ROCKVILLE Marine Led Speaker User Manual
- June 7, 2024
- RockVille
Table of Contents
RMC65L / RMC80L
MARINE LED SPEAKER USER’S MANUAL
RMC65L / RMC80L
MARINE LED SPEAKER USER’S MANUAL
LED CONTROLLER WIRING INSTRUCTIONS
Connect the male plug extending from one of the s
peakers to the female end of one of the cables extending from
the controller (a). Connect the male end of the included extension cord to the
female end of the other cable extending from the controller (b). Now connect
the female plug of the extension to the male plug extending from the other
speaker (c).
This LED controller module supports LED products that feature common anode connections. The black triangle with the plus sign inside indicates the common connection anode. The peak output current is 4 amps per channel. If the main unit is overheating, please reduce the load.
This unit accepts 5V to 24V power supply. Connect the red cable to the positive (+12V) terminal of your power supply or to an accessory line. Connect the black cable to the closest part of the vehicle chassis.
PLEASE NOTE
• Use 18 gauge or thicker wire for power and ground connections.
• Anode connection is common positive.
CAUTION!
Do not short circuit the led output. Doing so may cause permanent damage!
REMOTE CONTROL FEATURES
1. Turn On / Standby: Press this key to turn on LEDs or switch to
standby mode.
2 / 9. Dynamic Mode: Switch from dynamic mode to color mode or switch
between dynamic modes.
3 / 8. Dynamic Mode Speed: Use these buttons to adjust dynamic mode
speed. If the unit is in static mode, pressing these buttons will switch the
unit to dynamic mode.
4 / 5. Static Color Adjust: Use these buttons to switch between static
colors. Pressing these keys while in dynamic mode will switch the unit to
static mode.
6 / 7. Brightness Adjust: Pressing these buttons will adjust brightness
while in static mode. If these buttons are pressed while the unit is in
dynamic mode, it will switch to static mode.
10 . Demo Mode button: this button will switch the unit into demo mode.
While in demo mode, the unit will loop through 17 dynamic modes with each
repeating 3 times.
11. Direct Color Select button: press these buttons to select specific
static colors. You can also use the Static Color Adjust buttons to select
static colors.
- Please remember to remove the plastic insulator from remote unit battery compartment.
- This remote uses a 3 volt CR2025 type battery. Replace with the same type of battery.
- The remote signal can pass though most obstacles.
- Don’t install unit in areas surrounded by metal as the remote signal will not reach the unit.
Visit us at:
RockvilleAudio.com
Due to constant improvements, these specifications are subject to
change without notice.
Copyright 2020
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>