Barrette OUTDOOR LIVING 73050575 Puppy Picket Kit Instruction Manual

Barrette OUTDOOR LIVING 73050575 Puppy Picket Kit

WARNING

• Improper installation of this product can result in personal injury. Always wear safety goggles when assembling the product.
• Incorrect installation may cause harm to the product or individual.
• Check local building codes to determine pool-safe product options.

NOTICE

• DO NOT attempt to assemble the kit if parts are missing or damaged.
• DO NOT return the product to the store, for assistance or replacement parts call: 1-877-265-2220

BEFORE YOU BEGIN

• Check your local zoning laws.
• Local zoning laws and Home Owner’s Associations may regulate the location, style, and height of your product or even require a permit signoff beforehand.
• Contact your local utility companies.
• You must have the utility companies clearly mark your property for electrical, gas, or water lines to avoid puncturing any unseen underground utilities.

NOTE

This Puppy Picket Kit is designed to work with residential aluminum ornamental fence panels that are 6′ wide with 5/8″ square pickets.

TOOLS/MATERIALS NEEDED

SOLD SEPARATELY

Puppy Picket Kit Components

QTY. Description

1| Puppy Picket
4| Clips
4| 1″ Square Drive Screws

• To obtain and review a copy of the warranty please visit barretteoutdoorliving.com.
• You may also contact us at 1-877-265-2220 or email CS.outdoorliving@barretteoutdoorliving.com.

TIP

• Puppy Picket can be installed in multiple orientations for different looks.

Installing clips to Puppy Picket Panel

• Take 4 clips and install them between the first and second picket on the top and bottom rails for both sides of the panel (Fig. 1).
• To install the clip to the rail, push the clip down on top of the rail (Fig. 2).
• Once the clip is wrapped around the rail from the top (Fig. 3), rotate the clip 90 degrees until it snaps into position.
• See (Fig. 4) for the correct orientation based on what panel the puppy picket is being installed onto.

Installing Puppy Picket Panel to Existing Panel

• Align the Puppy Picket Panel to the desired location.
• Align clips to the appropriate pickets on the existing panel (Fig. 5).
• Push each clip against the existing panel’s picket to engage the clip.
• The clip should wrap around the picket for proper installation.
• Once clips are installed, the installation should look like Figure 5.

TIP

Attach all Puppy Picket Panels to your fence project before moving to the next step. This will allow you to make adjustments to your Puppy Picket Panel’s alignment before screwing the Puppy Picket Panel down.

Screwing Puppy Picket To Existing Panel

• Align one 1″ Square Drive Screw to the center of each clip (Fig. 6).
• Drive screw through the Puppy Picket, Clip, and existing fence panel (Fig. 7).

Barrette Outdoor Living 7830 Freeway Circle, Middleburg Heights, OH 44130barretteoutdoorliving.com • (877) 265-2220

References

• Barrette Outdoor Living: HomePage

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>