout
3. Infrared Sensor
4. Battery Compartment
5. Main Body
6. Soap Tank

Note on Mixing Liquid

Foam liquid soap can be poured directly into the soap tank to use. Non-foam type needs to be diluted with water (5-8 times of water, add or subtract according to concentration).

The Ratio of Soap Solution to Water

Soap Solution : Water = 1 : 5 1 : 8 (Normal Range)
Soap Solution : Water < 1 : 5 1 : 8 (Spout Foam Easily)
Soap Solution : Water > 1 : 5 1 : 8 (Spout Sparse Foam)

Operation

1. Open the soap tank by rotating it gently in the counter-clockwise direction.

2. Open the battery cover, insert 4 x AA alkaline batteries (Not Included) correctly. Please note that observe the polarities compartment before inserting batteries. Then close the battery cover.

3. Pour the desired amount of liquid into the soap tank with the attached funnel, then rotate the tank gently in the clockwise direction to fix it.

4. Power On: Press the power button once (indicator light flashes white once).

5. Now you can enjoy the ideal foam by placing your hand under the sensor (distance <6cm).

Indicator Light State

 |

Indicator Light

|

State

---|---|---
|

Flash white once

|

Turn on

|

Flash blue once

|

Turn Off

|

Steady blue

|

Low Battery

If Soap is not Dispensed

The liquid soap could become congealed in the spout or dispensing tube if not used for a long time or in a cold/dry climate. If that is the case, pour out any soap remaining in the tank, fill the tank with some warm water and then operate the dispenser several times until the water begins to be dispensed from the spout. Finally, pour out any remaining water and refill the tank with liquid soap.

Specifications

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>