ULINE 1-1 Gallon F-Style Can Shipper User Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE 1-1 Gallon F-Style Can Shipper User Guide
COMPONENTS
1 Corrugated Carton
1 – 1 Gallon F-Style Metal Can
1 Screw Cap Closure and Inner Seal 1 – 1 Mil Poly Bag
1 – 5.5″ 40# Cable Tie
2″ Wide (2.6 mil) Polypropylene Tape (Uline Model # S-14564) Sold Separately
ASSEMBLY INSTRUCTIONS
-
Fold flaps on bottom of carton so that they meet. Manufacturer’s certification must be visible on the outside of the carton
Figure 1 -
Seal bottom of carton down the center seam with one strip of 2″ wide (2.6 mil) polypropylene tape (Uline Model # S-14564). The tape must extend at least 3″ over each end of the (See Figure 1)
-
Fill can. Do not overfill
Figure 2
-
Place inner seal inside opening and tap it down using a rubber mallet until it is securely in place. Seal can by threading cap onto opening with 17-26 in-lbs of (See Figure 2)
Figure 3 -
Place can into carton − bottom (See Figure 3)
NOTE: If shipping by air, can must be placed into the included 1 mil poly bag. Poly bag must be sealed with the included 5.5″ 40# cable tie.
ASSEMBLY INSTRUCTIONS CONTINUED
-
Fold flaps on top of carton so that they meet. “THIS SIDE UP” must be visible on the outside of the carton
Figure 4 -
Seal top of carton down the center seam with one strip of 2″ wide (2.6 mil) polypropylene tape (Uline Model # S-14564). The tape must extend at least 3″ over each end of the (See Figure 4)