Barrette EZ GRIP Gate Handle Instructions
- June 7, 2024
- Barrette
Table of Contents
EZ GRIP
GATE HANDLE
Installation Instructions
Read all instructions prior to installing the product.
Refer to manufacturers’ safety instructions when operating any tools.
To register your product, please visit:
barretteoutdoorliving.com
WARNING:
- Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling, and assembling the product.
- Incorrect installation may cause harm to the gate or individual.
- Not pool code approved.
NOTICE:
- DO NOT attempt to assemble the kit if parts are missing or damaged.
- DO NOT return the product to the store, for assistance or replacement parts call: 1-800-336-2383.
TOOLS NEEDED:
| Pencil
---|---
| Phillips Driver Bit
| Drill
| 3/32″ Bit
Component list:
QTY | Description |
---|---|
1 | Gate Handle |
2 | Screw Caps |
2 | 2 1/2″ #2 Phillips Square Combo Self-Drilling Screws(Stainless Steel) |
To obtain and review a copy of the warranty please visit: barretteoutdoorliving.com. You may also contact us at 1-800-336 2383 or email Cs.outdoorliving@ebarrette.com
- Install Barrette Outdoor Living Gate Hinges before installing handle (Fig. 1).
- Once hinges are installed and gate is aligned, position handle at the desired height and pre-drill holes on the gate (Fig. 2).
- Align handle over pre-drilled holes and secure with two screws (Fig. 3).
- Align screw cap slot to raised groove in handle. Push to secure screw caps (Fig. 4).
Barrette Outdoor Living
545 Tilton Rd, Egg Harbor City, NJ. 08215
barretteoutdoorliving.com •
800-336-2383
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>