Barrette OUTDOOR LIVING 73050522 VersaRail 2.5-in Post Extension Instruction Manual
- June 4, 2024
- Barrette OUTDOOR LIVING
Table of Contents
WEB REV 10.21
POST EXTENSION FOR ALUMINUM RAIL
Installation Instructions
Read all instructions prior to installing the product.
Refer to manufacturers’ safety instructions when operating any tools.
To register your product, please visit:
barretteoutdoorliving.com
WARNING:
- Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling, and assembling the product.
- Post extension is designed for use with Barrette Outdoor Living® Standard duty Aluminum Railing posts.
- Not for load-bearing use.
NOTICE:
- DO NOT attempt to assemble the kit if parts are missing or damaged.
- DO NOT return the product to the store, for assistance or replacement parts call: 1-877-265-2220.
Component List:
| QTY | Description |
|---|---|
| 1 | 65″ post extension |
| 1 | Post Coupler |
| 2 | J Hooks |
| 10 | #10×1″ screws |
TOOLS/MATERIALS NEEDED:
Safety Goggles
Tape Measure
Power Screwdriver/drill
5⁄32″ drill bit
-
Determine the desired finished height of your post. The post extension is 65″ long. Cut the post extension to the desired height.
-
Remove the post cap from the installed post.
Attach the post cap to the end of the extension. -
Attach the “J” hooks at the top of the post extension near the post cap.
a. Mark the holes and pre-drill with a 5⁄32″ drill bit and secure with provided #10 x1″ long screws. (Fig 1). -
Insert the coupler into the bottom of the extension.
Tap with a rubber mallet until firmly seated. -
Using the pre-drilled holes as a guide secure the coupler to the extension by pre-drilling the 4 holes with a 5⁄32″ drill bit and secure with four #10 x 1″ screws (Fig 2).
-
a. Attach the post extension by firmly seating the coupler at the top of the installed post. Make sure the “J” hooks that were installed earlier are in the correct orientation. Tap top of extension with a rubber mallet to firmly seat.
b. Using the pre-drilled holes as a guide, secure the coupler to the extension by predrilling the 4 holes with a 5⁄32″ drill bit and secure with four #10 x 1″ screws (Fig 3).
To obtain and review a copy of the warranty please visit barretteoutdoorliving.com. You may also contact us at 1-877-265-2220 or email CS.outdoorliving@barretteoutdoorliving.com.
Barrette Outdoor Living
7830 Freeway Circle, Middleburg Heights, OH 44130
barretteoutdoorliving.com •
877-265-2220
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>