BUFFALO Griddle Instruction Manual
- June 7, 2024
- BUFFALO
Table of Contents
BUFFALO Griddle Instruction Manual
Safety Tips
- Position on a flat, stable surface.
- A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
- Consult Local and National Standards to comply with the following:
- Health and Safety at Work Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
- DO NOT immerse the appliance in water.
- Some surfaces become hot during operation – take care when using the appliance.
- Always switch off and disconnect the power supply to the appliance when not in use.
- Not suitable for outdoor use.
- This appliance must only be used in accordance with these instructions and by persons competent to do so.
- This appliance is not suitable for use by children.
- Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
- If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified technician in order to avoid a hazard.
Product Description
- P108 – Counter Top Electric Griddle (Cast Iron plate. Cooking Area: 385mm x 280mm)
- P109 – Counter Top Electric Griddle (Cast Iron plate. Cooking Area: 380mm x 385mm)
- L515 – Counter Top Electric Griddle (Stainless Steel plate. Cooking Area: 500mm x 310mm)
- G791 – Counter Top Electric Griddle (Stainless Steel plate. Cooking Area: 735mm x 330mm)
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your BUFFALO product.
Pack Contents
The following is included:
- BUFFALO Griddle
- Waste Tray
- Instruction Manual
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
Operation
Model featured: P108
Seasoning the Griddle Plate
Before using for the first time the cooking surface needs to seasoned.
- Ensure the cooking surface is clean.
- Brush the surface with cooking oil.
- Set the thermostat to 110°C and turn the appliance On. The power indicator light turns on.
- Once the appliance reaches temperature the power indicator light turns off.
- Turn the appliance Off and allow to cool before wiping away any excess oil.
- The appliance is now ready to use.
Cooking
-
Connect the appliance to the mains power supply.
-
Set the thermostat to the desired temperature (60°C-300°C). The power indicator light comes on and the appliance begins to heat up.
Note: 200°C to 220°C is suitable for general cooking. -
The power indicator light turns off when the appliance has reached the set temperature.
Note: BUFFALO recommend the cooking surface is lightly oiled before cooking. -
Place the foodstuffs on the griddle plate and cook as required.
Cleaning, Care & Maintenance
If grease is permitted to accumulate, it will begin to carbonised into a hard substance that is extremely difficult to remove. To prevent this follow the cleaning steps below:
- Always turn Off the appliance and disconnect from the power supply before cleaning.
- Allow the appliance to cool before cleaning.
- Use warm, soapy water and a damp cloth to clean the exterior of the appliance.
- Take care when using scrapers to remove cooking residues as they can damage the cooking surface.
- Dry thoroughly after cleaning.
- A BUFFALO dealer or qualified technician should carry out repairs if required.
Scraping
After each use, scrape the appliance with a scraper/grill stone/copper brush or flexible spatula to remove excess fat and food. A waste tray is provided for the scrapings if necessary.
If there is an accumulation of burned fat or food, the cooking surface should be thoroughly scoured and re-seasoned. .
NOTE: IT IS VITAL THAT THE COOKING SURFACE IS RE-SEASONED AFTER SCOURING.
WARNING: DO NOT USE STEEL WOOL AS IT MAY LEAVE SHARDS THAT COULD CONTAMINATE FOOD.
Waste Tray
These appliances feature a waste tray to collect any liquid or fats that run off during cooking.
At least once a day, remove and empty the waste tray before washing with warm soapy water. Do not allow the tray to overfill or excess grease will run out of the overflow hole at the front of the tray.
WARNING: DO NOT remove the tray during or immeadiately after use as the contents will be hot.
Note: The waste tray for the L515/G791 slots inside the appliance.
Troubleshooting
If your BUFFALO appliance develops a fault, please check the following table before making a call to the Helpline.
Fault | Probable Cause | Action |
---|---|---|
The appliance is not working | The appliance is not switched on | Check the |
appliance is plugged in correctly and switched on
Plug and lead are damaged| Call BUFFALO agent or qualified technician
Fuse in the plug has blown| Replace the plug fuse
Power supply| Check power supply
Internal wiring fault| Call BUFFALO agent or qualified technician
Appliance does not reach set temperature| Faulty thermostat| Call BUFFALO
agent or qualified technician
Faulty element| Call BUFFALO agent or qualified technician
Appliance heats up but indicator light does not come on| Bulb has expired|
Call BUFFALO agent or qualified technician
Power indicator light comes on but appliance does not heat up| Faulty element|
Call BUFFALO agent or qualified technician
Faulty thermostat| Call BUFFALO agent or qualified technician
Thermostat set incorrectly| Check thermostat
Appliance slow to heat up| Cooking surface not clean| Clean cooking surface
Faulty element| Call BUFFALO agent or qualified technician
Surface flaking| Build up of carbonised food debris| Refer to Cleaning, Care
and Maintainence section
No power| Thermal cut-out switch has activated (P108/P109/L515)| Press re-set
switch on rear of unit (P108/P109/L515)
Technical Specifications
Model
| Voltage| Power| Current| Cooking Surface Dimensions w x d (mm)| Dimensions h x w x d (mm)|
Weight (kg)
---|---|---|---|---|---|---
P108
| 230V 50Hz| 1800W| 8A| 385 x 280| 228 x 440 x 365| 19.5
P109| 230V 50Hz| 2800W| 12.2A| 380 x 385| 228 x 440 x 465|
23
L515
| 230V 50Hz| 2200W| 9.6A| 500 x 310| 200 x 525 x 460| 24.5
G791| 230V 50Hz| 2900W| 12.6A| 735 x 330| 200 x 745 x 460|
34.2
Electrical Wiring
This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
- Live wire (coloured brown) to terminal marked L
- Neutral wire (coloured blue) to terminal marked N
- Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with
regulatory standards and specifications set by international, independent, and
federal authorities.
BUFFALO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to change specifications without notice.
DECLARATION OF CONFORMITY
Equipment Type|
- Counter Top Electric Griddle – 385x280mm
- Counter Top Electric Griddle – 380x385mm
- Electric Griddle Electric
Griddle – 2900 watt 230V
---|---
Model|
- P108
- P109
- L515
- G791
Application of Council Directives(s)|
- Low Voltage Directive (LVD) 2014/35/EC
- EN 60335-1:2012 +A11:2014
- EN 60335-2-38: 2002 +A1:2008
- EN 62233:2008
- Electro-Magnetic Compatibility (EMC) Directive 2014/30/EU EN 55014-1:2006 +A1:2009
- EN 55014-2:2015
- EN 61000-3-2:2014
- EN 61000-3-3:2013
- Restriction of Hazardous Substances Directive (RoHS) 2015/863 amending Annex II to Directive 2011/65/EU
Producer Name| Buffalo| Buffalo
Producer Address| Fourth Way,
Avonmouth,
Bristol,
BS11 8TB
United Kingdom| 42 North Point
Business Park
New Mallow Road
Cork Ireland
the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and Standard(s).
Date | 27 th March 2019 |
---|---|
Signature | ![Signature](https://manuals.plus/wp- |
content/uploads/2021/08/6-553-300x184.jpg)
Full Name| Ashley Hooper
Position| Technical & Quality Manager
Technical Support
UK|
0845 146 2887
---|---
NL
|
0800-29129
040 – 2628080
FR
| 0800- 29 2 29
0160 34 28 80
DE
|
0800 – 1860806
IT
|
N/A
ES
|
901-100133
PT
|
http://www.buffalo-appliances.com/