AIRMAX Fountain Mooring Kit Instruction Manual
- June 4, 2024
- Airmax
Table of Contents
AIRMAX Fountain Mooring Kit
What’s Included:
-
2 Fountain Stakes
-
2 Carabiners
-
4 Cable Clamps
(2 are pre-installed on the 75’ & 125’ mooring lines) -
2 75’ or 125’ Mooring Lines*
-OR- -
1 500’ Mooring Line
(Depending on which kit you ordered)
Tools Required:
- 5/16” Wrench or Nut Driver
- Side Cutters
- Hammer
Installation Instructions
-
For round floats, thread one preassembled mooring loop through one of the mounting holes in the fountain float and secure with a carabiner. For Lake Series® fountains, clip the carabiner on the loop and seure the carabiner to the the upper D-ring on the fountain power unit.
For 500’ kits you
will need to first measure and cut the cable to create two lines. Follow steps
4-6 for creating a mooring loop. -
Place fountain in pond. With the help of a 2nd person, grab the mooring lines and walk to opposite sides of the pond to pull the fountain to desired location.
-
Using a hammer, install a fountain stake at one location angled slightly away from the pond.
-
Loop the mooring cable around the fountain stake leaving a loop only large enough to slide on and off the stake.
-
Use a 5/16” wrench or nut driver to secure the mooring line loop with a cable clamp.
-
Trim excess line with side cutters, leaving only a few inches of excess line.
-
Repeat steps 3-6 to secure the mooring line on the opposite side of the pond. Pull the line tight to ensure little to no movement of the fountain.
Airmax, Inc.
15425 Chet’s Way Street, Armada, MI 48005
866-424-7629
www.airmaxeco.com
contactus@airmaxeco.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>