Airmax Maintenance & Operation Control Panel Timer User Guide
- June 7, 2024
- Airmax
Table of Contents
Maintenance & Operation of the Control Panel Timer
RUN TIME USING THE MANUAL BYPASS
Press the MANUAL button until the line is above “ON”. This mode will bypass
all programmed settings.
RUN TIME USING A PROGRAM
Setting the Clock
Step 1: Press the RESET button to clear all history from memory.
Step 2: Press and hold the CLOCK button.
Step 3: Continue to hold the CLOCK button while pressing the DAY, HOUR or
MIN button to set the day and time.
Step 4: Release the CLOCK button.
CREATING A PROGRAM
The Airmax NEMA 3R Powder Coated Control Panel allows up to 8 ON/OFF run times.
Select the days for each run time to occur based on the 15 preset schedule of days listed below.
Note: Ponds will receive the most benefit from continual water movement. We recommend running fountains at least 8-10 hours daily, to maximize benefits, unless a secondary aeration system is in operation.
Step 1: Press the TIMER button once to display “1on –:–”
Step 2: Press the DAY button to scroll through the preset schedule
options.
Step 3: When the desired schedule is displayed press the HOUR or MIN
buttons to select the ON time.
Step 4: Press the TIMER button once to switch display to “1off –:–”
Step 5: Press the DAY button to scroll to the program selected in step 2.
Step 6: Press the HOUR or MIN button to select the OFF time.
Step 7: Repeat steps 1-6 for each additional program desired, up to 8
programs.
Step 8: When all programs have been created press the CLOCK button to
execute the programs.
Step 9: Press the MANUAL button until the line is above AUTO.
EDITING A PROGRAM
Review a Program - To review the list of current programs press the
TIMER button repeatedly to scroll through the programs. When finished press
the CLOCK button to return to the time of day.
Change an On/Off Time – To adjust an on off time press the TIMER button
to scroll to the program you will to change. Press the DAY, HOUR or MIN
buttons to adjust the time. When finished press the CLOCK button to return to
the time of day.
Add a Program - If there are not already 8 programs running you may
elect to add an additional program by following. See CREATING A PROGRAM
Remove a Program - In the event that a program needs to be removed you
will need to RESET the timer and program only the desired schedules.
| a. | MO | TU | WE | TH | FR | SA | SU |
|---|---|---|---|---|---|---|---|
| b. | MO | ||||||
| c. | TU | ||||||
| d. | WE | ||||||
| e. | TH | ||||||
| f. | FR | ||||||
| g. | SA | ||||||
| h. | SU | ||||||
| i. | MO | TU | WE | TH | FR | ||
| j. | SA | SU | |||||
| k. | MO | TU | WE | TH | FR | SA | |
| l. | MO | TU | WE | ||||
| m. | TH | FR | SA | ||||
| n. | MO | WE | FR | ||||
| o. | TU | TH | SA |
MAINTENANCE:
REPLACING THE BATTERY
Note: Timer settings will be retained for approximately 1 minute once the battery is removed. Each timer uses (1) CR2032 Lithium Battery.
Step 1: On the back of the timer use a small flathead screwdriver or
similar to pull the battery compartment from the timer.
Step 2: Install a new battery and reinstall the battery compartment.
airmaxeco.com | 866-424-7629 | P.O.Box 38 | Romeo, MI 48065
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>